Luiz Thiago Vasconcelos da Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Luiz Thiago Vasconcelos da Silva has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Ronaldo Ferreira Do Nascimento
Federal University of Ceará
3 shared publications - Adriana Nunes Correia
Universidade Federal do Ceará Campus do Pici, Bl 940
2 shared publications Ronaldo Ferreira Do Nascimento
Trace Analysis Laboratory, Department of Analytical Chemistry and Physical Chemistry Federal University of Ceará, Campus do Pici Fortaleza Ceará Brazil
2 shared publications- Thiago Mielle Brito Ferreira Oliveira
Federal University of Cariri Av. Ten. Raimundo Rocha, 1639
2 shared publications - Adonay Rodrigues Loiola
Department of Organic and Inorganic Chemistry, Federal University of Ceará, Fortaleza, Brazil
1 shared publication - Amanda Fonseca Lopes
Department of Analytical Chemistry and Physical-Chemistry, Federal University of Ceará, Fortaleza, 60455-970, Ceará, Brazil
1 shared publication
Latest Publications
- Open Access
- 24 July 2026
- Published by Elsevier in SSRN Electronic Journal
Tailoring Porous FexMn(1-x) Coatings for the Hydrogen Evolution Reaction via Deep Eutectic Solvent-Mediated Electrodeposition
This work reports the successful electrodeposition of coatings from a plating solution prepared from a mixture of choline chloride and urea in a molar ratio of 1:2, with variable amounts of FeCl2 and MnCl2. This strategy allowed the evaluation of the effect of Mn content on surface morphology, crystallographic phases and electrocatalytic properties for the Hydrogen Evolution Reaction (HER), which were assessed by recording potentiodynamic polarization curves in 0.5 mol L-1 NaOH solution at a scan rate of 5 mV s-1. The SEM images revealed a porous surface of coatings, which improved the electrochemical surface area (ECSA) compared with non-porous Fe coatings. The obtained X-ray diffractograms revealed the presence of ferritic and austenitic phases in all coatings. Although pure Fe exhibits high intrinsic activity at low rates, the Fe-Mn coatings displayed superior performance and robustness under industrial conditions (150 mA cm⁻²). Finally, the electrodeposited coatings have the potential to be used as next-generation cathodes, bridging the gap between laboratory-scale design and sustainable industrial hydrogen production.
- 24 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessTailoring Porous FexMn(1-x) Coatings for the Hydrogen Evolution Reaction via Deep Eutectic Solvent-Mediated Electrodeposition
This work reports the successful electrodeposition of coatings from a plating solution prepared from a mixture of choline chloride and urea in a molar ratio of 1:2, with variable amounts of FeCl2 and MnCl2. This strategy allowed the evaluation of the effect of Mn content on surface morphology, crystallographic phases and electrocatalytic properties for the Hydrogen Evolution Reaction (HER), which were assessed by recording potentiodynamic polarization curves in 0.5 mol L-1 NaOH solution at a scan rate of 5 mV s-1. The SEM images revealed a porous surface of coatings, which improved the electrochemical surface area (ECSA) compared with non-porous Fe coatings. The obtained X-ray diffractograms revealed the presence of ferritic and austenitic phases in all coatings. Although pure Fe exhibits high intrinsic activity at low rates, the Fe-Mn coatings displayed superior performance and robustness under industrial conditions (150 mA cm⁻²). Finally, the electrodeposited coatings have the potential to be used as next-generation cathodes, bridging the gap between laboratory-scale design and sustainable industrial hydrogen production.
