EEEvgenii Epifanov

Evgenii Epifanov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Evgenii Epifanov has a total of 18 co-authors. Here are the top co-authors by number of shared publications:

  • N. G. Minaev

    Institute of Photon Technologies, Kurchatov Complex of Crystallography and Photonics, NRC Kurchatov Institute, Troitsk, 108840 Moscow, Russia

    4 shared publications
  • Evgenii Igorevich Mareev

    Institute of Photon Technologies, Kurchatov Complex of Crystallography and Photonics, NRC Kurchatov Institute, Troitsk, 108840 Moscow, Russia

    3 shared publications
  • Timur A. Semenov

    Institute of Photon Technologies, Kurchatov Complex of Crystallography and Photonics, National Research Center “Kurchatov institute”, Moscow, Russia

    3 shared publications
  • G. V. Mishakov

    Institute of Photon Technologies, Kurchatov Complex of Crystallography and Photonics, National Research Center “Kurchatov institute”, Moscow, Russia

    2 shared publications
  • A. A. Garmatina

    Institute of Photon Technologies, Kurchatov Complex of Crystallography and Photonics, National Research Center “Kurchatov institute”, Moscow, Russia

    1 shared publication
  • A. G. Shubny

    Institute of Photon Technologies of Federal Scientific Research Centre “Crystallography and Photonics” of Russian Academy of Sciences , Pionerskaya 2, Moscow, Troitsk 108840, Russia

    1 shared publication

Latest Publications

  • Optical Diagnostics of Submicron Ibuprofen Particles in the RESS Process

    by T. A. Semenov, E. O. Epifanov, G. V. Mishakov, N. V. Minaev, A. M. Vorobey, A. A. Garmatina, V. V. Rovenko, E. I. Mareev

    An experimental setup has been developed for the in situ optical diagnostics of the formation of submicron particles using the micronization method of rapid expansion of supercritical solutions (RESS). The particle sizes are controlled based on measurements of the Mie scattering indicatrix (in the angle range of 15°–160°) of probing laser radiation (λ = 450 nm). The paper describes a technique for modeling the scattering indicatrix of an ensemble of particles based on the solution of the Mie problem. Ibuprofen particles with sizes of 400–2000 nm were obtained and characterized at supercritical initial conditions of 130 bar and 310 K. A method is proposed to increase the efficiency of ibuprofen micronization in the RESS process based on explosive boiling of a subcritical CO2 + ibuprofen mixture at process parameters of 70 bar and 302 K. The predominance of submicron ibuprofen particles with a lognormal distribution and an average size of 540 ± 140 nm is shown.

  • Open Access

    Time-Resolved Diagnostics of Explosive Boiling of Ibuprofen Solution in Subcritical CO2: From Microaggregates to CO2 Nanoclusters

    by Timur Semenov, Evgenii Epifanov, Gennady Mishakov, Vladimir Rovenko, Anton Vorobei, Ivan Goryachuk, Alexander Lazarev, Nikita Minaev, Evgenii Mareev

    Using an in situ method of time-resolved Mie scattering indicatrix registration, the dynamics of micro- and nanoparticle formation during the explosive boiling of a solution of ibuprofen in subcritical carbon dioxide (T0 = 302 K, P0 = 71 bar) were investigated. The process is found to exhibit multistage behavior. At the jet front, ibuprofen microaggregates with a mean radius of 1.4 ± 0.2 μm are formed, maintaining a stable size over the initial ~100 ms. Subsequent reduction in boiling intensity results in a decrease in the particle radius to 650 ± 100 nm. In the following stage, nanoscale CO2 clusters (20–50 nm) are detected by the Mie scattering technique. The findings indicate that the final size of the resulting ibuprofen particles is governed not only by the initial thermodynamic conditions but also by the boiling dynamics of the ibuprofen-saturated CO2 solution during the pulsed ejection process.

  • Dynamics of Submicron Gold Particle Formation during Laser Ablation in Supercritical Carbon Dioxide

    by E. O. Epifanov, N. M. Asharchuk, D. N. Khmelenin, I. V. Trofimov, A. O. Rybaltovsky, G. V. Mishakov, T. A. Semenov, N. V. Minaev, E. I. Mareev

    The dynamics of submicron gold particle formation during laser ablation in supercritical and liquid CO2 are investigated using time-resolved Mie scattering absorption spectroscopy. It is found that a high density of CO2 of approximately 800 kg/m3, regardless of the phase state, leads to the formation of laser-induced medium fluctuations on time scales of 10 to 1000 μs, during which the defocusing of subsequent laser pulses may occur. Under conditions of the reduced fluid density in the vicinity of the Widom region (P = 8.5 МРa, T = 310 K), it is demonstrated that nanoparticles can leave the interaction zone unhindered as evidenced by the exponential increase in integral absorption. Data from the absorption spectra allow the observation of the nanoparticle formation dynamics with an average diameter of approximately 160 nm and a log-normal size distribution, the width of which is determined by the thermodynamic conditions of CO2.


  • Thermoplasmonic laser-induced backside wet etching

    by A. G. Shubny, E. O. Epifanov, N. V. Minaev, V. I. Yusupov

    The article is devoted to one of the effective technologies for processing solid transparent materials—thermoplasmonic laser-induced backside wet etching (TP LIBWE). This technology involves aqueous solutions of metal precursors as a working medium. The dependence of the efficiency of sapphire TP LIBWE micromachining on the parameters of laser action is studied with the aqueous solution of the AgNO3 precursor as a working media. The near-optimal range of laser intensities from the point of the etching speed and quality is found. Utilizing the optoacoustic methods, high-speed video, and an optical integrating sphere, the initial stage of the TP LIBWE process is studied in detail. A four-stage model of the TP LIBWE beginning process is proposed, which explains the effects from the beginning of Ag nanoparticle formation in the region of laser exposure to the transition of the TP LIBWE process to a stationary laser microstructuring mode. It is shown that effective microstructuring occurs due to the appearance on the sapphire surface of a thin modified layer in the region of laser action. This thin modified layer is an amorphous Al2O3 with numerous plasmonic Ag nanoparticles inside it and at the sapphire/liquid interface.