Peiyu Zhao
Research Subjects
Peiyu Zhao has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Jiangxuan Song
State Key Laboratory for Mechanical Behavior of Materials Shaanxi International Research Center for Soft Matter Xi'an Jiaotong University Xi'an China
2 shared publications Ahu Shao
Northwestern Polytechnical University
1 shared publication- Bing Li
Tongji University
1 shared publication Chonggao Bao
State Key Laboratory for Mechanical Behavior of Materials, Shaanxi International Research Center for Soft Matter, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publicationChunwei Li
Northwestern Polytechnical University
1 shared publicationFarshad Boorboor Ajdari
Department of Applied Chemistry, Faculty of Chemistry, University of Kashan, Kashan 8731753153, Iran
1 shared publication
Latest Publications
- 19 November 2026
- Published by American Chemical Society (ACS) in ACS Nano
Screening of Single-Atom Catalysts for Na2S-Mediated Pre-Sodiation and Interfacial Rejuvenation in Low N/P Ratio Sodium Batteries
The pursuit of higher energy and power densities in sodium-ion batteries (SIBs) is constrained by the trade-off between multielectron faradaic reaction kinetics and interfacial stability. Here, we develop a catalyst-mediated presodiation and interfacial rejuvenation strategy to address the low initial Coulombic efficiency of hard carbon (HC) anodes and transition-metal (TM) dissolution from high-voltage polyanionic and layered oxide cathodes in ampere-hour-scale pouch cells. Moving beyond empirical catalyst selection, we establish a rational screening framework for transition-metal single-atom sites based on electronic coupling and geometric compatibility with Na2S. Atomically dispersed Co (SA-Co) emerges as the preferred catalyst, reducing the Na2S decomposition potential to 3.49 V. An SA-Co/Na2S@C functional layer enables precise sodium-inventory compensation and simultaneous interfacial rejuvenation. Unlike conventional blended additives, sulfur-derived polysulfides suppress TM crossover and support high-voltage operation up to 4.5 V, while replenished sodium compensates irreversible HC losses and stabilizes the solid-electrolyte interphase. Coupling an SA-Co/Na2S@C-coated Na3V2(PO4)3 (NVP) cathode (18 mg cm–2) with an HC anode under lean-sodium and lean-electrolyte conditions (N/P ratio = 0.4; E/C ratio = 1.2 g Ah1–) yields a 1.1 Ah pouch cell retaining 97.2% capacity after 200 cycles, with gravimetric and volumetric energy densities of 317 Wh kg–1 and 485 Wh L–1, respectively, and a maximum power density of 831 W kg–1. Compatible with existing electrode manufacturing, this scalable interfacial approach offers a practical pathway toward high-energy, high-power SIBs.
- 19 November 2026
- Published by American Chemical Society (ACS) in ACS Nano
Screening of Single-Atom Catalysts for Na2S-Mediated Pre-Sodiation and Interfacial Rejuvenation in Low N/P Ratio Sodium Batteries
The pursuit of higher energy and power densities in sodium-ion batteries (SIBs) is constrained by the trade-off between multielectron faradaic reaction kinetics and interfacial stability. Here, we develop a catalyst-mediated presodiation and interfacial rejuvenation strategy to address the low initial Coulombic efficiency of hard carbon (HC) anodes and transition-metal (TM) dissolution from high-voltage polyanionic and layered oxide cathodes in ampere-hour-scale pouch cells. Moving beyond empirical catalyst selection, we establish a rational screening framework for transition-metal single-atom sites based on electronic coupling and geometric compatibility with Na2S. Atomically dispersed Co (SA-Co) emerges as the preferred catalyst, reducing the Na2S decomposition potential to 3.49 V. An SA-Co/Na2S@C functional layer enables precise sodium-inventory compensation and simultaneous interfacial rejuvenation. Unlike conventional blended additives, sulfur-derived polysulfides suppress TM crossover and support high-voltage operation up to 4.5 V, while replenished sodium compensates irreversible HC losses and stabilizes the solid-electrolyte interphase. Coupling an SA-Co/Na2S@C-coated Na3V2(PO4)3 (NVP) cathode (18 mg cm–2) with an HC anode under lean-sodium and lean-electrolyte conditions (N/P ratio = 0.4; E/C ratio = 1.2 g Ah1–) yields a 1.1 Ah pouch cell retaining 97.2% capacity after 200 cycles, with gravimetric and volumetric energy densities of 317 Wh kg–1 and 485 Wh L–1, respectively, and a maximum power density of 831 W kg–1. Compatible with existing electrode manufacturing, this scalable interfacial approach offers a practical pathway toward high-energy, high-power SIBs.
- 22 July 2022
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 5 (8) , 10141-10148
Regulating Lithium Ion Transport by a Highly Stretchable Interface for Dendrite-Free Lithium Metal Batteries
- 22 July 2022
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 5 (8) , 10141-10148
Regulating Lithium Ion Transport by a Highly Stretchable Interface for Dendrite-Free Lithium Metal Batteries
- 1 September 2021
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 60, 156-161
Functional copolymer binder for nickel-rich cathode with exceptional cycling stability at high temperature through coordination interaction
- 1 September 2021
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 60, 156-161
Functional copolymer binder for nickel-rich cathode with exceptional cycling stability at high temperature through coordination interaction