Lei Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lei Chen has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Ke-Bo Li
National University of Defense Technology
7 shared publicationsXian-Zong Bai
National University of Defense Technology
7 shared publicationsYan-Gang Liang
National University of Defense Technology
7 shared publicationsKeBo Li
National University of Defense Technology
3 shared publicationsGuoJin Tang
National University of Defense Technology
2 shared publications- Hong-Tao Yan
Natl Univ Def Technol, Coll Aerosp Sci & Engn, Deya Rd 109, Changsha 410073, Hunan, Peoples R China
1 shared publication
Latest Publications
- Open Access
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Numerical and experimental studies of a morphing airfoil with trailing edge high-frequency flapping
The aerodynamic performance of a morphing airfoil is numerically and experimentally investigated. The morphing airfoil is designed based on macro fiber composites, capable of trailing edge flapping during 10–90 Hz with a maximum amplitude of 0.55 mm. A numerical model with flexible deformation walls based on the experiment is established to precisely restore the actual dynamic morphing instead of segmental deformation to explore the transient aerodynamic performance of high-frequency flapping. The drag coefficient is reduced by 2.07% at the flapping frequency (ff) of 37.5 Hz compared with the rigid airfoil, while the drag coefficient and the lift coefficient increase by 4.8% and 5.8% for ff at 600 Hz. The vortex is broken up by flapping, and the corresponding position has been forwarded to the tail. Dynamic mode decomposition shows that the wing's flapping dominates the second mode and the high-frequency vortex has changed to low-frequency. The energy of higher modes is transferred to lower-order modes that the first mode's power has risen sharply from 49.29% of the rigid airfoil to 91.83%. In the wind tunnel experiment, the lift and drag forces are increased by 1.88% and 0.77% at the flapping frequency of 40 Hz, respectively. Furthermore, the lift force frequency is locked by flapping and changes from 124.9 Hz of the rigid airfoil to the flapping frequency, consistent with the computational fluid dynamics results. The research has provided a solution to reduce the drag force and increase the lift force of the aircraft by the trailing edge flapping.
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Open AccessNumerical and experimental studies of a morphing airfoil with trailing edge high-frequency flapping
The aerodynamic performance of a morphing airfoil is numerically and experimentally investigated. The morphing airfoil is designed based on macro fiber composites, capable of trailing edge flapping during 10–90 Hz with a maximum amplitude of 0.55 mm. A numerical model with flexible deformation walls based on the experiment is established to precisely restore the actual dynamic morphing instead of segmental deformation to explore the transient aerodynamic performance of high-frequency flapping. The drag coefficient is reduced by 2.07% at the flapping frequency (ff) of 37.5 Hz compared with the rigid airfoil, while the drag coefficient and the lift coefficient increase by 4.8% and 5.8% for ff at 600 Hz. The vortex is broken up by flapping, and the corresponding position has been forwarded to the tail. Dynamic mode decomposition shows that the wing's flapping dominates the second mode and the high-frequency vortex has changed to low-frequency. The energy of higher modes is transferred to lower-order modes that the first mode's power has risen sharply from 49.29% of the rigid airfoil to 91.83%. In the wind tunnel experiment, the lift and drag forces are increased by 1.88% and 0.77% at the flapping frequency of 40 Hz, respectively. Furthermore, the lift force frequency is locked by flapping and changes from 124.9 Hz of the rigid airfoil to the flapping frequency, consistent with the computational fluid dynamics results. The research has provided a solution to reduce the drag force and increase the lift force of the aircraft by the trailing edge flapping.
- Open Access
- 25 July 2022
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2022, 1-13
Design of Arbitrary Time Convergence Controller for n -th Order System
A class of arbitrary time convergence controllers based on a special time-varying scaling function provide designers with a good choice to realize prescribed time stable systems. However, these controllers have the problem of conservative control parameter range and lack a uniform formula for systems of different order. Herein, the arbitrary time convergence controller is improved, the unified formula for -th order system is given, and a more accurate control parameter range is obtained. By constructing an ingenious auxiliary function and a novel Lyapunov function, the arbitrary time convergence of the -th order controller is proved, and the reasonable parameter selection range is obtained using the integrator backstepping and the mathematical induction method. The effectiveness and advantages of the proposed arbitrary time convergence controllers under saturated input constraints are illustrated through numerical simulations by comparative studies in unmanned aerial vehicle (UAV) formation control.
