Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ige Ayodeji Rapheal has a total of 38 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Review: Assessment of Domestic Solid Fuel Sources in Nigeria

    by Grażyna Łaska, Ayodeji Raphael Ige

    Nigeria has the potential to generate 12,522 MW of electricity, but can only dispatch 4000 MW, which is insufficient for a population of over 200 million people as of 2022. Therefore, Nigerians use solid fuels including firewood and charcoal as an alternative to insufficient electricity for domestic use. The consumption of firewood and charcoal in Nigeria is estimated at 23,745,458 tons and 4,828,689 tons, respectively in 2021, by far the most consumed domestic solid fuel sources in Nigeria. Although there are domestic solid fuel alternatives, such as dung, agricultural residues and coal, to firewood and wood charcoal, their sustainable adoption has been slow in Nigeria, indicating that there is insufficient knowledge of domestic solid fuel sources. This requires a review focused on assessing Nigeria’s national sources of solid fuels. This article presents an overview of the sources of domestic solid fuels in Nigeria, an exploration of different types of firewood and charcoal studies, the impact of solid fuels on climate change and the environment, health risks associated with solid fuel and biomass briquettes and pellets as domestic solid fuel alternatives to charcoal and firewood. The continued production and use of firewood and wood charcoal as domestic solid fuel sources encourage deforestation, desertification and greenhouse gas emission, which in turn pose a threat to a sustainable environment and good health. It is necessary to limit the felling of trees for firewood and charcoal production to curtail their negative impacts on the health of users and the environment. This review covered the thermal, mechanical and physical properties of briquette and pellet fuels as substitutions for firewood and charcoal. It was shown that employing briquettes and pellets as a source of solid fuel in the home will lessen the negative impacts that these fuels have on users’ health, the climate and the environment.


  • Kinetic and mechanistic study of the biosorption of Copper(II) Ion from wastewater using porous Chitosan-Walnut shell composite

    by Abayomi Bamisaye, Morenike O. Adesina, Moses O. Alfred, Ayodeji Rapheal Ige, Mopelola Abidemi Idowu, Kayode Adesina Adegoke


  • Green synthesis of copper nanoparticles using Musa acuminata aqueous extract and their antibacterial activity

    by Aliyu Muhammad, Ashiru Umar, Abubakar Umar Birnin-Yauri, Hannatu Abubakar Sanni, Cosmos Moki Elinge, Ayodeji Rapheal Ige, Murtala Maidamma Ambursa

    Muhammad A, Umar A, Birnin-Yauri AU, Sanni HA, Elinge CM, Ige AR, Ambursa MM. 2023. Green synthesis of copper nanoparticles using Musa acuminata aqueous extract and their antibacterial activity. Asian J Trop Biotechnol 20: 10-16. Green synthesis is a convenient and affordable alternative to the synthesis of copper nanoparticles. The objective of the present study was to synthesize copper nanoparticles via the green method, using Musa acuminata (banana) fruit extracts as a reducing agent with copper sulfate serving as a precursor. The antibacterial activities of the synthesized CuNps were also tested. Fruits extracts of M. acuminata were used to synthesize with CuSO4(aq) as a precursor. The synthesized nanoparticles were characterized using Uv-Vis, FTIR, XRD, SEM, and EDX techniques. The synthesis results showed that the nanoparticles were of Face-Centered Cubic (FCC) structure with high stability. The average diameter of the synthesized copper nanoparticles is 18nm. Uv-Vis, scanning electron microscope, X-ray diffraction, energy disperses X-ray, and Fourier transforms infrared spectroscopy established that the formed nanoparticles are copper nanoparticles. The antibacterial activity of the synthesized nanoparticles was also tested using pathogenic bacteria Escherichia coli and Staphylococcus aureus. The results showed that copper nanoparticles were promising antibacterial agents.


