ZYZihui Yu

Zihui Yu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Zihui Yu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Evaluation of Irrigation Modes for Greenhouse Drip Irrigation Tomatoes Based on AquaCrop and DSSAT Models

    by Jiankun Ge, Zihui Yu, Xuewen Gong, Yinglu Ping, Jinyao Luo, Yanbin Li

    The improvement of the simulation accuracy of crop models in different greenhouse environments would be better applied to the automation management of greenhouse cultivation. Tomatoes under drip irrigation in a greenhouse were taken as the research object, and the cumulative evaporation capacity (Ep) of the 20 cm standard evaporation dish was taken as the basis for irrigation. Three treatments were set up in the experiment: high water treatment without mulch (NM-0.9 Ep), high water treatment with mulch (M-0.9 Ep), and low water treatment with mulch (M-0.5 Ep). AquaCrop and DSSAT models were used to simulate the canopy coverage, soil water content, biomass, and yield of the tomatoes. Data from 2020 were used to correct the model, and simulation results from 2021 were analyzed in this paper. The results showed that: (1) Of the two crop models, the simulation accuracy of the greenhouse tomato canopy coverage kCC was higher, and the root mean square errors were less than 6.8% (AquaCrop model) and 8.5% (DSSAT model); (2) The AquaCrop model could accurately simulate soil water change under high water treatments, while the DSSAT model was more suitable for the conditions without mulch; (3) The relative error RE of simulated and observed values for biomass B, yield Y, and water use efficiency WUE in the AquaCrop model were less than 2.0%, 2.3%, and 9.0%, respectively, while those of the DSSAT model were less than 4.7%, 7.6%, and 10.4%, respectively; (4) Considering the simulation results of each index comprehensively, the AquaCrop model was superior to the DSSAT model; subsequently, the former was used to predict 16 different water and film coating treatments (S1–S16). It was found that the greenhouse tomato yield and WUE were the highest under S7 (0.8 Ep), at 8.201 t/ha and 2.79 kg/m3, respectively.


  • Open Access

    Root Distribution of Tomato Cultivated in Greenhouse under Different Ventilation and Water Conditions

    by Jiankun Ge, Huanhuan Liu, Xuewen Gong, Zihui Yu, Lusheng Li, Yanbin Li

    Mastering root distribution is essential for optimizing the root zone environment and for improving water use efficiency, especially for crops cultivated in greenhouses. Here, we set up two irrigation amount levels based on measurements of the cumulative 20 cm pan evaporation (Ep) (i.e., K0.9: 0.9 Ep; K0.5: 0.5 Ep), and three ventilation modes through opening the greenhouse vents at different locations (TR: open the roof vents only; TRS: open both the roof and south vents; TS: open the south vents only) to reveal the effects of the ventilation mode and irrigation amount on the root distribution of greenhouse tomato. Six treatments were designed in blocks with the ventilation mode as the main treatment and the irrigation amount as the vice treatment. On this basis, the normalized root length density (NRLD) model of six treatments was developed by considering air environment, soil water and temperature conditions, root length density (RLD) and yield. The results showed that air speed of the TRS was significantly higher than TR and TS (p < 0.01), and the air temperature and relative humidity under different ventilation showed the rule: TR > TS > TRS. There was a significant third-order polynomial function relationship between NRLD and soil depth, and the coefficient of the cubic term (R0) had a bivariate quadratic polynomial function relationship with irrigation amount and air speed (determination coefficient, R2 = 0.86). Root mean square errors of the simulated and measured value of NRLD under TR, TRS and TS were 0.20, 0.23 and 0.27 in 2020, and 0.31, 0.23 and 0.28 in 2021, respectively, normalized root mean squared errors were 15%, 17%, 20% in 2020, and 23%, 18% and 21% in 2021. The RLD distribution ratio from the ground surface to a one-quarter relative root depth was 74.1%, and 88.0% from the surface to a one-half relative root depth. The results of the yield showed that a better combination of ventilation and irrigation was recommended as TRS combined with K0.9.


  • Open Access

    Prediction of Greenhouse Tomato Crop Evapotranspiration Using XGBoost Machine Learning Model

    by Jiankun Ge, Linfeng Zhao, Zihui Yu, Huanhuan Liu, Lei Zhang, Xuewen Gong, Huaiwei Sun

    Crop evapotranspiration estimation is a key parameter for achieving functional irrigation systems. However, ET is difficult to directly measure, so an ideal solution was to develop a simulation model to obtain ET. There are many ways to calculate ET, most of which use models based on the Penman–Monteith equation, but they are often inaccurate when applied to greenhouse crop evapotranspiration. The use of machine learning models to predict ET has gradually increased, but research into their application for greenhouse crops is relatively rare. We used experimental data for three years (2019–2021) to model the effects on ET of eight meteorological factors (net solar radiation (Rn), mean temperature (Ta), minimum temperature (Tamin), maximum temperature (Tamax), relative humidity (RH), minimum relative humidity (RHmin), maximum relative humidity (RHmax), and wind speed (V)) using a greenhouse drip irrigated tomato crop ET prediction model (XGBR-ET) that was based on XGBoost regression (XGBR). The model was compared with seven other common regression models (linear regression (LR), support vector regression (SVR), K neighbors regression (KNR), random forest regression (RFR), AdaBoost regression (ABR), bagging regression (BR), and gradient boosting regression (GBR)). The results showed that Rn, Ta, and Tamax were positively correlated with ET, and that Tamin, RH, RHmin, RHmax, and V were negatively correlated with ET. Rn had the greatest correlation with ET (r = 0.89), and V had the least correlation with ET (r = 0.43). The eight models were ordered, in terms of prediction accuracy, XGBR-ET > GBR-ET > SVR-ET > ABR-ET > BR-ET > LR-ET > KNR-ET > RFR-ET. The statistical indicators mean square error (0.032), root mean square error (0.163), mean absolute error (0.132), mean absolute percentage error (4.47%), and coefficient of determination (0.981) of XGBR-ET showed that XGBR-ET modeled daily ET for greenhouse tomatoes well. The parameters of the XGBR-ET model were ablated to show that the order of importance of meteorological factors on XGBR-ET was Rn > RH > RHmin> Tamax> RHmax> Tamin> Ta> V. Selecting Rn, RH, RHmin, Tamax, and Tamin as model input variables using XGBR ensured the prediction accuracy of the model (mean square error 0.047). This study has value as a reference for the simplification of the calculation of evapotranspiration for drip irrigated greenhouse tomato crops using a novel application of machine learning as a basis for an effective irrigation program.