Kiattiwut Prasertsuk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kiattiwut Prasertsuk has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Chayut Thanapirom
National Electronics and Computer Technology Center, 112 Thailand Science Park, Pathum Thani 12120, Thailand
3 shared publicationsChia Jia Yi
National Electronics and Computer Technology Center, Pathum Thani, Thailand
2 shared publications- Jia Yi Chia
School of Integrated Science and Innovation (ISI), Sirindhorn International Institute of Technology
2 shared publications - Rungroj Jintamethasawat
National Electronics and Computer Technology Center, Pathum Thani, Thailand
2 shared publications - Sopanant Datta
Science Division, Mahidol University International College, Mahidol University, Salaya, Phutthamonthon, Nakhon Pathom 73170, Thailand
2 shared publications - Taweetham Limpanuparb
Science Division, Mahidol University International College Mahidol University Salaya 73170 Thailand
2 shared publications
Latest Publications
- Open Access
- 27 September 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (40) , 35783-35791
Chemometric Analysis of a Ternary Mixture of Caffeine, Quinic Acid, and Nicotinic Acid by Terahertz Spectroscopy
- 27 September 2022
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (40) , 35783-35791
Open AccessChemometric Analysis of a Ternary Mixture of Caffeine, Quinic Acid, and Nicotinic Acid by Terahertz Spectroscopy
- Open Access
Terahertz Spectroscopic Analysis of Lactose in Infant Formula: Implications for Detection and Quantification
Lactose plays a significant role in daily lives as a constituent of various food and pharmaceutical products. Yet, lactose intolerance conditions demand low-lactose and lactose-free products in the market. These increasing nutritional claims and labels on food products entail simple and reliable methods of analysis that can be used for meeting quality standards, nutritional claims and legal requirements. In this study, terahertz time–domain spectroscopy (THz-TDS) was employed to analyse α-lactose monohydrate qualitatively and quantitatively in food products. Both absorption spectra and absorption coefficient spectra were investigated for their prediction performance. Regression models for lactose quantification using peak area and height of the absorption peaks 0.53 and 1.37 THz were developed and assessed in infant formula samples. Satisfactory prediction results were achieved in ideal conditions with pure standards, but not in all predictions of infant formula samples. Reasons and further implications are discussed.
Open AccessTerahertz Spectroscopic Analysis of Lactose in Infant Formula: Implications for Detection and Quantification
Lactose plays a significant role in daily lives as a constituent of various food and pharmaceutical products. Yet, lactose intolerance conditions demand low-lactose and lactose-free products in the market. These increasing nutritional claims and labels on food products entail simple and reliable methods of analysis that can be used for meeting quality standards, nutritional claims and legal requirements. In this study, terahertz time–domain spectroscopy (THz-TDS) was employed to analyse α-lactose monohydrate qualitatively and quantitatively in food products. Both absorption spectra and absorption coefficient spectra were investigated for their prediction performance. Regression models for lactose quantification using peak area and height of the absorption peaks 0.53 and 1.37 THz were developed and assessed in infant formula samples. Satisfactory prediction results were achieved in ideal conditions with pure standards, but not in all predictions of infant formula samples. Reasons and further implications are discussed.
- Open Access
- 15 December 2021
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 61 (SA) , SA1006
Reverse bias annealing effects in N-polar GaN/AlGaN metal-insulator-semiconductor high electron mobility transistors
Reverse bias annealing (RBA) is applied to N-polar GaN high electron mobility transistors (HEMTs) to improve the quality of the gate stack interface. As demonstrated for Ga-polar HEMTs, RBA improves the stability of the gate stack interface. However, the decrease in the maximum drain current density is observed as a unique phenomenon for the N-polar HEMTs. The calculation of the band profile suggests that in the N-polar HEMTs the electrons injected from the gate electrode by the reverse bias accumulate at the gate stack interface in the extrinsic gate region. This promotes the electron trapping in the gate stack, which results in an increase in the source access resistance by the virtual gate phenomenon. In the Ga-polar HEMTs, the electrons tend to accumulate at the AlGaN/GaN interface rather than the gate stack interface, which gives less chance of the virtual gate phenomenon.
- 15 December 2021
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 61 (SA) , SA1006
Open AccessReverse bias annealing effects in N-polar GaN/AlGaN metal-insulator-semiconductor high electron mobility transistors
Reverse bias annealing (RBA) is applied to N-polar GaN high electron mobility transistors (HEMTs) to improve the quality of the gate stack interface. As demonstrated for Ga-polar HEMTs, RBA improves the stability of the gate stack interface. However, the decrease in the maximum drain current density is observed as a unique phenomenon for the N-polar HEMTs. The calculation of the band profile suggests that in the N-polar HEMTs the electrons injected from the gate electrode by the reverse bias accumulate at the gate stack interface in the extrinsic gate region. This promotes the electron trapping in the gate stack, which results in an increase in the source access resistance by the virtual gate phenomenon. In the Ga-polar HEMTs, the electrons tend to accumulate at the AlGaN/GaN interface rather than the gate stack interface, which gives less chance of the virtual gate phenomenon.