- 25 July 2022
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2022, 1-13
Open AccessDesign of Arbitrary Time Convergence Controller for n -th Order System
A class of arbitrary time convergence controllers based on a special time-varying scaling function provide designers with a good choice to realize prescribed time stable systems. However, these controllers have the problem of conservative control parameter range and lack a uniform formula for systems of different order. Herein, the arbitrary time convergence controller is improved, the unified formula for -th order system is given, and a more accurate control parameter range is obtained. By constructing an ingenious auxiliary function and a novel Lyapunov function, the arbitrary time convergence of the -th order controller is proved, and the reasonable parameter selection range is obtained using the integrator backstepping and the mathematical induction method. The effectiveness and advantages of the proposed arbitrary time convergence controllers under saturated input constraints are illustrated through numerical simulations by comparative studies in unmanned aerial vehicle (UAV) formation control.
- Open Access
- 31 March 2022
- Published by Frontiers Media SA in Frontiers in Neurorobotics
- Vol. 16, 817168
A Distributed Multi-Agent Formation Control Method Based on Deep Q Learning
Distributed control method plays an important role in the formation of a multi-agent system (MAS), which is the prerequisite for an MAS to complete its missions. However, the lack of considering the collision risk between agents makes many distributed formation control methods lose practicability. In this article, a distributed formation control method that takes collision avoidance into account is proposed. At first, the MAS formation control problem can be divided into pair-wise unit formation problems where each agent moves to the expected position and only needs to avoid one obstacle. Then, a deep Q network (DQN) is applied to model the agent's unit controller for this pair-wise unit formation. The DQN controller is trained by using reshaped reward function and prioritized experience replay. The agents in MAS formation share the same unit DQN controller but get different commands due to various observations. Finally, through the min-max fusion of value functions of the DQN controller, the agent can always respond to the most dangerous avoidance. In this way, we get an easy-to-train multi-agent collision avoidance formation control method. In the end, unit formation simulation and multi-agent formation simulation results are presented to verify our method.
- 31 March 2022
- Published by Frontiers Media SA in Frontiers in Neurorobotics
- Vol. 16, 817168
Open AccessA Distributed Multi-Agent Formation Control Method Based on Deep Q Learning
Distributed control method plays an important role in the formation of a multi-agent system (MAS), which is the prerequisite for an MAS to complete its missions. However, the lack of considering the collision risk between agents makes many distributed formation control methods lose practicability. In this article, a distributed formation control method that takes collision avoidance into account is proposed. At first, the MAS formation control problem can be divided into pair-wise unit formation problems where each agent moves to the expected position and only needs to avoid one obstacle. Then, a deep Q network (DQN) is applied to model the agent's unit controller for this pair-wise unit formation. The DQN controller is trained by using reshaped reward function and prioritized experience replay. The agents in MAS formation share the same unit DQN controller but get different commands due to various observations. Finally, through the min-max fusion of value functions of the DQN controller, the agent can always respond to the most dangerous avoidance. In this way, we get an easy-to-train multi-agent collision avoidance formation control method. In the end, unit formation simulation and multi-agent formation simulation results are presented to verify our method.