  • Open Access

    Roles of Biomass in the Absorption of Heavy Metals

    by I. A. Adegoke, A. R. Ige, O. R. Adejoba, D. A. Aruwajoye, J. James

    Mining, plating, dyeing, automobile manufacturing, and metal processing all emit toxic heavy metals into the environment. The environmental challenges, socioeconomic and environmental effects of toxic heavy metals released into the environment cause environmental problems that have exposed our ecosystem to a greater threat, as well as contamination of aquatic water bodies through water runoff, with a subsequent effect on people's health. As a result, research into the roles of biomass as a mitigation process in heavy metal absorption is required. As a result, the purpose of this paper is to investigate the roles of biomass as a medium for heavy metal absorption in contaminated soil. The use of bio-char and other carbonaceous materials such as activated carbon, sawdust, and agricultural residues has shown great potential for the removal of various inorganic and organic pollutants and radionuclides due to properties such as large surface area, micro porous structure, and high adsorption capacity. Pulverized activated charcoal, a promising material based among nano-structured carbon materials, continues to attract a lot of attention due to its unique physical and chemical properties. Lower greenhouse gas emissions and a cleaner environment are two additional environmental benefits of biomass as a renewable energy source. The importance of biomass as a potential natural remediation material cannot be overstated based on the use of biomass waste to treat or resolve anthropogenic environmental problems.


  • Influence of Alkali Pre-Treatment on Properties Of Watermelon Peels Briquettes

    by Abayomi Bamisaye, Ige Ayodeji Rapheal

    Urbanization has significantly increased the rate of waste generation as well mount pressure on the available resources for continual existence of human on planet earth. This therefore necessitated the conversion of agricultural wastes to usable form. This study is aimed to investigate the influence of alkali pre-treatment on briquettes produced from watermelon peels. The macerated starch-bonded watermelon peel (MSWP) and unmacerated starch-bonded watermelon peel (USWP) samples were molded and analyzed. Proximate analysis, FourierTransform Infrared (FTIR) analysis, Scanning electron microscopy (SEM), Calorific values, density and compressive strength, among other properties, were determined for the fabricated briquettes. The recorded calorific values of both MSWP and USWP were 22.43±0.14MJ/Kg and 13.45±0.1 MJ/Kg respectively at p < 0.05. While the volatile matter values were 59.98±0.19 and 67.01±0.32 for MSWP and USWP respectively. It took USWP approximately 15.14 minutes to boil 1000 cm3 of water, while MSWP boiled same quantity of water in 11.219 minutes. Both FTIR and SEM show a morphological restructuring with C-O vibrational stretch of 1037 cm-1 in USWP and at 1019 cm-1 for mercerized MSWP. The finding of this study shows that both the alkali-treated and untreated water melon peel can be used for fuel briquette production. However mercerization improves the combustion property when compared to the untreated briquette samples.


  • Physico-chemical and combustion analyses of bio-briquettes from biochar produced from pyrolysis of groundnut shell

    by Ige Ayodeji Rapheal, Elinge Cosmos Moki, Aliyu Muhammad, Gwani Mohammed, Lawal Gusau Hassan, Abubakar Umar BirninYauri

    The initiative of using biomass as a preference source of energy is vindicated by its availability, abundance, easy accessibility and its eco-friendly nature. This therefore calls for the conversion of agricultural wastes to usable form. This study is aimed to investigate the physicochemical and combustion properties of briquettes obtained from pyrolyzed biochar of groundnut shell. The groundnut shell biochar briquette bonded with cassava starch as binder were molded and analyzed. Proximate analysis, ultimate analyses, Scanning electron microscopy (SEM), Calorific values, density and compressive strength, among other properties, were determined for the fabricated briquettes. A high heating value of 45.20 MJ/Kg was recorded for groundnut shell biochar briquette compared to 25.20 MJ/Kg of raw groundnut shell briquette. While the ash contents of 5.12 % and 6.40 % were recorded for raw groundnut shell briquette and groundnut shell biochar briquette respectively. It took groundnut shell biochar briquette approximately 10 minutes to boil 1000 cm3 of water, while raw groundnut shell briquette boiled same quantity of water in 20 minutes. The finding of this study shows that the biochar obtained from the pyrolysis of groundnut shell is suitable for fuel briquette production. Â