- Open Access
- 23 February 2026
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 114 (2)
Development and Evaluation of the Physico‐Chemical and Biological Properties of New Experimental Hydraulic Silicates
To evaluate the physico‐chemical and biological properties of experimental hydraulic cements ( EHCs ) prepared after the synthesis of tricalcium silicate ( C 3 S ), calcium zirconium silicate ( CZS ), and strontium phosphate silicate ( SPS ) in comparison with Biodentine ( BD ). After synthesizing and characterizing the silicates ( FTIR / XRD / SEM ‐ EDS / TEM ), EHCs were analyzed for setting, radiopacity, dimensional stability, compressive strength, solubility, pH , calcium/strontium ion release, and biocompatibility. Significant differences were observed in setting times, with BD < C 3 S / CZS and BD / SPS < C 3 S , both in initial and final ( p < 0.05); BD offered shorter times. Regarding radiopacity, the materials ranked as SPS > CZS > C 3 S > BD ( p < 0.05). No differences were observed in dimensional stability (24 h/30 days) ( p > 0.05). BD showed higher compressive strength than EHCs in both assessed periods ( p < 0.05); EHCs exhibited an increase over time ( p < 0.05). Regarding solubility, BD had less mass loss in both periods ( p < 0.05). Regarding pH , differences were found at 3 h/15 days between BD (8.70; 7.99) and C 3 S / CZS cements ( p < 0.05). At 72 h/168 h, C 3 S (9.50; 9.23) showed higher values than SPS / BD and CZS / BD , respectively ( p < 0.05). For calcium/strontium release, differences were observed at 3 h between C 3 S / CZS / BD and SPS ( p < 0.05). In subsequent periods, SPS provided the highest release, superior to C 3 S / CZS ( p < 0.05). Regarding biocompatibility, no significant differences were observed in the presence of polymorphonuclear cells, mononuclear cells, or fibroblasts ( p > 0.05); less vascularization was observed at 30 days for BD / C 3 S / CZS ( p < 0.05). Under the study's conditions, it can be concluded that EHCs exhibited promising physicochemical properties, which can still be improved, and adequate biocompatibility. Thus, this article highlights the possibility of developing new silicate‐based hydraulic cements.
- 23 February 2026
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 114 (2)
Open AccessDevelopment and Evaluation of the Physico‐Chemical and Biological Properties of New Experimental Hydraulic Silicates
To evaluate the physico‐chemical and biological properties of experimental hydraulic cements ( EHCs ) prepared after the synthesis of tricalcium silicate ( C 3 S ), calcium zirconium silicate ( CZS ), and strontium phosphate silicate ( SPS ) in comparison with Biodentine ( BD ). After synthesizing and characterizing the silicates ( FTIR / XRD / SEM ‐ EDS / TEM ), EHCs were analyzed for setting, radiopacity, dimensional stability, compressive strength, solubility, pH , calcium/strontium ion release, and biocompatibility. Significant differences were observed in setting times, with BD < C 3 S / CZS and BD / SPS < C 3 S , both in initial and final ( p < 0.05); BD offered shorter times. Regarding radiopacity, the materials ranked as SPS > CZS > C 3 S > BD ( p < 0.05). No differences were observed in dimensional stability (24 h/30 days) ( p > 0.05). BD showed higher compressive strength than EHCs in both assessed periods ( p < 0.05); EHCs exhibited an increase over time ( p < 0.05). Regarding solubility, BD had less mass loss in both periods ( p < 0.05). Regarding pH , differences were found at 3 h/15 days between BD (8.70; 7.99) and C 3 S / CZS cements ( p < 0.05). At 72 h/168 h, C 3 S (9.50; 9.23) showed higher values than SPS / BD and CZS / BD , respectively ( p < 0.05). For calcium/strontium release, differences were observed at 3 h between C 3 S / CZS / BD and SPS ( p < 0.05). In subsequent periods, SPS provided the highest release, superior to C 3 S / CZS ( p < 0.05). Regarding biocompatibility, no significant differences were observed in the presence of polymorphonuclear cells, mononuclear cells, or fibroblasts ( p > 0.05); less vascularization was observed at 30 days for BD / C 3 S / CZS ( p < 0.05). Under the study's conditions, it can be concluded that EHCs exhibited promising physicochemical properties, which can still be improved, and adequate biocompatibility. Thus, this article highlights the possibility of developing new silicate‐based hydraulic cements.