- 28 October 2020
- Published by Science China Press., Co. Ltd. in SCIENTIA SINICA Technologica
- Vol. 51 (4) , 424-434
Toward space situational awareness: A space-based autonomous optical tracking method for space objects
- 28 October 2020
- Published by Science China Press., Co. Ltd. in SCIENTIA SINICA Technologica
- Vol. 51 (4) , 424-434
Toward space situational awareness: A space-based autonomous optical tracking method for space objects
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 18 (23) , 9802-9811
Strategy Design and Sensor Scheduling for Optical Navigation of Low Earth Orbit Satellites
Space-based optical (SBO) sensor is a special kind of star sensor, which can be used in not only the space-based observation for space objects but also satellite navigation, called optical navigation in this paper. The aim of this paper is to design optical navigation strategy for low earth orbit (LEO) satellites, including the selection of beacon objects, and the sensor scheduling for improving navigation accuracy. The processing and observation geometry of space-based optical observation is illustrated first. Based on the characteristics of the space-based optical observation, the distribution of beacon geosynchronous orbit satellites is designed for optical navigation of LEO satellites. And the sensor scheduling criterion for optical navigation is deduced to analyze the characteristics of optical navigation and schedule the navigation mission. It is found that an efficient way to improve the optical navigation accuracy is to add an additional sensor to track other beacon objects, whose line of sight (LOS) should be perpendicular to the original LOS of the sensor as far as possible. Therefore, global positioning system satellites are used as the supplement of beacon objects. Finally, based on the sensor scheduling criterion, navigation for a LEO satellite with two SBO sensors is scheduled, which obtains more accurate results and converges more rapidly.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 18 (23) , 9802-9811
Strategy Design and Sensor Scheduling for Optical Navigation of Low Earth Orbit Satellites
Space-based optical (SBO) sensor is a special kind of star sensor, which can be used in not only the space-based observation for space objects but also satellite navigation, called optical navigation in this paper. The aim of this paper is to design optical navigation strategy for low earth orbit (LEO) satellites, including the selection of beacon objects, and the sensor scheduling for improving navigation accuracy. The processing and observation geometry of space-based optical observation is illustrated first. Based on the characteristics of the space-based optical observation, the distribution of beacon geosynchronous orbit satellites is designed for optical navigation of LEO satellites. And the sensor scheduling criterion for optical navigation is deduced to analyze the characteristics of optical navigation and schedule the navigation mission. It is found that an efficient way to improve the optical navigation accuracy is to add an additional sensor to track other beacon objects, whose line of sight (LOS) should be perpendicular to the original LOS of the sensor as far as possible. Therefore, global positioning system satellites are used as the supplement of beacon objects. Finally, based on the sensor scheduling criterion, navigation for a LEO satellite with two SBO sensors is scheduled, which obtains more accurate results and converges more rapidly.
- 8 October 2018
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 233 (10) , 3547-3563
Performance analysis of differential geometric guidance law against high-speed target with arbitrarily maneuvering acceleration
The interception of high-speed target with an arbitrary maneuvering acceleration causes serious troubles to the guidance and control system design of airborne missile. A novel guidance law based on the classical differential geometry curve theory was proposed not long ago. Although it is believed and numerically demonstrated that this differential geometric guidance law (DGGL) is superior to the classical pure proportional navigation (PPN) in intercepting high-speed targets, its performance has not been thoroughly analyzed. In this paper, using the Lyapunov-like approach, the performance of DGGL against the high-speed target with an arbitrary but upper-bounded maneuvering acceleration is well studied. The upper bounds of the LOS rate and commanded acceleration of DGGL are obtained, and conditions that guarantee the capture of this type of maneuvering target are also presented. The nonlinear relative dynamics between the missile and target is taken into full account. Finally, the proposed theoretical findings are demonstrated by numerical simulation examples.
- 8 October 2018
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 233 (10) , 3547-3563
Performance analysis of differential geometric guidance law against high-speed target with arbitrarily maneuvering acceleration
The interception of high-speed target with an arbitrary maneuvering acceleration causes serious troubles to the guidance and control system design of airborne missile. A novel guidance law based on the classical differential geometry curve theory was proposed not long ago. Although it is believed and numerically demonstrated that this differential geometric guidance law (DGGL) is superior to the classical pure proportional navigation (PPN) in intercepting high-speed targets, its performance has not been thoroughly analyzed. In this paper, using the Lyapunov-like approach, the performance of DGGL against the high-speed target with an arbitrary but upper-bounded maneuvering acceleration is well studied. The upper bounds of the LOS rate and commanded acceleration of DGGL are obtained, and conditions that guarantee the capture of this type of maneuvering target are also presented. The nonlinear relative dynamics between the missile and target is taken into full account. Finally, the proposed theoretical findings are demonstrated by numerical simulation examples.
- 13 July 2018
- Published by Springer Nature in Science China Technological Sciences
- Vol. 61 (8) , 1161-1174
Performance of 3D TPN against true-arbitrarily maneuvering target for exoatmospheric interception
- 13 July 2018
- Published by Springer Nature in Science China Technological Sciences
- Vol. 61 (8) , 1161-1174
Performance of 3D TPN against true-arbitrarily maneuvering target for exoatmospheric interception
- 29 November 2017
- Published by Springer Nature
- p. E1
Erratum to: Orbital Data Applications for Space Objects
- 29 November 2017
- Published by Springer Nature
- p. E1
Erratum to: Orbital Data Applications for Space Objects