Barsheek Roy
Barsheek Roy has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Thorsten Gerdes
Keylab Glass Technology University of Bayreuth Bayreuth Germany
3 shared publicationsAndreas Rosin
Keylab Glass Technology, Chair of Ceramic Materials Engineering, University of Bayreuth, Bayreuth, Germany
2 shared publicationsStefan Schafföner
Keylab Glass Technology, Chair of Ceramic Materials Engineering, University of Bayreuth, Bayreuth, Germany
2 shared publications- Andreas Rosin
Keylab Glass Technology University of Bayreuth Department of Engineering Science Bayreuth Germany
1 shared publication Felix Baier
Experimental Physics XI University of Bayreuth Bayreuth Germany
1 shared publication- Stefan Schafföner
Chair of Ceramic Materials Engineering University of Bayreuth Bayreuth Germany
1 shared publication
Latest Publications
- Open Access
- 24 August 2022
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 14 (2) , 229-239
Structural characterization of the near‐surface region of soda–lime–silica glass by X‐ray photoelectron spectroscopy
The structural chemistry of the near‐surface region of soda–lime–silica (SLS) glass is described in terms of silicate network connectivity using X‐ray photoelectron spectroscopy (XPS). A thorough investigation of O1s and Si2p spectral lines by sequential XPS measurements, accompanied by Ar + sputtering, revealed the variation of concentration of bridging oxygen, non‐bridging oxygen (NBO), and hydrous species (SiOH/H 2 O) as a function of depth from the glass surface. The O total /Si atomic ratio was calculated to vary in the range of 2.90–3.74 throughout the depth of sputtering for a total duration of 110 min, while considering each of the aforementioned oxygen speciations in the curve‐fitted spectra of O1s orbital. The glass surface up to a depth of 1–3 nm had the highest O total /Si ratio of 3.74, which was representative for a mechanically weak structure with Q 0 and Q 1 species, marked by the respective linkages of four and three NBOs per silica tetrahedral unit. This dictates the vital contribution of the hydrous species associated with silanol groups to the near‐surface structure of SLS glass.
- 24 August 2022
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 14 (2) , 229-239
Open AccessStructural characterization of the near‐surface region of soda–lime–silica glass by X‐ray photoelectron spectroscopy
The structural chemistry of the near‐surface region of soda–lime–silica (SLS) glass is described in terms of silicate network connectivity using X‐ray photoelectron spectroscopy (XPS). A thorough investigation of O1s and Si2p spectral lines by sequential XPS measurements, accompanied by Ar + sputtering, revealed the variation of concentration of bridging oxygen, non‐bridging oxygen (NBO), and hydrous species (SiOH/H 2 O) as a function of depth from the glass surface. The O total /Si atomic ratio was calculated to vary in the range of 2.90–3.74 throughout the depth of sputtering for a total duration of 110 min, while considering each of the aforementioned oxygen speciations in the curve‐fitted spectra of O1s orbital. The glass surface up to a depth of 1–3 nm had the highest O total /Si ratio of 3.74, which was representative for a mechanically weak structure with Q 0 and Q 1 species, marked by the respective linkages of four and three NBOs per silica tetrahedral unit. This dictates the vital contribution of the hydrous species associated with silanol groups to the near‐surface structure of SLS glass.
- Open Access
- 17 February 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-13
Revealing the surface structural cause of scratch formation on soda-lime-silica glass
Scratch formation on glass surfaces is a ubiquitous phenomenon induced by plastic deformation, often accompanied by radial, lateral or median cracks with consequent chipping and brittle fracture caused during and after the event of dynamic abrasion instigated by shear stress by a harder material. This paper addresses the fundamental aspect of scratch formation on soda-lime-silica (SLS) glass surfaces. A constructive combination of surface-sensitive characterization tools, including field emission scanning electron microscopy (FESEM), laser scanning microscopy (LSM), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy and instrumented indentation technique (IIT), helped to investigate the structural cause of generation of visible scratches on SLS glass surfaces. The experimental results indicate that a silicate network possessing a mechanically weakening structural characteristic in terms of network connectivity confined to the region between 5 and 100 nm below the glass surface is likely to cause a destructive surface scratch eminently visible to the naked eye.
- 17 February 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-13
Open AccessRevealing the surface structural cause of scratch formation on soda-lime-silica glass
Scratch formation on glass surfaces is a ubiquitous phenomenon induced by plastic deformation, often accompanied by radial, lateral or median cracks with consequent chipping and brittle fracture caused during and after the event of dynamic abrasion instigated by shear stress by a harder material. This paper addresses the fundamental aspect of scratch formation on soda-lime-silica (SLS) glass surfaces. A constructive combination of surface-sensitive characterization tools, including field emission scanning electron microscopy (FESEM), laser scanning microscopy (LSM), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy and instrumented indentation technique (IIT), helped to investigate the structural cause of generation of visible scratches on SLS glass surfaces. The experimental results indicate that a silicate network possessing a mechanically weakening structural characteristic in terms of network connectivity confined to the region between 5 and 100 nm below the glass surface is likely to cause a destructive surface scratch eminently visible to the naked eye.
- Open Access
- 28 September 2021
- Published by Springer Nature in Research Square
Revealing the scientific root of scratch formation on soda-lime-silica glass surface: Digging deeper into structural modification of glass surface
Scratch formation on glass surfaces is a ubiquitous phenomenon induced by the virtue of plastic deformation, often accompanied by radial, lateral or median cracks with consequent chipping and brittle fracture caused during and after the event of dynamic abrasion instigated by shear stress by another harder material. This paper deals with the fundamental aspect of scratch formation on soda-lime-silica (SLS) glass surfaces. A constructive combination of surface-sensitive characterization tools including field emission scanning electron microscopy (FESEM), laser scanning microscopy (LSM), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy and instrumented indentation technique (IIT), helped to investigate the structural cause of generation of visible scratches on SLS glass surfaces. The experimental evidences propose that a silicate network possessing a mechanically-weakening structural characteristic in terms of network connectivity confined to the region between 5 nm and 100 nm below the glass surface, is likely to cause a destructive surface scratch eminently visible to naked eyes.
- 28 September 2021
- Published by Springer Nature in Research Square
Open AccessRevealing the scientific root of scratch formation on soda-lime-silica glass surface: Digging deeper into structural modification of glass surface
Scratch formation on glass surfaces is a ubiquitous phenomenon induced by the virtue of plastic deformation, often accompanied by radial, lateral or median cracks with consequent chipping and brittle fracture caused during and after the event of dynamic abrasion instigated by shear stress by another harder material. This paper deals with the fundamental aspect of scratch formation on soda-lime-silica (SLS) glass surfaces. A constructive combination of surface-sensitive characterization tools including field emission scanning electron microscopy (FESEM), laser scanning microscopy (LSM), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy and instrumented indentation technique (IIT), helped to investigate the structural cause of generation of visible scratches on SLS glass surfaces. The experimental evidences propose that a silicate network possessing a mechanically-weakening structural characteristic in terms of network connectivity confined to the region between 5 nm and 100 nm below the glass surface, is likely to cause a destructive surface scratch eminently visible to naked eyes.