Beiping Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Beiping Zhou has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Jie Zhou
School of Electronic and Information Engineering, Nanjing University of Information Science and Technology, Nanjing 210044, China
2 shared publications - Yongfeng Zhao
Qingdao West Coast Geomatics Center, Qingdao 266055, China
2 shared publications - Beiping Zhou
Nanjing Univ Informat Sci & Technol, Sch Atmosphere Sci, Nanjing 210044, Peoples R China
1 shared publication - Chen Yang
Nanjing University of Information Science and Technology, Nanjing, China
1 shared publication - Gandong Xu
College of Changwang, Nanjing University of Information Science and Technology, Nanjing 210044, China
1 shared publication - Keqi Zhao
Piesat Information Technology Co., Ltd., Beijing, China
1 shared publication
Latest Publications
- Open Access
- 6 July 2026
- Published by MDPI AG in Electronics
- Vol. 15 (13) , 2952
Geo-Temporal EM-AMP for CSI Acquisition in FAS-Assisted Grant-Free Random Access with a Mobile Receiver
Receiver mobility complicates channel state information (CSI) acquisition in fluid antenna system (FAS)-assisted grant-free random access (GFRA), because user activity and multi-port channels evolve across pilot frames. Existing FAS acquisition methods are mainly frame-wise, while temporal recovery schemes do not directly combine receiver geometry with Doppler information. This article proposes geo-temporal expectation-maximization approximate message passing (GT-EM-AMP), which transfers posterior information between frames and refines the channel prior using receiver trajectory, effective Doppler, and coarse geometry. The proposed recursion preserves the low-complexity structure of EM-AMP while introducing only limited additional state updates. Simulations over an SNR range from to 8 dB show that GT-EM-AMP achieves lower channel-estimation error and a favorable activity-detection tradeoff relative to static, temporal-only, geometry-only, and greedy baselines. Ablation, robustness, mobility, scalability, and statistical evaluations characterize the operating range of GT-EM-AMP and show that its activity-detection advantage depends on the SNR regime. GT-EM-AMP introduces modest runtime and memory overhead relative to static EM-AMP. The evaluation focuses on short acquisition windows with coarse geometry information under a Jakes-type temporal model.- 6 July 2026
- Published by MDPI AG in Electronics
- Vol. 15 (13) , 2952
Open AccessGeo-Temporal EM-AMP for CSI Acquisition in FAS-Assisted Grant-Free Random Access with a Mobile Receiver
Receiver mobility complicates channel state information (CSI) acquisition in fluid antenna system (FAS)-assisted grant-free random access (GFRA), because user activity and multi-port channels evolve across pilot frames. Existing FAS acquisition methods are mainly frame-wise, while temporal recovery schemes do not directly combine receiver geometry with Doppler information. This article proposes geo-temporal expectation-maximization approximate message passing (GT-EM-AMP), which transfers posterior information between frames and refines the channel prior using receiver trajectory, effective Doppler, and coarse geometry. The proposed recursion preserves the low-complexity structure of EM-AMP while introducing only limited additional state updates. Simulations over an SNR range from to 8 dB show that GT-EM-AMP achieves lower channel-estimation error and a favorable activity-detection tradeoff relative to static, temporal-only, geometry-only, and greedy baselines. Ablation, robustness, mobility, scalability, and statistical evaluations characterize the operating range of GT-EM-AMP and show that its activity-detection advantage depends on the SNR regime. GT-EM-AMP introduces modest runtime and memory overhead relative to static EM-AMP. The evaluation focuses on short acquisition windows with coarse geometry information under a Jakes-type temporal model. - Open Access
- 11 July 2025
- Published by MDPI AG in Electronics
- Vol. 14 (14) , 2804
Modeling and Analysis of Vehicle-to-Vehicle Fluid Antenna Communication Systems Aided by RIS
As communication technologies continue to evolve, Reconfigurable Intelligent Surfaces (RISs) have become a crucial and highly potential technology for sixth-generation (6G) mobile communication systems. Their key competitive advantages lie in their cost-effectiveness, minimal power consumption, and simple deployment. To address the limitations of current communication paradigms, this study innovatively integrates RIS technology into vehicle-to-vehicle (V2V) communication systems. Current methodologies fail to comprehensively elucidate the transmission principles underlying RIS-assisted V2V fluid antenna system (FAS) communications. The current channel characteristic analysis techniques and modeling theories struggle to achieve a balance between computational accuracy and computational complexity. To overcome these problems, this study systematically constructed a multipath sub-channel model in RIS-assisted V2V communication. Combining detailed simulation with theoretical analysis, a reliable parametric channel statistical model was established. This progress successfully overcame the main obstacle of the traditional RIS channel modeling method, which was unable to coordinate accuracy and efficiency.
