Wenqi Wei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Wenqi Wei has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Ting Wang
Institute of Physics
5 shared publications - Zihao Wang
Chinese Academy of Sciences
5 shared publications Dong Han
Beijing National Laboratory for Condensed Matter Physics, Institute of Physics, Chinese Academy of Sciences, Beijing 100190, People’s Republic of China
3 shared publications- Jian-Jun Zhang
Institute of Physics, Chinese Academy of Sciences 4 , Beijing 100190
3 shared publications - Bo Yang
Institute of Physics
2 shared publications - Dong Han
Institute of Semiconductors, Chinese Academy of Sciences
2 shared publications
Latest Publications
- 13 February 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (13) , 135116
Quantum dot distributed feedback laser grown on silicon with laterally coupled gratings
Direct epitaxy of quantum dot (QD) lasers on silicon is considered the holy grail of integrated silicon photonics. Various InAs/GaAs QD lasers grown directly on silicon substrates have been demonstrated but there has been limited research on single-longitudinal-mode lasers on silicon. Here, to avoid any regrowth procedures, distributed feedback (DFB) QD lasers on silicon are fabricated with lateral coupled (LC) gratings via a simplified fabrication process. The LC-DFB laser has a maximum laser power of 4.2 mW and threshold current of 80 mA under continuous-wave current mode at room temperature. Under an injection current of 110 mA, the side mode suppression ratio reaches 50 dB at room temperature. The relative intensity noise of the laser is measured as −135 dB Hz–1, with a corresponding optical linewidth of 3.5 MHz.
- 13 February 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (13) , 135116
Quantum dot distributed feedback laser grown on silicon with laterally coupled gratings
Direct epitaxy of quantum dot (QD) lasers on silicon is considered the holy grail of integrated silicon photonics. Various InAs/GaAs QD lasers grown directly on silicon substrates have been demonstrated but there has been limited research on single-longitudinal-mode lasers on silicon. Here, to avoid any regrowth procedures, distributed feedback (DFB) QD lasers on silicon are fabricated with lateral coupled (LC) gratings via a simplified fabrication process. The LC-DFB laser has a maximum laser power of 4.2 mW and threshold current of 80 mA under continuous-wave current mode at room temperature. Under an injection current of 110 mA, the side mode suppression ratio reaches 50 dB at room temperature. The relative intensity noise of the laser is measured as −135 dB Hz–1, with a corresponding optical linewidth of 3.5 MHz.
- 13 January 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
Quantum dot distributed feedback laser grown on silicon with laterally coupled gratings
The direct epitaxy of quantum dot (QD) lasers on silicon was considered as holy grail of integrated silicon photonics. With demonstration of various InAs/GaAs QD lasers directly grown on silicon substrates, there are limited research carried on single longitudinal mode lasers on silicon. Here, to avoid any regrowth procedures, distributed feedback (DFB) QD lasers on silicon are fabricated with lateral coupled (LC) gratings via simplified fabrication process. The LC-DFB laser has a maximum laser power of 4.5 mW and threshold current of 80 mA under continuous-wave current mode at room temperature. Under injection current of 110 mA, the side mode suppression ratio (SMSR) reaches 50 dB at room temperature. The RIN of the laser is measured with value of -135dB/Hz with corresponding optical linewidth of 3.5 MHz.
- 13 January 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
Quantum dot distributed feedback laser grown on silicon with laterally coupled gratings
The direct epitaxy of quantum dot (QD) lasers on silicon was considered as holy grail of integrated silicon photonics. With demonstration of various InAs/GaAs QD lasers directly grown on silicon substrates, there are limited research carried on single longitudinal mode lasers on silicon. Here, to avoid any regrowth procedures, distributed feedback (DFB) QD lasers on silicon are fabricated with lateral coupled (LC) gratings via simplified fabrication process. The LC-DFB laser has a maximum laser power of 4.5 mW and threshold current of 80 mA under continuous-wave current mode at room temperature. Under injection current of 110 mA, the side mode suppression ratio (SMSR) reaches 50 dB at room temperature. The RIN of the laser is measured with value of -135dB/Hz with corresponding optical linewidth of 3.5 MHz.