  • Effect of Millet Stalks and Shea Nut Shells on Biogas Production

    by Cosmos Moki Elinge, Ayodeji Rapheal Ige, Morenike O. Adesina, Harrison Ogala, Lawal Gusau Hassan, A.N.L. Mbongo

    Biogas production undergoes decomposition of organic compounds under anaerobic condition. This present work investigated the yield of biogas production from Shea nut shell and millet stalk and their blends with sheep dung. It was revealed that sheep dung (control) had the highest yield with an average production of 187.8 ml of gas for 102 days followed by sheanut shell - sheep dung blends which had 123.3 ml of gas for 102 days. Millet stalk - sheep dung blends recorded 75.9 ml of gas for 79 days. Shea nut shell and millet stalk presented 31.5 ml of gas for 81 days and 7.1 ml of gas for 48 days respectively while the pH for production ranged from 10.1 to 4.6. The moisture contents recorded for millet stalk, Shea nut shell and sheep dung before and after production were 40%, 45%, 65% and 80%, 65%, 85 respectively, and also the recorded ash contents before and after production were, 35%, 45%, 40% and 85%, 75%, 65%, respectively. It was observed that the blending of Shea nut shell and sheep dung greatly improves biogas yield while Millet stalks alone are good material for biogas production at a reasonable pH and moisture content values.

  • Open Access

    Optimization and Characterization of Bio-oil Produced from Rice Husk Using Surface Response Methodology

    by Ige Ayodeji Rapheal, Elinge Cosmos Moki, Aliyu Muhammad, Gwani Mohammed, Lawal Hassan Gusauc

    The study depicts the production, optimization and characterization of bio-oil from pyrolyzed rice husk using a fabricated fixed bed reactor. The pyrolysis process was conducted with bio-oil response, bio-char response and non-condensable gases response as products. The effect of pyrolysis variables were observed by the production of the bio-oil as the response. Sixty runs of pyrolysis experiments were suggested by Box Benkhen design indicated optimum pyrolysis conditions at particle size of 2.03mm mesh, reaction time of 81.80 mins and temperature of 650oC for rice husk. The maximum bio-oil yield was obtained with 38.39% at optimum condition of the variables. The bio-oil sample obtained had better performance compared with ASTM standard. Such a determination would contribute so immensely to a significant comprehension of the chemical efficiency of the pyrolysis reaction.


  • Biogas production from blends of fonio husk and donkey dung via anaerobic digestion for sustainable development

    by Ogala Harrison, Ige Ayodeji Rapheal

    There is growing public concern over potential impact on environmental quality caused by animal wastes. Anaerobic digestion, a biological conversion process can be used to obtain energy from biologicall wastes. This study explored the production of biogas from co-digestion of fonio hus and donkey dung using anaerobic biological conversion. The digesters were labeled as; digester A –Fonio husk only, digester B - donkey dung only, digester C – Fonio husk (300g) and Donkey Dung (200g), digester D – Fonio husk (200g) and donkey dung (300g). Proximate analysis of the substrates before and after digestion were determined such as total solids (TS), volatile solid, carbon content, nitrogen content, ash content, etc., and pH before and after digestion process. The biogas produced during this period was collected by water displacement method and subsequently measured. The results showed that Fonio husk in bio-digesters A and B gave a cumulative average biogas volume of 4972 ml and 5222 ml (week 3) while pig dung in bio-digesters C and D gave a cumulative average biogas volume of 5564 ml and 5978 respectively (week 3) within three weeks of fermentation. The digester is capable of producing 0.007m at average working temperature of 320C. Digester D produces higher volume of biogas as a result of improved nutrient provide by donkey dung as shown in the results obtained from the proximate analysis and has the best neutral pH, there was a reduction in the startup time. Â