- 11 July 2025
- Published by MDPI AG in Electronics
- Vol. 14 (14) , 2804
Open AccessModeling and Analysis of Vehicle-to-Vehicle Fluid Antenna Communication Systems Aided by RIS
As communication technologies continue to evolve, Reconfigurable Intelligent Surfaces (RISs) have become a crucial and highly potential technology for sixth-generation (6G) mobile communication systems. Their key competitive advantages lie in their cost-effectiveness, minimal power consumption, and simple deployment. To address the limitations of current communication paradigms, this study innovatively integrates RIS technology into vehicle-to-vehicle (V2V) communication systems. Current methodologies fail to comprehensively elucidate the transmission principles underlying RIS-assisted V2V fluid antenna system (FAS) communications. The current channel characteristic analysis techniques and modeling theories struggle to achieve a balance between computational accuracy and computational complexity. To overcome these problems, this study systematically constructed a multipath sub-channel model in RIS-assisted V2V communication. Combining detailed simulation with theoretical analysis, a reliable parametric channel statistical model was established. This progress successfully overcame the main obstacle of the traditional RIS channel modeling method, which was unable to coordinate accuracy and efficiency.
- Open Access
- 8 July 2025
- Published by MDPI AG in Electronics
- Vol. 14 (14) , 2750
Low-Complexity Sum-Rate Maximization for Multi-IRS-Assisted V2I Systems
Intelligent reflecting surface (IRS) has emerged as a promising solution to establish propagation paths in non-line-of-sight (NLoS) scenarios, effectively mitigating blockage challenges in direct vehicle-to-infrastructure (V2I) links. This study investigates a time-varying multi-IRS-assisted multiple-input multiple-output (MIMO) communication system, aiming to maximize the system sum rate through the joint optimization of base station (BS) precoding and IRS phase configurations. The formulated problem exhibits inherent non-convexity and time-varying characteristics, posing significant optimization challenges. To address these, we propose a low-complexity dimension-wise sine maximization (DSM) algorithm, grounded in the sum path gain maximization (SPGM) criterion, to efficiently optimize the IRS phase shift matrix. Concurrently, the water-filling (WF) algorithm is employed for BS precoding design. Simulation results demonstrate that compared with traditional methods, the proposed DSM algorithm achieves a 14.9% increase in sum rate, while exhibiting lower complexity and faster convergence. Furthermore, the proposed multi-IRS design yields an 8.7% performance gain over the single-IRS design.
- 8 July 2025
- Published by MDPI AG in Electronics
- Vol. 14 (14) , 2750
Open AccessLow-Complexity Sum-Rate Maximization for Multi-IRS-Assisted V2I Systems
Intelligent reflecting surface (IRS) has emerged as a promising solution to establish propagation paths in non-line-of-sight (NLoS) scenarios, effectively mitigating blockage challenges in direct vehicle-to-infrastructure (V2I) links. This study investigates a time-varying multi-IRS-assisted multiple-input multiple-output (MIMO) communication system, aiming to maximize the system sum rate through the joint optimization of base station (BS) precoding and IRS phase configurations. The formulated problem exhibits inherent non-convexity and time-varying characteristics, posing significant optimization challenges. To address these, we propose a low-complexity dimension-wise sine maximization (DSM) algorithm, grounded in the sum path gain maximization (SPGM) criterion, to efficiently optimize the IRS phase shift matrix. Concurrently, the water-filling (WF) algorithm is employed for BS precoding design. Simulation results demonstrate that compared with traditional methods, the proposed DSM algorithm achieves a 14.9% increase in sum rate, while exhibiting lower complexity and faster convergence. Furthermore, the proposed multi-IRS design yields an 8.7% performance gain over the single-IRS design.