- Open Access
- 1 August 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (8)
Unveiling charge transport in monolayer and few-layer CoPS3/metal contact: Insight from C-AFM
Monolayer and few-layer CoPS3 have been successfully synthesized via an Au-assisted exfoliation technique, with their transport properties subsequently investigated by conductive atomic force microscopy. Rectification effects can be observed in CoPS3 nanosheets due to the Schottky junction formation at the Au/CoPS3 interface, especially in configurations comprising two or more layer flakes. The distinct transport properties between monolayer and few-layer samples demonstrate that the charge transport behavior in the vertical direction is associated with the van der Waals gap. The calculated electron affinity for CoPS3 is about 4.84 eV, as revealed by the thermionic emission model. The results obtained contribute to the knowledge base concerning the transport characteristics of ultrathin MPX3, facilitating further exploration of the transport behavior of these materials and their potential applications in novel electronic devices.
- 1 August 2024
- Published by AIP Publishing in APL Materials
- Vol. 12 (8)
Open AccessUnveiling charge transport in monolayer and few-layer CoPS3/metal contact: Insight from C-AFM
Monolayer and few-layer CoPS3 have been successfully synthesized via an Au-assisted exfoliation technique, with their transport properties subsequently investigated by conductive atomic force microscopy. Rectification effects can be observed in CoPS3 nanosheets due to the Schottky junction formation at the Au/CoPS3 interface, especially in configurations comprising two or more layer flakes. The distinct transport properties between monolayer and few-layer samples demonstrate that the charge transport behavior in the vertical direction is associated with the van der Waals gap. The calculated electron affinity for CoPS3 is about 4.84 eV, as revealed by the thermionic emission model. The results obtained contribute to the knowledge base concerning the transport characteristics of ultrathin MPX3, facilitating further exploration of the transport behavior of these materials and their potential applications in novel electronic devices.
- Open Access
E-Band InAs Quantum Dot Micro-Disk Laser with Metamorphic InGaAs Layers Grown on GaAs/Si (001) Substrate
The direct growth of III-V quantum dot (QD) lasers on silicon substrate has been rapidly developing over the past decade and has been recognized as a promising method for achieving on-chip light sources in photonic integrated circuits (PICs). Up to date, O- and C/L-bands InAs QD lasers on Si have been extensively investigated, but as an extended telecommunication wavelength, the E-band QD lasers directly grown on Si substrates are not available yet. Here, we demonstrate the first E-band (1365 nm) InAs QD micro-disk lasers epitaxially grown on Si (001) substrates by using a III-V/IV hybrid dual-chamber molecular beam epitaxy (MBE) system. The micro-disk laser device on Si was characterized with an optical threshold power of 0.424 mW and quality factor (Q) of 1727.2 at 200 K. The results presented here indicate a path to on-chip silicon photonic telecom-transmitters.
Open AccessE-Band InAs Quantum Dot Micro-Disk Laser with Metamorphic InGaAs Layers Grown on GaAs/Si (001) Substrate
The direct growth of III-V quantum dot (QD) lasers on silicon substrate has been rapidly developing over the past decade and has been recognized as a promising method for achieving on-chip light sources in photonic integrated circuits (PICs). Up to date, O- and C/L-bands InAs QD lasers on Si have been extensively investigated, but as an extended telecommunication wavelength, the E-band QD lasers directly grown on Si substrates are not available yet. Here, we demonstrate the first E-band (1365 nm) InAs QD micro-disk lasers epitaxially grown on Si (001) substrates by using a III-V/IV hybrid dual-chamber molecular beam epitaxy (MBE) system. The micro-disk laser device on Si was characterized with an optical threshold power of 0.424 mW and quality factor (Q) of 1727.2 at 200 K. The results presented here indicate a path to on-chip silicon photonic telecom-transmitters.
- Open Access
- 17 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (16)
Epitaxial GaSb films directly grown on on-axis Si(001) with low defect density by MBE
In recent years, GaSb-on-Si direct heteroepitaxy has been highly desirable to extend the operating wavelength range into mid-infrared and high-mobility applications, such as free-space communications, gas sensing, and hyperspectral imaging. High-quality GaSb films on Si remain challenging due to the high density of defects generated during the growth. For this purpose, epitaxial GaSb films were grown by molecular beam epitaxy on on-axis Si(001). Due to the large lattice mismatch (12.2%) between GaSb and Si, here, we proposed a radical design and growth strategy with the primary objective of achieving the annihilation of antiphase boundaries (APBs) and the reduction of threading dislocation density (TDD). Benefitting from a V-grooved Si hollow structure, we demonstrated the growth of emerging-APB-free GaSb film on Si(001) with low mosaicity. Moreover, by introducing InGaSb/GaSb dislocation filtering layers, the atomically flat surface root mean square roughness is improved to 0.34 (on Si) and 0.14 nm (on GaAs/Si). Moreover, the corresponding TDD can be reduced to 3.5 × 107 and 2 × 107 cm−2, respectively, one order of magnitude lower than the minimum value found in the literature. These reported results are a powerful lever to improve the overall quality of epitaxial Si-based antimonide, which is of high interest for various devices and critical applications, such as laser diodes, photo-detectors, and solar cells.
