Yafei Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yafei Wang has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
You Li
Asia-Japan Research Institute, Ritsumeikan University, Osaka, Japan
4 shared publications- Hiroatsu Fukuda
Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu 808-0135, Japan
3 shared publications - Weijun Gao
Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu, Japan
3 shared publications - Hiroatsu Fukuda
Department of Architecture, University of Kitakyushu, Kitakyushu 802-8577, Japan
2 shared publications Weijun Gao
Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu, 808-0135, Japan
2 shared publicationsWeisheng Zhou
College of Policy Science, Ritsumeikan University, Osaka, Japan
2 shared publications
Latest Publications
- Open Access
Thermal Performance Optimization of Trombe Walls: A Comprehensive Experimental Study in Cold Regions
In cold regions with prolonged subzero temperatures and abundant solar radiation, Trombe walls serve as high-efficiency passive solar building envelopes for improving indoor thermal comfort. This study aims to optimize the thermal performance of Trombe walls via a multimodal data analysis framework and a multiview measurement algorithm. Three distinct Trombe wall configurations were constructed and continuously monitored for 60 consecutive days under typical winter conditions (average temperature: −15 °C; solar radiation intensity: 800–1100 W/m2). Field-measured datasets, including solar radiation intensity, hourly air temperature distribution, and heat exchange efficiency, were systematically analyzed to quantify the impacts of ventilation mode, air gap width, and insulation thickness on thermal performance. The results demonstrate that the hourly peak surface temperature of the optimized Trombe wall reaches 25.7 °C at 13:00, which significantly improves indoor thermal comfort compared with conventional buildings. An air gap width of 6 cm minimizes indoor temperature fluctuations (fluctuation coefficient = 0.08), while a 20 mm insulation layer stabilizes heat loss reduction at 31.1% relative to non-insulated walls. The optimal operational parameter combination (6 cm air gap, 16 °C indoor set temperature) was determined based on the lowest temperature fluctuation and highest thermal efficiency, with experimental results deviating by less than 5% from established analytical models. This study verifies the reliability of the multimodal data analysis framework for Trombe wall performance evaluation, providing practical design guidelines for passive solar building envelopes in cold regions.
Open AccessThermal Performance Optimization of Trombe Walls: A Comprehensive Experimental Study in Cold Regions
In cold regions with prolonged subzero temperatures and abundant solar radiation, Trombe walls serve as high-efficiency passive solar building envelopes for improving indoor thermal comfort. This study aims to optimize the thermal performance of Trombe walls via a multimodal data analysis framework and a multiview measurement algorithm. Three distinct Trombe wall configurations were constructed and continuously monitored for 60 consecutive days under typical winter conditions (average temperature: −15 °C; solar radiation intensity: 800–1100 W/m2). Field-measured datasets, including solar radiation intensity, hourly air temperature distribution, and heat exchange efficiency, were systematically analyzed to quantify the impacts of ventilation mode, air gap width, and insulation thickness on thermal performance. The results demonstrate that the hourly peak surface temperature of the optimized Trombe wall reaches 25.7 °C at 13:00, which significantly improves indoor thermal comfort compared with conventional buildings. An air gap width of 6 cm minimizes indoor temperature fluctuations (fluctuation coefficient = 0.08), while a 20 mm insulation layer stabilizes heat loss reduction at 31.1% relative to non-insulated walls. The optimal operational parameter combination (6 cm air gap, 16 °C indoor set temperature) was determined based on the lowest temperature fluctuation and highest thermal efficiency, with experimental results deviating by less than 5% from established analytical models. This study verifies the reliability of the multimodal data analysis framework for Trombe wall performance evaluation, providing practical design guidelines for passive solar building envelopes in cold regions.
- Open Access
- 29 December 2025
- Published by MDPI AG in Preprints.org
Thermal Performance Evaluation of Trombe Wall Systems Using Multimodal Data Analysis
National economic growth drives rapid infrastructure development, with civil engineering technology shifting from manual to AI and computer-based approaches due to the mature development of the Internet. Against this backdrop, this study applies computer technologies—specifically multimodal data—to enhance project rigor and safety. Taking an intelligent Trombe wall in a specific temperature area as a case study, we use multimodal data analysis and a multi-view algorithm to establish a systematic analysis process. Experimental results show that the four temperature measurement points of the Trombe wall reach maximum temperatures of 25.7°C (point 1), 24.7°C (point 2), and 25.1°C (points 3 and 4). These findings indicate that multimodal data analysis can effectively improve the quality of civil construction.
