Yongkang Zheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yongkang Zheng has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Hanxin Zhang
China Aerodynam Res & Dev Ctr, Mianyang 621000, Sichuan, Peoples R China
1 shared publicationHao Tian
China Aerodynam Res & Dev Ctr, Mianyang 621000, Sichuan, Peoples R China
1 shared publication- Hao Tian
China Aerodynamics Research and Development Center, Mianyang 621000, China
1 shared publication - Jingying Wang
School of Nuclear Science, Energy and Power Engineering, Shandong University
1 shared publication - Shuang Wang
China Aerodynamics Research and Development Center, Mianyang 621000, China
1 shared publication - Wei Zhao
School of Nuclear, Energy and Power Engineering, Shandong University, Jinan 250061, China
1 shared publication
Latest Publications
- Open Access
Improvement in Efficiency of Blunt Cone Drag and Heat Reduction by Combination of Aerospike and Partition Jets
To mitigate the severe aerodynamic and thermal loads on high-speed vehicles, a combined control approach employing an aerospike and a partition jet system is investigated. The influence of jet position on flow field behavior, drag reduction and thermal load management is examined. Using the SST k-ω turbulence model integrated into a finite-volume framework, the study conducts numerical simulations by solving the three-dimensional Reynolds-averaged Navier–Stokes equations at a flight altitude of 30 km and Mach 5. Considering that the reverse force generated by the top and bottom jets would cause an increase in drag along the direction of motion, the lateral jet contributes more significantly to the drag reduction. The combination of the aerospike and multi-zone jets performs better in terms of drag reduction and thermal protection than single-zone jet strategies. Among them, the scheme with simultaneous jets at three positions has the highest drag reduction efficiency, up to 230%, but it requires the most working medium. Through the comprehensive analysis of the heat and drag reduction efficiency, the lateral jet is the optimal configuration.
Open AccessImprovement in Efficiency of Blunt Cone Drag and Heat Reduction by Combination of Aerospike and Partition Jets
To mitigate the severe aerodynamic and thermal loads on high-speed vehicles, a combined control approach employing an aerospike and a partition jet system is investigated. The influence of jet position on flow field behavior, drag reduction and thermal load management is examined. Using the SST k-ω turbulence model integrated into a finite-volume framework, the study conducts numerical simulations by solving the three-dimensional Reynolds-averaged Navier–Stokes equations at a flight altitude of 30 km and Mach 5. Considering that the reverse force generated by the top and bottom jets would cause an increase in drag along the direction of motion, the lateral jet contributes more significantly to the drag reduction. The combination of the aerospike and multi-zone jets performs better in terms of drag reduction and thermal protection than single-zone jet strategies. Among them, the scheme with simultaneous jets at three positions has the highest drag reduction efficiency, up to 230%, but it requires the most working medium. Through the comprehensive analysis of the heat and drag reduction efficiency, the lateral jet is the optimal configuration.
- Open Access
- 4 September 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (17) , 9991
Evaluation of Thermodynamic and Chemical Kinetic Models for Hypersonic and High-Temperature Flow Simulation
Significant thermochemical nonequilibrium effects always exist in the flow field around hypersonic vehicle at extreme flight condition. Previous studies have proposed various thermodynamic and chemical kinetic models to describe the thermochemical nonequilibrium processes in hypersonic and high-temperature flow. However, different selections from such models might lead to remarkable variations in computational burden and prediction accuracy, which is still a matter of being unclear. In the present study, different commonly studied models for calculating the thermochemical nonequilibrium are systematically evaluated. The 5-, 7- and 11-species chemical kinetic models of Dunn-Kang, Gupta and Park together with the one- and two-temperature models are employed respectively to simulate the hypersonic flows over a standard cylinder with the radius of 1 m by HyFLOW, which is a commercial software based on the numerical solution of Navier-Stokes equations. Three flight conditions of FIRE Ⅱ classical flight trajectory are employed in the study. It shows that the differences between the results of the Dunn-Kang, Gupta and Park chemical kinetic models with the same number of species are small, but the Gupta model predicts the most conservative values of the wall heat flux. When only the order of magnitude and distribution trends of the pressure and wall heat flux are concerned, the one-temperature model combined with 5-species chemical reaction model can be used for a rapid prediction. While the accurate flow solution is required, the two-temperature model conjugated with Gupta 11-species model is recommended, especially at the conditions of extremely high altitude and Mach number.
- 4 September 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (17) , 9991
Open AccessEvaluation of Thermodynamic and Chemical Kinetic Models for Hypersonic and High-Temperature Flow Simulation
Significant thermochemical nonequilibrium effects always exist in the flow field around hypersonic vehicle at extreme flight condition. Previous studies have proposed various thermodynamic and chemical kinetic models to describe the thermochemical nonequilibrium processes in hypersonic and high-temperature flow. However, different selections from such models might lead to remarkable variations in computational burden and prediction accuracy, which is still a matter of being unclear. In the present study, different commonly studied models for calculating the thermochemical nonequilibrium are systematically evaluated. The 5-, 7- and 11-species chemical kinetic models of Dunn-Kang, Gupta and Park together with the one- and two-temperature models are employed respectively to simulate the hypersonic flows over a standard cylinder with the radius of 1 m by HyFLOW, which is a commercial software based on the numerical solution of Navier-Stokes equations. Three flight conditions of FIRE Ⅱ classical flight trajectory are employed in the study. It shows that the differences between the results of the Dunn-Kang, Gupta and Park chemical kinetic models with the same number of species are small, but the Gupta model predicts the most conservative values of the wall heat flux. When only the order of magnitude and distribution trends of the pressure and wall heat flux are concerned, the one-temperature model combined with 5-species chemical reaction model can be used for a rapid prediction. While the accurate flow solution is required, the two-temperature model conjugated with Gupta 11-species model is recommended, especially at the conditions of extremely high altitude and Mach number.
- Open Access
- 1 January 2023
- Published by Tech Science Press in Fluid Dynamics & Materials Processing
- Vol. 19 (1) , 207-222
A Numerical Study on Supersonic Combustion Optimization Based on the Streamwise Vortex-Couple Method
In this paper, some typical methods to promote mixing in supersonic combustion are reviewed, and the fluid-dynamic mechanism underpinning the development of the supersonic shear layer in the presence of a streamwise vortex is analyzed through computational fluid dynamics. It is proven that the streamwise vortex-couple method is an excellent approach to enhance mixing. A specific combustor design is proposed accordingly.
- 1 January 2023
- Published by Tech Science Press in Fluid Dynamics & Materials Processing
- Vol. 19 (1) , 207-222
Open AccessA Numerical Study on Supersonic Combustion Optimization Based on the Streamwise Vortex-Couple Method
In this paper, some typical methods to promote mixing in supersonic combustion are reviewed, and the fluid-dynamic mechanism underpinning the development of the supersonic shear layer in the presence of a streamwise vortex is analyzed through computational fluid dynamics. It is proven that the streamwise vortex-couple method is an excellent approach to enhance mixing. A specific combustor design is proposed accordingly.