- 17 April 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 122 (16)
Open AccessEpitaxial GaSb films directly grown on on-axis Si(001) with low defect density by MBE
In recent years, GaSb-on-Si direct heteroepitaxy has been highly desirable to extend the operating wavelength range into mid-infrared and high-mobility applications, such as free-space communications, gas sensing, and hyperspectral imaging. High-quality GaSb films on Si remain challenging due to the high density of defects generated during the growth. For this purpose, epitaxial GaSb films were grown by molecular beam epitaxy on on-axis Si(001). Due to the large lattice mismatch (12.2%) between GaSb and Si, here, we proposed a radical design and growth strategy with the primary objective of achieving the annihilation of antiphase boundaries (APBs) and the reduction of threading dislocation density (TDD). Benefitting from a V-grooved Si hollow structure, we demonstrated the growth of emerging-APB-free GaSb film on Si(001) with low mosaicity. Moreover, by introducing InGaSb/GaSb dislocation filtering layers, the atomically flat surface root mean square roughness is improved to 0.34 (on Si) and 0.14 nm (on GaAs/Si). Moreover, the corresponding TDD can be reduced to 3.5 × 107 and 2 × 107 cm−2, respectively, one order of magnitude lower than the minimum value found in the literature. These reported results are a powerful lever to improve the overall quality of epitaxial Si-based antimonide, which is of high interest for various devices and critical applications, such as laser diodes, photo-detectors, and solar cells.
- 4 August 2022
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 55 (40) , 405105
Reliable InAs quantum dot lasers grown on patterned Si (001) substrate with embedded hollow structures assisted thermal stress relaxation
Direct epitaxial growth of III–V quantum dot (QD) lasers on Si (001) substrates is recognized as a promising and low-cost method for realizing high-performance on-chip light sources in silicon photonic integrated circuits (PICs). Recently, the CMOS-compatible patterned Si (001) substrates with sawtooth structures have been widely implemented to suppress the lattice mismatch induced defects and antiphase boundaries for heteroepitaxial growth of high-quality III–V materials on Si. Considerable progresses have been made on high-performance 1300 nm InAs/GaAs QD lasers on Si (001). Here, we report a thermal stress-relaxed (111)-faceted silicon hollow structures by homoepitaxial method for reliable InAs/GaAs QD lasers growing on Si (001) substrates. Both simulation analysis and experimental results indicate that the voids buried below the sawtooth structures can release about 9% of the accumulative thermal stress of the III–V/Si system during the cooling process. Furthermore, electrically pumped InAs/GaAs QD narrow ridge lasers are grown and fabricated on the specially designed Si (001) platforms with a maximum operation temperature up to 90 °C under continuous-wave operation mode. Additionally, an extrapolated lifetime of over 5300 h is calculated from the reliability test at 65 °C. These results lead toward high-yield, scalable, and reliable III–V lasers on Si (001) substrates for PICs.
- 4 August 2022
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 55 (40) , 405105
Reliable InAs quantum dot lasers grown on patterned Si (001) substrate with embedded hollow structures assisted thermal stress relaxation
Direct epitaxial growth of III–V quantum dot (QD) lasers on Si (001) substrates is recognized as a promising and low-cost method for realizing high-performance on-chip light sources in silicon photonic integrated circuits (PICs). Recently, the CMOS-compatible patterned Si (001) substrates with sawtooth structures have been widely implemented to suppress the lattice mismatch induced defects and antiphase boundaries for heteroepitaxial growth of high-quality III–V materials on Si. Considerable progresses have been made on high-performance 1300 nm InAs/GaAs QD lasers on Si (001). Here, we report a thermal stress-relaxed (111)-faceted silicon hollow structures by homoepitaxial method for reliable InAs/GaAs QD lasers growing on Si (001) substrates. Both simulation analysis and experimental results indicate that the voids buried below the sawtooth structures can release about 9% of the accumulative thermal stress of the III–V/Si system during the cooling process. Furthermore, electrically pumped InAs/GaAs QD narrow ridge lasers are grown and fabricated on the specially designed Si (001) platforms with a maximum operation temperature up to 90 °C under continuous-wave operation mode. Additionally, an extrapolated lifetime of over 5300 h is calculated from the reliability test at 65 °C. These results lead toward high-yield, scalable, and reliable III–V lasers on Si (001) substrates for PICs.