Xinlei Jia
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xinlei Jia has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Chenchen Zhang
Guangxi Key Laboratory of Information Materials, Guangxi Collaborative Innovation Center for Structure and Properties for New Energy and Materials, School of Material Science and Engineering, Guilin University of Electronic Technology, Guilin 541004, China
2 shared publications - Fen Xu
Guilin University of Electronic Technology
2 shared publications - Hongge Pan
Institute of Science and Technology for New Energy, Xi’an Technological University, Xi’an, China
2 shared publications - Li Kang
School of Material Science & Engineering, Guangxi Key Laboratory of Information Materials, Guangxi Collaborative Innovation Center of Structure and Property for New Energy and Materials, Guilin University of Electronic Technology, Guilin 541004, China
2 shared publications - Lixian Sun
Guilin University of Electronic Technology
2 shared publications - Yiting Bu
School of Material Science & Engineering, Guangxi Key Laboratory of Information Materials, Guangxi Collaborative Innovation Center of Structure and Property for New Energy and Materials, Guilin University of Electronic Technology, Guilin 541004, China
2 shared publications
Latest Publications
- Open Access
- 9 August 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (16) , 2732
Graphene-Modified Co-B-P Catalysts for Hydrogen Generation from Sodium Borohydride Hydrolysis
Sodium borohydride (NaBH4) is considered a good candidate for hydrogen generation from hydrolysis because of its high hydrogen storage capacity (10.8 wt%) and environmentally friendly hydrolysis products. However, due to its sluggish hydrogen generation (HG) rate in the water, it usually needs an efficient catalyst to enhance the HG rate. In this work, graphene oxide (GO)-modified Co-B-P catalysts were obtained using a chemical in situ reduction method. The structure and composition of the as-prepared catalysts were characterized, and the catalytic performance for NaBH4 hydrolysis was measured as well. The results show that the as-prepared catalyst with a GO content of 75 mg (Co-B-P/75rGO) exhibited an optimal catalytic efficiency with an HG rate of 12087.8 mL min−1 g−1 at 25 °C, far better than majority of the findings that have been reported. The catalyst had a good stability with 88.9% of the initial catalytic efficiency following 10 cycles. In addition, Co-, B-, and P-modified graphene showed a synergistic effect improving the kinetics and thermodynamics of NaBH4 hydrolysis with a lower activation energy of 28.64 kJ mol−1. These results reveal that the GO-modified Co-B-P catalyst has good potential for borohydride hydrolysis applications.
- 9 August 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (16) , 2732
Open AccessGraphene-Modified Co-B-P Catalysts for Hydrogen Generation from Sodium Borohydride Hydrolysis
Sodium borohydride (NaBH4) is considered a good candidate for hydrogen generation from hydrolysis because of its high hydrogen storage capacity (10.8 wt%) and environmentally friendly hydrolysis products. However, due to its sluggish hydrogen generation (HG) rate in the water, it usually needs an efficient catalyst to enhance the HG rate. In this work, graphene oxide (GO)-modified Co-B-P catalysts were obtained using a chemical in situ reduction method. The structure and composition of the as-prepared catalysts were characterized, and the catalytic performance for NaBH4 hydrolysis was measured as well. The results show that the as-prepared catalyst with a GO content of 75 mg (Co-B-P/75rGO) exhibited an optimal catalytic efficiency with an HG rate of 12087.8 mL min−1 g−1 at 25 °C, far better than majority of the findings that have been reported. The catalyst had a good stability with 88.9% of the initial catalytic efficiency following 10 cycles. In addition, Co-, B-, and P-modified graphene showed a synergistic effect improving the kinetics and thermodynamics of NaBH4 hydrolysis with a lower activation energy of 28.64 kJ mol−1. These results reveal that the GO-modified Co-B-P catalyst has good potential for borohydride hydrolysis applications.
- Open Access
- 25 July 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (15) , 2550
Bimetallic Pt-Ni Nanoparticles Confined in Porous Titanium Oxide Cage for Hydrogen Generation from NaBH4 Hydrolysis
Sodium borohydride (NaBH4), with a high theoretical hydrogen content (10.8 wt%) and safe characteristics, has been widely employed to produce hydrogen based on hydrolysis reactions. In this work, a porous titanium oxide cage (PTOC) has been synthesized by a one-step hydrothermal method using NH2-MIL-125 as the template and L-alanine as the coordination agent. Due to the evenly distributed PtNi alloy particles with more catalytically active sites, and the synergistic effect between the PTOC and PtNi alloy particles, the PtNi/PTOC catalyst presents a high hydrogen generation rate (10,164.3 mL∙min−1∙g−1) and low activation energy (28.7 kJ∙mol−1). Furthermore, the robust porous structure of PTOC effectively suppresses the agglomeration issue; thus, the PtNi/PTOC catalyst retains 87.8% of the initial catalytic activity after eight cycles. These results indicate that the PtNi/PTOC catalyst has broad applications for the hydrolysis of borohydride.
- 25 July 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (15) , 2550
Open AccessBimetallic Pt-Ni Nanoparticles Confined in Porous Titanium Oxide Cage for Hydrogen Generation from NaBH4 Hydrolysis
Sodium borohydride (NaBH4), with a high theoretical hydrogen content (10.8 wt%) and safe characteristics, has been widely employed to produce hydrogen based on hydrolysis reactions. In this work, a porous titanium oxide cage (PTOC) has been synthesized by a one-step hydrothermal method using NH2-MIL-125 as the template and L-alanine as the coordination agent. Due to the evenly distributed PtNi alloy particles with more catalytically active sites, and the synergistic effect between the PTOC and PtNi alloy particles, the PtNi/PTOC catalyst presents a high hydrogen generation rate (10,164.3 mL∙min−1∙g−1) and low activation energy (28.7 kJ∙mol−1). Furthermore, the robust porous structure of PTOC effectively suppresses the agglomeration issue; thus, the PtNi/PTOC catalyst retains 87.8% of the initial catalytic activity after eight cycles. These results indicate that the PtNi/PTOC catalyst has broad applications for the hydrolysis of borohydride.