Takenori Iwaya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Takenori Iwaya has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Shuhei Ichikawa
Graduate School of Engineering, The University of Osaka 1 , 2-1 Yamadaoka, Suita, Osaka 565-0871
5 shared publications - Jun Tatebayashi
Graduate School of Engineering, The University of Osaka 1 , 2-1 Yamadaoka, Suita, Osaka 565-0871
4 shared publications Y. Fujiwara
Graduate School of Engineering, The University of Osaka 1 , 2-1 Yamadaoka, Suita, Osaka 565-0871
3 shared publications- Dolf Timmerman
Graduate School of Engineering, Osaka University 1 , Osaka 565-0871, Japan
2 shared publications - S. Yamazaki
Graduate School of Engineering, The University of Osaka 1 , 2-1 Yamadaoka, Suita, Osaka 565-0871
2 shared publications - Brandon Mitchell
Department of Physics, Lehigh University 2 , Bethlehem, Pennsylvania 18015
1 shared publication
Latest Publications
- 29 June 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (26)
Ultra-stable multiple emission wavelengths produced by Tb-doped Al x Ga1− x N-based light-emitting diodes
Tb-doped semiconductors are candidates for novel full-color light sources in next-generation high-definition displays. Particularly, Tb-doped AlxGa1−xN (AlxGa1−xN:Tb) has attracted much attention because Tb3+ ions doped into AlxGa1−xN show ultra-stable multi-color emissions consisting of blue, green, yellow, and red. Herein, we demonstrate room-temperature operation of AlxGa1−xN:Tb light-emitting diodes (LEDs) under current injections and characterize the optical/electrical properties. Ultra-stable Tb3+ emissions with narrow linewidths are clearly observed, and it is revealed that the quantum efficiencies monotonically increase for Al-richer conditions. Furthermore, the LEDs fabricated on AlN templates show superior optical and electrical properties to those on GaN templates because Al-rich AlxGa1−xN:Tb layers are coherently grown on the AlN templates due to the decreased lattice mismatch, resulting in higher crystal quality and shortening the radiative lifetime (from 280 to 227 μs) related to 5D4–7FJ (J = 3, 4, 5, 6) transitions in Tb3+ ions. Through color filters, RGB emissions originating from the respective transitions are selectively obtained at the same light-emitting area. The multi-color AlxGa1−xN:Tb-based LEDs would be a novel light source for wide applications such as micro-LED displays.
- 29 June 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (26)
Ultra-stable multiple emission wavelengths produced by Tb-doped Al x Ga1− x N-based light-emitting diodes
Tb-doped semiconductors are candidates for novel full-color light sources in next-generation high-definition displays. Particularly, Tb-doped AlxGa1−xN (AlxGa1−xN:Tb) has attracted much attention because Tb3+ ions doped into AlxGa1−xN show ultra-stable multi-color emissions consisting of blue, green, yellow, and red. Herein, we demonstrate room-temperature operation of AlxGa1−xN:Tb light-emitting diodes (LEDs) under current injections and characterize the optical/electrical properties. Ultra-stable Tb3+ emissions with narrow linewidths are clearly observed, and it is revealed that the quantum efficiencies monotonically increase for Al-richer conditions. Furthermore, the LEDs fabricated on AlN templates show superior optical and electrical properties to those on GaN templates because Al-rich AlxGa1−xN:Tb layers are coherently grown on the AlN templates due to the decreased lattice mismatch, resulting in higher crystal quality and shortening the radiative lifetime (from 280 to 227 μs) related to 5D4–7FJ (J = 3, 4, 5, 6) transitions in Tb3+ ions. Through color filters, RGB emissions originating from the respective transitions are selectively obtained at the same light-emitting area. The multi-color AlxGa1−xN:Tb-based LEDs would be a novel light source for wide applications such as micro-LED displays.
- Open Access
- 1 February 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (2)
An efficiently excited Eu3+ luminescent site formed in Eu,O-codoped GaN
For the development of III-nitride-semiconductor-based monolithic micro-light-emitting diode (LED) displays, Eu,O-codoped GaN (GaN:Eu,O) is a promising material candidate for the red LEDs. The luminescence efficiency of Eu-related emission strongly depends on the local atomic structure of Eu ions. Our previous research has revealed that post-growth thermal annealing is an effective method for reconfiguring luminescent sites, leading to a significant increase in light output. We observed the preferential formation of a site with a peak at ∼2.004 eV by the annealing process. In this study, we demonstrate that it is a previously unidentified independent site (OMVPE-X) using combined excitation–emission spectroscopy and time-resolved photoluminescence measurements. In addition, we perform excitation power-dependent photoluminescence measurements and show that this OMVPE-X site dominates the emission at a low excitation power region despite its small relative abundance, suggesting a high excitation efficiency. Most importantly, applying our annealing technique to an LED exhibits a reasonably increased electroluminescence intensity associated with OMVPE-X, confirming that this site has a high excitation efficiency also under current injection. These results demonstrate the importance of OMVPE-X as a notable luminescent site for brighter and more efficient GaN:Eu,O-based LEDs.