- 29 December 2025
- Published by MDPI AG in Preprints.org
Open AccessThermal Performance Evaluation of Trombe Wall Systems Using Multimodal Data Analysis
National economic growth drives rapid infrastructure development, with civil engineering technology shifting from manual to AI and computer-based approaches due to the mature development of the Internet. Against this backdrop, this study applies computer technologies—specifically multimodal data—to enhance project rigor and safety. Taking an intelligent Trombe wall in a specific temperature area as a case study, we use multimodal data analysis and a multi-view algorithm to establish a systematic analysis process. Experimental results show that the four temperature measurement points of the Trombe wall reach maximum temperatures of 25.7°C (point 1), 24.7°C (point 2), and 25.1°C (points 3 and 4). These findings indicate that multimodal data analysis can effectively improve the quality of civil construction.
- Open Access
- 3 June 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-13
Dimensionless comparison of solar radiation time series data to address seasonality
The intermittency of solar power presents significant challenges for grid and energy systems, primarily owing to the unstable and chaotic characteristics of solar radiation time series caused by the combination of seasonality and stochasticity. Currently, there is a lack of simple and easily interpretable methods for describing or transforming solar radiation time series that can directly benefit various solar energy applications. In this study, a deseasonalization method for solar radiation time series based on a transformation matrix is introduced. This method is based on the assumption that daily solar radiation patterns can be scaled by day length and radiation intensity and involves transforming daily solar radiation patterns to eliminate differences due to seasonal effects and geographical location. The proposed method is developed and validated using long-term hourly data collected from five observation stations in Japan: Abashiri, Sapporo, Tokyo, Hiroshima, and Fukuoka, spanning the year from 2000 to 2022. The results indicate that the deseasonalized solar radiation time series exhibits three characteristics: (1) improved correlation in time series, (2) comparable radiation patterns, and (3) seasonal scalability. This study provides a foundational approach to simplifying the solar radiation time series, offering potential for broader applications in solar energy forecasting.
- 3 June 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-13
Open AccessDimensionless comparison of solar radiation time series data to address seasonality
The intermittency of solar power presents significant challenges for grid and energy systems, primarily owing to the unstable and chaotic characteristics of solar radiation time series caused by the combination of seasonality and stochasticity. Currently, there is a lack of simple and easily interpretable methods for describing or transforming solar radiation time series that can directly benefit various solar energy applications. In this study, a deseasonalization method for solar radiation time series based on a transformation matrix is introduced. This method is based on the assumption that daily solar radiation patterns can be scaled by day length and radiation intensity and involves transforming daily solar radiation patterns to eliminate differences due to seasonal effects and geographical location. The proposed method is developed and validated using long-term hourly data collected from five observation stations in Japan: Abashiri, Sapporo, Tokyo, Hiroshima, and Fukuoka, spanning the year from 2000 to 2022. The results indicate that the deseasonalized solar radiation time series exhibits three characteristics: (1) improved correlation in time series, (2) comparable radiation patterns, and (3) seasonal scalability. This study provides a foundational approach to simplifying the solar radiation time series, offering potential for broader applications in solar energy forecasting.
- 29 September 2024
- Published by Springer Nature
- p. 152-157
Load Leveling Potential Evaluation of Virtual Power Plant Based on Genetic Algorithm Optimization
- 29 September 2024
- Published by Springer Nature
- p. 152-157
Load Leveling Potential Evaluation of Virtual Power Plant Based on Genetic Algorithm Optimization
- 30 April 2023
- Published by Elsevier in Energy Conversion and Management
- Vol. 286, 116719
Graphical decomposition model to estimate hourly global solar radiation considering weather stochasticity
- 30 April 2023
- Published by Elsevier in Energy Conversion and Management
- Vol. 286, 116719
Graphical decomposition model to estimate hourly global solar radiation considering weather stochasticity
- Open Access
Comparison of Willingness to Pay for Quality Air and Renewable Energy Considering Urban Living Experience
Currently, quality air and renewable energy are main concerns in protecting the environment. Comparing willingness to pay for quality air and renewable energy is rare in the existing literature. However, the public faces these issues simultaneously. In addition, population mobility under China’s household registration system, i.e., urban living experience, may affect the willingness to pay for environmental protection. Consequently, the difference between people’s willingness to pay for quality air and renewable energy in China is discussed. Binary logistic regression is adopted to analyze the correlation factors based on data from the China General Social Survey. The results show that willingness to pay is influenced by environmental attitudes, awareness of energy use, government responsibilities, age, household income level, and trust. The effects of urban living experience on willingness to pay weakens as age decreases. Thus, improving environmental awareness and specialized knowledge remain important means of promoting willingness to pay. Our findings can help marketers and policy designers develop balanced or targeted measures when taking joint actions.