- 12 April 2024
- Published by Springer Nature in The Journal of Supercomputing
- Vol. 80 (11) , 16497-16518
Study on spatial and temporal correlation characteristics for RIS-aided macrocell high-speed railway propagation systems
- 12 April 2024
- Published by Springer Nature in The Journal of Supercomputing
- Vol. 80 (11) , 16497-16518
Study on spatial and temporal correlation characteristics for RIS-aided macrocell high-speed railway propagation systems
- Open Access
- 24 August 2022
- Published by MDPI AG in Electronics
- Vol. 11 (17) , 2642
Novel AoD Estimation Algorithms for WSSUS and Non-WSSUS V2V Channel Modeling
In this paper, we propose efficient computational solutions for estimating the statistical properties of wide-sense stationary un-correlative scattering (WSSUS) and non-WSSUS multiple-input multiple-output (MIMO) vehicle-to-vehicle (V2V) channel models. Specifically, in the WSSUS channel models, we first estimate the angle of departure (AoD) for the non-line of sight (NLoS) propagation components. In this manner, the complex channel impulse response (CIR), which are widely used in the existing literature to characterize the wireless channel physical properties, can be estimated on the basis of the estimated AoD and defined model parameters. Conversely, in the non-WSSUS channel models, by estimating the AoD in the initial stage, the real-time complex CIR of the V2V channel model can be estimated on the basis of the estimated AoD and the moving time/velocities/directions of the mobile transmitter (MT) and mobile receiver (MR). In the estimation process of the aforementioned cases, we introduce different solutions to convert the CIRs from the complex domain to the real-value domain, thereby optimizing the computational efficiency for investigating channel characteristics as compared to existing methods. Numerical results of the WSSUS and non-WSSUS MIMO V2V channel characteristics, such as the spatial-temporal (ST) cross-correlation functions (CCFs) and auto-correlation functions (ACFs), are estimated on the basis of the estimated complex CIRs. These results are in agreements with theoretical ones, indicating that the proposed algorithms are practical for estimating the WSSUS and non-WSSUS MIMO V2V channel characteristics.
- 24 August 2022
- Published by MDPI AG in Electronics
- Vol. 11 (17) , 2642
Open AccessNovel AoD Estimation Algorithms for WSSUS and Non-WSSUS V2V Channel Modeling
In this paper, we propose efficient computational solutions for estimating the statistical properties of wide-sense stationary un-correlative scattering (WSSUS) and non-WSSUS multiple-input multiple-output (MIMO) vehicle-to-vehicle (V2V) channel models. Specifically, in the WSSUS channel models, we first estimate the angle of departure (AoD) for the non-line of sight (NLoS) propagation components. In this manner, the complex channel impulse response (CIR), which are widely used in the existing literature to characterize the wireless channel physical properties, can be estimated on the basis of the estimated AoD and defined model parameters. Conversely, in the non-WSSUS channel models, by estimating the AoD in the initial stage, the real-time complex CIR of the V2V channel model can be estimated on the basis of the estimated AoD and the moving time/velocities/directions of the mobile transmitter (MT) and mobile receiver (MR). In the estimation process of the aforementioned cases, we introduce different solutions to convert the CIRs from the complex domain to the real-value domain, thereby optimizing the computational efficiency for investigating channel characteristics as compared to existing methods. Numerical results of the WSSUS and non-WSSUS MIMO V2V channel characteristics, such as the spatial-temporal (ST) cross-correlation functions (CCFs) and auto-correlation functions (ACFs), are estimated on the basis of the estimated complex CIRs. These results are in agreements with theoretical ones, indicating that the proposed algorithms are practical for estimating the WSSUS and non-WSSUS MIMO V2V channel characteristics.