- 1 February 2024
- Published by AIP Publishing in AIP Advances
- Vol. 14 (2)
Open AccessAn efficiently excited Eu3+ luminescent site formed in Eu,O-codoped GaN
For the development of III-nitride-semiconductor-based monolithic micro-light-emitting diode (LED) displays, Eu,O-codoped GaN (GaN:Eu,O) is a promising material candidate for the red LEDs. The luminescence efficiency of Eu-related emission strongly depends on the local atomic structure of Eu ions. Our previous research has revealed that post-growth thermal annealing is an effective method for reconfiguring luminescent sites, leading to a significant increase in light output. We observed the preferential formation of a site with a peak at ∼2.004 eV by the annealing process. In this study, we demonstrate that it is a previously unidentified independent site (OMVPE-X) using combined excitation–emission spectroscopy and time-resolved photoluminescence measurements. In addition, we perform excitation power-dependent photoluminescence measurements and show that this OMVPE-X site dominates the emission at a low excitation power region despite its small relative abundance, suggesting a high excitation efficiency. Most importantly, applying our annealing technique to an LED exhibits a reasonably increased electroluminescence intensity associated with OMVPE-X, confirming that this site has a high excitation efficiency also under current injection. These results demonstrate the importance of OMVPE-X as a notable luminescent site for brighter and more efficient GaN:Eu,O-based LEDs.
- 16 January 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (3) , 032102
Enhanced light output of Eu, O-codoped GaN caused by reconfiguration of luminescent sites during post-growth thermal annealing
Luminescence efficiency of Eu-related emission from Eu, O-codoped GaN (GaN:Eu, O) strongly depends on the local structure of Eu ions. Growth at relatively low temperature (∼960 °C) not only enables high Eu doping concentration but also elevates Eu-clustering due to its low diffusion coefficient, which results in formation of a large number of inefficient luminescent sites. We have studied the impact of post-growth thermal annealing at high temperatures on elimination of Eu clusters by photoluminescence measurements. These clarify that thermal annealing at high temperatures induces changes in the structural conformation and converts inefficient luminescent sites to efficient ones. As a result, the sample annealed at 1100 °C shows increased luminescence efficiency with a maximum of 5.1 times that of the as-grown sample. Post-growth thermal annealing offers a way to improve the efficiency of GaN:Eu, O further for practical application in III-nitride-based monolithic three-primary colors' light-emitting diodes.
- 16 January 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (3) , 032102
Enhanced light output of Eu, O-codoped GaN caused by reconfiguration of luminescent sites during post-growth thermal annealing
Luminescence efficiency of Eu-related emission from Eu, O-codoped GaN (GaN:Eu, O) strongly depends on the local structure of Eu ions. Growth at relatively low temperature (∼960 °C) not only enables high Eu doping concentration but also elevates Eu-clustering due to its low diffusion coefficient, which results in formation of a large number of inefficient luminescent sites. We have studied the impact of post-growth thermal annealing at high temperatures on elimination of Eu clusters by photoluminescence measurements. These clarify that thermal annealing at high temperatures induces changes in the structural conformation and converts inefficient luminescent sites to efficient ones. As a result, the sample annealed at 1100 °C shows increased luminescence efficiency with a maximum of 5.1 times that of the as-grown sample. Post-growth thermal annealing offers a way to improve the efficiency of GaN:Eu, O further for practical application in III-nitride-based monolithic three-primary colors' light-emitting diodes.
- 22 July 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (16) , 28853-28864
Improved Q-factors of III-nitride-based photonic crystal nanocavities by optical loss engineering
III-nitride-based two-dimensional photonic crystal (2D-PhC) cavities with high-quality factors (Q-factors) have a large potential application, however realized Q-factors in the visible wavelength regime have been relatively moderate. In this study, we demonstrate the design and fabrication of 2D-PhC cavities to achieve high Q-factors, especially in the visible range. From the comparison of numerical calculations and the experimental results, we discuss the dominant optical losses that limit the Q-factor of H3-type cavities formed in an Eu,O-codoped GaN film. Based on these results we designed 2D-PhC cavities which can effectively suppress these dominant losses. We fabricated 2D-heterostructures and show a high Q-factor of 10500 at a resonant wavelength of ∼660 nm, which is considerably larger than any existing GaN-based nano/micro-resonators in the visible region. This study provides design guidelines for the realization of high Q-factors in photonic crystal nanocavities based on III-nitride semiconductors.
- 22 July 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (16) , 28853-28864
Improved Q-factors of III-nitride-based photonic crystal nanocavities by optical loss engineering
III-nitride-based two-dimensional photonic crystal (2D-PhC) cavities with high-quality factors (Q-factors) have a large potential application, however realized Q-factors in the visible wavelength regime have been relatively moderate. In this study, we demonstrate the design and fabrication of 2D-PhC cavities to achieve high Q-factors, especially in the visible range. From the comparison of numerical calculations and the experimental results, we discuss the dominant optical losses that limit the Q-factor of H3-type cavities formed in an Eu,O-codoped GaN film. Based on these results we designed 2D-PhC cavities which can effectively suppress these dominant losses. We fabricated 2D-heterostructures and show a high Q-factor of 10500 at a resonant wavelength of ∼660 nm, which is considerably larger than any existing GaN-based nano/micro-resonators in the visible region. This study provides design guidelines for the realization of high Q-factors in photonic crystal nanocavities based on III-nitride semiconductors.