- 2 November 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 93, 346-354
The role of FexCu(1‒x) electrodeposits from a deep eutectic solvent in promoting the hydrogen evolution reaction
- 2 November 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 93, 346-354
The role of FexCu(1‒x) electrodeposits from a deep eutectic solvent in promoting the hydrogen evolution reaction
- 22 June 2024
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 29 (8) , 3265-3291
Influence study of cationic surfactant, temperature, and current on the electrocoagulation process for removal of Remazol Red RB 133 by central composite design and response surface methodology
- 22 June 2024
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 29 (8) , 3265-3291
Influence study of cationic surfactant, temperature, and current on the electrocoagulation process for removal of Remazol Red RB 133 by central composite design and response surface methodology
- 3 April 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 64, 906-913
Electrocoagulation cell for the production of hydrogen without carbon emission and simultaneous treatment of textile wastewater
- 3 April 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 64, 906-913
Electrocoagulation cell for the production of hydrogen without carbon emission and simultaneous treatment of textile wastewater
- 26 July 2022
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 104 (16) , 3913-3935
Magnetic zeolite from fly ash as a cost-effective adsorbent for Cu²⁺, Pb²⁺, Zn²⁺, and Cd²⁺ removal from aqueous media: a comprehensive study
In this work, we report the synthesis of magnetic zeolite A using fly ash as the main sources of SiO₂ and Al₂O₃, by hydrothermal use in the adsorption of Pb2, Cd2, Zn2⁺ and Cu2. The composite synthesis was successful, and the obtained material was characterised by using different techniques, such as X-ray diffraction (XRD), X-ray fluorescence (XRF), Infrared vibrational spectroscopy (FTIR), Electron Microscopy (SEM), and pH point of zero charge (pHpzc). XRD measurements confirm zeolites A as the main crystalline phases (98.5%), with the presence of a small amount of sodalite (1.5%). In the SEM of magnetic composite, the characteristic morphology for zeolite A was noted, with magnetite nanoparticles dispersed on its surface, resulting in a composite with magnetic properties. In the adsorption study, the magnetic composite showed a fast rate of adsorption, in which the pseudo second order model was the one that best described the experimental data of the metal ions under study. The Redlich-Peterson isotherm model best represented the experimental data of Pb2⁺ and Cd2⁺, while the Langmuir and Sips models fitted Zn2⁺ and Cu2⁺, respectively. Thus, the results showed that the magnetic composite presented high magnetic quality, facilitating its separation from the aqueous medium, as well as being a promising adsorbent in the adsorption of metal ions in aqueous medium. GRAPHICAL ABSTRACT
- 26 July 2022
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 104 (16) , 3913-3935
Magnetic zeolite from fly ash as a cost-effective adsorbent for Cu²⁺, Pb²⁺, Zn²⁺, and Cd²⁺ removal from aqueous media: a comprehensive study
In this work, we report the synthesis of magnetic zeolite A using fly ash as the main sources of SiO₂ and Al₂O₃, by hydrothermal use in the adsorption of Pb2, Cd2, Zn2⁺ and Cu2. The composite synthesis was successful, and the obtained material was characterised by using different techniques, such as X-ray diffraction (XRD), X-ray fluorescence (XRF), Infrared vibrational spectroscopy (FTIR), Electron Microscopy (SEM), and pH point of zero charge (pHpzc). XRD measurements confirm zeolites A as the main crystalline phases (98.5%), with the presence of a small amount of sodalite (1.5%). In the SEM of magnetic composite, the characteristic morphology for zeolite A was noted, with magnetite nanoparticles dispersed on its surface, resulting in a composite with magnetic properties. In the adsorption study, the magnetic composite showed a fast rate of adsorption, in which the pseudo second order model was the one that best described the experimental data of the metal ions under study. The Redlich-Peterson isotherm model best represented the experimental data of Pb2⁺ and Cd2⁺, while the Langmuir and Sips models fitted Zn2⁺ and Cu2⁺, respectively. Thus, the results showed that the magnetic composite presented high magnetic quality, facilitating its separation from the aqueous medium, as well as being a promising adsorbent in the adsorption of metal ions in aqueous medium. GRAPHICAL ABSTRACT