Anton Murros
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Anton Murros has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Miika Soikkeli
VTT Technical Research Centre of Finland Ltd , P.O. Box 1000
4 shared publications - Andrey Generalov
VTT Technical Research Center of Finland Ltd. 2 , P.O. Box 1000, FI-02044 VTT, Finland
3 shared publications - Sanna Arpiainen
VTT Technical Research Center of Finland Ltd. 2 , P.O. Box 1000, FI-02044 VTT, Finland
3 shared publications Anamul Md Hoque
Department of Microtechnology and Nanoscience, Chalmers University of Technology 1 , SE-41296 Gothenburg, Sweden
2 shared publications- Andrei Vorobiev
Department of Microtechnology and Nanoscience, Chalmers University of Technology, Gothenburg, Sweden
2 shared publications Arantxa Maestre
Graphenea S.A. , Paseo Mikeletegi 83
2 shared publications
Latest Publications
- Open Access
- 9 September 2026
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 20 (37) , 25275-25289
Graphene Field-Effect Transistor Process and Analysis Optimization in 200 mm Pilot-Line Environment
The maturity of the chemical vapor deposition graphene-based device processing has increased from chip-level demonstrations to wafer-scale fabrication in the past few years. Due to this, wafer-scale electrical characterization and analysis of the fabricated devices have become increasingly important to enable extraction of multiple parameters with a minimal number of measurements for the quality-control purposes critical for industrial uptake of 2D material-based devices. As a crucial step, we demonstrate optimization of complementary metal-oxide semiconductor (CMOS) back-end-of-line (BEOL)-compatible graphene field-effect transistor (GFET) fabrication and analysis, including the gate stack, bottom contact, graphene patterning, and encapsulation process steps. The analysis methods include atomic force microscopy, scanning electron microscopy, and, most importantly, electrical characterization. The electrical characterization focuses on comparing different test structures and extraction methods for mobility, contact resistance, transfer curve hysteresis, and doping parameters. The comparison shows that the selected measurement test structures and analysis methods can have a large impact on the extracted values and should thus be considered when comparing data sets from different sources. The analysis shows that the optimized process offers a high device yield of 97% with good doping uniformity, contact resistance, and mobility as well as low transfer-curve hysteresis values on 200 mm wafers.
- 9 September 2026
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 20 (37) , 25275-25289
Open AccessGraphene Field-Effect Transistor Process and Analysis Optimization in 200 mm Pilot-Line Environment
The maturity of the chemical vapor deposition graphene-based device processing has increased from chip-level demonstrations to wafer-scale fabrication in the past few years. Due to this, wafer-scale electrical characterization and analysis of the fabricated devices have become increasingly important to enable extraction of multiple parameters with a minimal number of measurements for the quality-control purposes critical for industrial uptake of 2D material-based devices. As a crucial step, we demonstrate optimization of complementary metal-oxide semiconductor (CMOS) back-end-of-line (BEOL)-compatible graphene field-effect transistor (GFET) fabrication and analysis, including the gate stack, bottom contact, graphene patterning, and encapsulation process steps. The analysis methods include atomic force microscopy, scanning electron microscopy, and, most importantly, electrical characterization. The electrical characterization focuses on comparing different test structures and extraction methods for mobility, contact resistance, transfer curve hysteresis, and doping parameters. The comparison shows that the selected measurement test structures and analysis methods can have a large impact on the extracted values and should thus be considered when comparing data sets from different sources. The analysis shows that the optimized process offers a high device yield of 97% with good doping uniformity, contact resistance, and mobility as well as low transfer-curve hysteresis values on 200 mm wafers.
- Open Access
- 22 January 2025
- Published by Elsevier in Infrared Physics & Technology
- Vol. 145
Infrared bolometers based on 40-nm-Thick Nano-Thermoelectric silicon membranes
- 22 January 2025
- Published by Elsevier in Infrared Physics & Technology
- Vol. 145
Open AccessInfrared bolometers based on 40-nm-Thick Nano-Thermoelectric silicon membranes
- Top Cited PapersOpen Access
- 27 March 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (4) , 2197-2212
Terahertz Detection with Graphene FETs: Photothermoelectric and Resistive Self-Mixing Contributions to the Detector Response
- 27 March 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (4) , 2197-2212
Top Cited PapersOpen AccessTerahertz Detection with Graphene FETs: Photothermoelectric and Resistive Self-Mixing Contributions to the Detector Response
- Open Access
- 24 August 2023
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 5 (9) , 4925-4932
Wafer-Scale Graphene Field-Effect Transistor Biosensor Arrays with Monolithic CMOS Readout
The reliability of analysis is becoming increasingly important as point-of-care diagnostics are transitioning from single-analyte detection toward multiplexed multianalyte detection. Multianalyte detection benefits greatly from complementary metal-oxide semiconductor (CMOS) integrated sensing solutions, offering miniaturized multiplexed sensing arrays with integrated readout electronics and extremely large sensor counts. The development of CMOS back end of line integration compatible graphene field-effect transistor (GFET)-based biosensing has been rapid during the past few years, in terms of both the fabrication scale-up and functionalization toward biorecognition from real sample matrices. The next steps in industrialization relate to improving reliability and require increased statistics. Regarding functionalization toward truly quantitative sensors, on-chip bioassays with improved statistics require sensor arrays with reduced variability in functionalization. Such multiplexed bioassays, whether based on graphene or on other sensitive nanomaterials, are among the most promising technologies for label-free electrical biosensing. As an important step toward that, we report wafer-scale fabrication of CMOS-integrated GFET arrays with high yield and uniformity, designed especially for biosensing applications. We demonstrate the operation of the sensing platform array with 512 GFETs in simultaneous detection for the sodium chloride concentration series. This platform offers a truly statistical approach on GFET-based biosensing and further to quantitative and multianalyte sensing. The reported techniques can also be applied to other fields relying on functionalized GFETs, such as gas or chemical sensing or infrared imaging.
