Mustafa Atabey Buyukkaya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mustafa Atabey Buyukkaya has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Edo Waks
Institute for Research in Electronics and Applied Physics and Joint Quantum Institute University of Maryland 20742 College Park Maryland USA
4 shared publications Ahmad Mansoori
Center for High Technology Materials, University of New Mexico 2 , Albuquerque, New Mexico 87106, USA
2 shared publicationsChang-Min Lee
Department of Electrical and Computer Engineering and Institute for Research in Electronics and Applied Physics, University of Maryland 1 , College Park, Maryland 20742, USA
2 shared publications- Ganesh Balakrishnan
Center for High Technology Materials, University of New Mexico 2 , Albuquerque, New Mexico 87106
2 shared publications - Samuel Harper
Department of Electrical and Computer Engineering, University of Maryland 1 , College Park, Maryland 20742, USA
2 shared publications - Chang-Min Lee
Department of Electrical and Computer Engineering and Institute for Research in Electronics and Applied Physics, University of Maryland, College Park, Maryland 20742, USA
1 shared publication
Latest Publications
- Open Access
- 29 April 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (18)
Optimizing the quality factor of InP nanobeam cavities using atomic layer deposition
Photonic crystal nanobeam cavities are valued for their small mode volume, CMOS compatibility, and high coupling efficiency-crucial features for various low-power photonic applications and quantum information processing. However, despite their potential, nanobeam cavities often suffer from low quality factors due to fabrication imperfections that create surface states and optical absorption. In this work, we demonstrate InP nanobeam cavities with up to 140% higher quality factors by applying a coating of Al2O3 via atomic layer deposition to terminate dangling bonds and reduce surface absorption. Additionally, changing the deposition thickness allows precise tuning of the cavity mode wavelength without compromising the quality factor. This Al2O3 atomic layer deposition approach holds great promise for optimizing nanobeam cavities that are well-suited for integration with a wide range of photonic applications.
- 29 April 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 124 (18)
Open AccessOptimizing the quality factor of InP nanobeam cavities using atomic layer deposition
Photonic crystal nanobeam cavities are valued for their small mode volume, CMOS compatibility, and high coupling efficiency-crucial features for various low-power photonic applications and quantum information processing. However, despite their potential, nanobeam cavities often suffer from low quality factors due to fabrication imperfections that create surface states and optical absorption. In this work, we demonstrate InP nanobeam cavities with up to 140% higher quality factors by applying a coating of Al2O3 via atomic layer deposition to terminate dangling bonds and reduce surface absorption. Additionally, changing the deposition thickness allows precise tuning of the cavity mode wavelength without compromising the quality factor. This Al2O3 atomic layer deposition approach holds great promise for optimizing nanobeam cavities that are well-suited for integration with a wide range of photonic applications.
- Open Access
- 22 August 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (8)
Low power optical bistability from quantum dots in a nanobeam photonic crystal cavity
We demonstrate a low power thermally induced optical bistability at telecom wavelengths and room temperature using a nanobeam photonic crystal cavity embedded with an ensemble of quantum dots. The nanobeam photonic crystal cavity is transfer-printed onto the edge of a carrier chip for thermal isolation of the cavity with an efficient optical coupling between the nanobeam waveguide and optical setup. Reflectivity measurements performed with a tunable laser reveal the thermo-optic nature of the nonlinearity. A bistability power threshold as low as 23 μW and an on/off response contrast of 6.02 dB are achieved from a cavity with a moderately low quality factor of 2830. Our device provides optical bistability at power levels an order of magnitude lower than previous quantum-dot-based devices.
- 22 August 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 121 (8)
Open AccessLow power optical bistability from quantum dots in a nanobeam photonic crystal cavity
We demonstrate a low power thermally induced optical bistability at telecom wavelengths and room temperature using a nanobeam photonic crystal cavity embedded with an ensemble of quantum dots. The nanobeam photonic crystal cavity is transfer-printed onto the edge of a carrier chip for thermal isolation of the cavity with an efficient optical coupling between the nanobeam waveguide and optical setup. Reflectivity measurements performed with a tunable laser reveal the thermo-optic nature of the nonlinearity. A bistability power threshold as low as 23 μW and an on/off response contrast of 6.02 dB are achieved from a cavity with a moderately low quality factor of 2830. Our device provides optical bistability at power levels an order of magnitude lower than previous quantum-dot-based devices.
- 1 January 2022
- Published by Optica Publishing Group
- p. JTu3B.40
All-Optical Bistability from Quantum Dots in a Photonic Crystal Cavity
We experimentally demonstrate room temperature all-optical bistability at telecom wavelengths using a nanobeam photonic crystal cavity embedded with an ensemble of quantum dots. Reflectivity measurements are performed to confirm the thermo-optic nature of the bistability.
- 1 January 2022
- Published by Optica Publishing Group
- p. JTu3B.40
All-Optical Bistability from Quantum Dots in a Photonic Crystal Cavity
We experimentally demonstrate room temperature all-optical bistability at telecom wavelengths using a nanobeam photonic crystal cavity embedded with an ensemble of quantum dots. Reflectivity measurements are performed to confirm the thermo-optic nature of the bistability.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 8, FF2J.5
Telecom-Wavelength Bright Single Photon Sources with Post-Selected Indistinguishability
We demonstrate a bright telecom-wavelength single photon source based on a tapered nanobeam containing InAs/InP quantum dots. We obtain a first-lens brightness of 21.0% and a post-selected Hong-Ou-Mandel visibility of 0.91 in the telecom O-band.
- 1 January 2022
- Published by Optica Publishing Group
- Vol. 8, FF2J.5
Telecom-Wavelength Bright Single Photon Sources with Post-Selected Indistinguishability
We demonstrate a bright telecom-wavelength single photon source based on a tapered nanobeam containing InAs/InP quantum dots. We obtain a first-lens brightness of 21.0% and a post-selected Hong-Ou-Mandel visibility of 0.91 in the telecom O-band.