Open AccessComparison of Willingness to Pay for Quality Air and Renewable Energy Considering Urban Living Experience
Currently, quality air and renewable energy are main concerns in protecting the environment. Comparing willingness to pay for quality air and renewable energy is rare in the existing literature. However, the public faces these issues simultaneously. In addition, population mobility under China’s household registration system, i.e., urban living experience, may affect the willingness to pay for environmental protection. Consequently, the difference between people’s willingness to pay for quality air and renewable energy in China is discussed. Binary logistic regression is adopted to analyze the correlation factors based on data from the China General Social Survey. The results show that willingness to pay is influenced by environmental attitudes, awareness of energy use, government responsibilities, age, household income level, and trust. The effects of urban living experience on willingness to pay weakens as age decreases. Thus, improving environmental awareness and specialized knowledge remain important means of promoting willingness to pay. Our findings can help marketers and policy designers develop balanced or targeted measures when taking joint actions.
- Open Access
- 12 July 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Analysis of Energy Sharing Impacts in a Commercial Community: A Case of Battery Energy Storage System Deployment for Load Leveling
Energy use differences between day and night have been a key point in the efficient use of utilities. The battery energy storage system (BESS) is an attractive solution to level the grid load and has been introduced independently into many communities, although with high costs. Battery sharing presents the possibility of integrating independent energy storage systems to save money and improve energy use. Battery sharing highlights the interactions between a smart grid, smart buildings, and distributed energy storage to produce better energy management practices. In this work, we provide an analysis of battery sharing by establishing a coordinated control model for a distributed battery system. In our case study design, we selected 39 buildings with different capacities of energy storage systems as a battery-sharing community to optimize sharing schedules and the load-leveling performance. The results indicate that battery sharing could achieve a 13.2% reduction in building battery capacity compared with independent operation. We further investigate the impact of a building’s load profile patterns on the battery capacity in a battery-sharing community. It is economical to introduce a larger capacity battery system into buildings with no closing days and higher electricity consumption throughout the year. The optimal BESS capacity in commercial buildings depends on the lowest daytime power consumption. Commercial buildings with closing days have limitations regarding BESS deployment. On closing days, buildings can only use BESS by sharing. Buildings with two closing days a week lose 14.3% more energy than those with one closing day.
- 12 July 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Open AccessAnalysis of Energy Sharing Impacts in a Commercial Community: A Case of Battery Energy Storage System Deployment for Load Leveling
Energy use differences between day and night have been a key point in the efficient use of utilities. The battery energy storage system (BESS) is an attractive solution to level the grid load and has been introduced independently into many communities, although with high costs. Battery sharing presents the possibility of integrating independent energy storage systems to save money and improve energy use. Battery sharing highlights the interactions between a smart grid, smart buildings, and distributed energy storage to produce better energy management practices. In this work, we provide an analysis of battery sharing by establishing a coordinated control model for a distributed battery system. In our case study design, we selected 39 buildings with different capacities of energy storage systems as a battery-sharing community to optimize sharing schedules and the load-leveling performance. The results indicate that battery sharing could achieve a 13.2% reduction in building battery capacity compared with independent operation. We further investigate the impact of a building’s load profile patterns on the battery capacity in a battery-sharing community. It is economical to introduce a larger capacity battery system into buildings with no closing days and higher electricity consumption throughout the year. The optimal BESS capacity in commercial buildings depends on the lowest daytime power consumption. Commercial buildings with closing days have limitations regarding BESS deployment. On closing days, buildings can only use BESS by sharing. Buildings with two closing days a week lose 14.3% more energy than those with one closing day.
- 12 May 2019
- Published by Springer Nature
- p. 451-459
Design of Library Reader Deployment and Management System Based on RFID Technology
- 12 May 2019
- Published by Springer Nature
- p. 451-459
Design of Library Reader Deployment and Management System Based on RFID Technology