- 24 August 2023
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 5 (9) , 4925-4932
Open AccessWafer-Scale Graphene Field-Effect Transistor Biosensor Arrays with Monolithic CMOS Readout
The reliability of analysis is becoming increasingly important as point-of-care diagnostics are transitioning from single-analyte detection toward multiplexed multianalyte detection. Multianalyte detection benefits greatly from complementary metal-oxide semiconductor (CMOS) integrated sensing solutions, offering miniaturized multiplexed sensing arrays with integrated readout electronics and extremely large sensor counts. The development of CMOS back end of line integration compatible graphene field-effect transistor (GFET)-based biosensing has been rapid during the past few years, in terms of both the fabrication scale-up and functionalization toward biorecognition from real sample matrices. The next steps in industrialization relate to improving reliability and require increased statistics. Regarding functionalization toward truly quantitative sensors, on-chip bioassays with improved statistics require sensor arrays with reduced variability in functionalization. Such multiplexed bioassays, whether based on graphene or on other sensitive nanomaterials, are among the most promising technologies for label-free electrical biosensing. As an important step toward that, we report wafer-scale fabrication of CMOS-integrated GFET arrays with high yield and uniformity, designed especially for biosensing applications. We demonstrate the operation of the sensing platform array with 512 GFETs in simultaneous detection for the sodium chloride concentration series. This platform offers a truly statistical approach on GFET-based biosensing and further to quantitative and multianalyte sensing. The reported techniques can also be applied to other fields relying on functionalized GFETs, such as gas or chemical sensing or infrared imaging.
- 12 September 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (11) , 119901
Publisher's Note: “Geometrical magnetoresistance effect and mobility in graphene field-effect transistors” [Appl. Phys. Lett. 121, 013502 (2022)]
- 12 September 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (11) , 119901
Publisher's Note: “Geometrical magnetoresistance effect and mobility in graphene field-effect transistors” [Appl. Phys. Lett. 121, 013502 (2022)]
- Open Access
- 4 July 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (1) , 013502
Geometrical magnetoresistance effect and mobility in graphene field-effect transistors
Further development of graphene field-effect transistors (GFETs) for high-frequency electronics requires accurate evaluation and study of the mobility of charge carriers in a specific device. Here, we demonstrate that the mobility in the GFETs can be directly characterized and studied using the geometrical magnetoresistance (gMR) effect. The method is free from limitations of other approaches since it does not require an assumption of the constant mobility and the knowledge of the gate capacitance. Studies of a few sets of GFETs in the wide range of transverse magnetic fields indicate that the gMR effect dominates up to approximately 0.55 T. In higher fields, the physical magnetoresistance effect starts to contribute. The advantages of the gMR approach allowed us to interpret the measured dependencies of mobility on the gate voltage, i.e., carrier concentration, and identify the corresponding scattering mechanisms. In particular, the range of the fairly constant mobility is associated with the dominating Coulomb scattering. The decrease in mobility at higher carrier concentrations is associated with the contribution of the phonon scattering. Analysis shows that the gMR mobility is typically 2–3 times higher than that found via the commonly used drain resistance model. The latter underestimates the mobility since it does not take the interfacial capacitance into account.
- 4 July 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (1) , 013502
Open AccessGeometrical magnetoresistance effect and mobility in graphene field-effect transistors
Further development of graphene field-effect transistors (GFETs) for high-frequency electronics requires accurate evaluation and study of the mobility of charge carriers in a specific device. Here, we demonstrate that the mobility in the GFETs can be directly characterized and studied using the geometrical magnetoresistance (gMR) effect. The method is free from limitations of other approaches since it does not require an assumption of the constant mobility and the knowledge of the gate capacitance. Studies of a few sets of GFETs in the wide range of transverse magnetic fields indicate that the gMR effect dominates up to approximately 0.55 T. In higher fields, the physical magnetoresistance effect starts to contribute. The advantages of the gMR approach allowed us to interpret the measured dependencies of mobility on the gate voltage, i.e., carrier concentration, and identify the corresponding scattering mechanisms. In particular, the range of the fairly constant mobility is associated with the dominating Coulomb scattering. The decrease in mobility at higher carrier concentrations is associated with the contribution of the phonon scattering. Analysis shows that the gMR mobility is typically 2–3 times higher than that found via the commonly used drain resistance model. The latter underestimates the mobility since it does not take the interfacial capacitance into account.