- 8 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
An ADAM Optimization for Water-Vapor Effect Removal in THz-TDS Data
An ADAM optimization method, implemented using the Theano framework, for water-vapor effect removal from THz-TDS (terahertz time-domain spectroscopy) data is proposed. The cost function is derived from the ratio between the energy in the main THz pulse and the oscillation after the pulse as in [1]. A quantitative experimental validation of the method is performed. For free space measurement, the cost function is 0.018 in a sealed N2 environment, 0.043 in an open environment and 0.020 for the open environment data after applying the method. In addition, a qualitative improvement of D-(-)-Quinic acid's THz absorbance measurement in an open environment, where atmospheric humidity exists, is demonstrated. The cross-correlation between the D-(-)-Quinic acid's absorbance spectrum measured in a sealed N2 environment and one measured in an open environment increases from 0.044 to 0.62 after the water-vapor effect removal method is applied.
- 8 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
An ADAM Optimization for Water-Vapor Effect Removal in THz-TDS Data
An ADAM optimization method, implemented using the Theano framework, for water-vapor effect removal from THz-TDS (terahertz time-domain spectroscopy) data is proposed. The cost function is derived from the ratio between the energy in the main THz pulse and the oscillation after the pulse as in [1]. A quantitative experimental validation of the method is performed. For free space measurement, the cost function is 0.018 in a sealed N2 environment, 0.043 in an open environment and 0.020 for the open environment data after applying the method. In addition, a qualitative improvement of D-(-)-Quinic acid's THz absorbance measurement in an open environment, where atmospheric humidity exists, is demonstrated. The cross-correlation between the D-(-)-Quinic acid's absorbance spectrum measured in a sealed N2 environment and one measured in an open environment increases from 0.044 to 0.62 after the water-vapor effect removal method is applied.
- Open Access
- 16 January 2020
- Published by Wiley in International Journal of Optics
- Vol. 2020, 1-8
The Simulation of a Surface Plasmon Resonance Metallic Grating for Maximizing THz Sensitivity in Refractive Index Sensor Application
Nowadays, the simplicity of both designing and fabrication process of a terahertz (THz) resonator-based sensing technique leads to its ongoing development. The consumable THz resonator needs to be easily integrated into an existing terahertz time domain spectroscopy (THz TDS) measurement system. It should also be able to be fabricated in a mass scale with a low production cost. In this work, a metal-coated surface plasmon resonance- (SPR-) based sensor is simulated and designed as a low-cost refractive index sensor utilizing rigorous coupled wave analysis (RCWA). To demonstrate our methodology, we design a gold-coated grating with a polydimethylsiloxane (PDMS) as a substrate, in order to perform quantitative analysis of gasoline-toluene mixture composition, which has a refraction index variation of 0.1 at THz frequency. The grating period is tuned such that its surface plasmon resonance (SPR) frequency matches with the peak frequency of the THz TDS system. Moreover, other grating parameters, i.e., a filling factor and a grating depth, are optimized to increase the sensor sensitivity and sharpen the resonance dip. High sensitivity up to 500 GHz/RIU with a refractive index resolution up to 0.01 is numerically revealed. The H-field of the designed grating is then evaluated to indicate a strong SPR excitation. The well-developed designed grating introduces a promising, low-cost, and easily fabricated THz refractive index sensor.
- 16 January 2020
- Published by Wiley in International Journal of Optics
- Vol. 2020, 1-8
Open AccessThe Simulation of a Surface Plasmon Resonance Metallic Grating for Maximizing THz Sensitivity in Refractive Index Sensor Application
Nowadays, the simplicity of both designing and fabrication process of a terahertz (THz) resonator-based sensing technique leads to its ongoing development. The consumable THz resonator needs to be easily integrated into an existing terahertz time domain spectroscopy (THz TDS) measurement system. It should also be able to be fabricated in a mass scale with a low production cost. In this work, a metal-coated surface plasmon resonance- (SPR-) based sensor is simulated and designed as a low-cost refractive index sensor utilizing rigorous coupled wave analysis (RCWA). To demonstrate our methodology, we design a gold-coated grating with a polydimethylsiloxane (PDMS) as a substrate, in order to perform quantitative analysis of gasoline-toluene mixture composition, which has a refraction index variation of 0.1 at THz frequency. The grating period is tuned such that its surface plasmon resonance (SPR) frequency matches with the peak frequency of the THz TDS system. Moreover, other grating parameters, i.e., a filling factor and a grating depth, are optimized to increase the sensor sensitivity and sharpen the resonance dip. High sensitivity up to 500 GHz/RIU with a refractive index resolution up to 0.01 is numerically revealed. The H-field of the designed grating is then evaluated to indicate a strong SPR excitation. The well-developed designed grating introduces a promising, low-cost, and easily fabricated THz refractive index sensor.