Jianfeng Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jianfeng Sun has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Xianglong Zeng
Shanghai University
2 shared publications - Baojun Lin
Shanghai Engineering Center for Microsatellites, Shanghai, China
1 shared publication - Hongyu He
Key Laboratory of Space Laser Communication and Detection Technology, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China
1 shared publication - Jiafeng Lu
Shanghai University
1 shared publication - Jiangtao Xu
Key Lab of Specialty Fiber Optics and Optical Access Network, Shanghai University, Shanghai, China
1 shared publication - Linghao Meng
The Key Lab of Specialty Fiber Optics and Optical Access Network, Shanghai University, 34747 Shanghai, Shanghai China
1 shared publication
Latest Publications
- Open Access
Phase-Shift Laser Ranging Technology Based on Multi-Frequency Carrier Phase Modulation
Compared to traditional phase laser ranging technology, phase-shift laser ranging technology based on carrier phase modulation has significant advantages, such as simple modulation and demodulation, as well as simultaneous ranging and velocity measurements with high precision. To expand the range and ensure the ranging precision in carrier phase modulation in phase-shift laser ranging technology, we propose a phase-shift laser ranging system based on multi-frequency carrier phase modulation. We analyzed the effects of the stagger coefficient, modulation depth, and signal-to-noise ratio on the ranging precision by simulation. Finally, we built an experimental system with a range of 300 m by choosing appropriate parameters and conducting linearity and range precision tests. The experimental results show that the system has good linearity, and the ranging precision can reach 1 cm when the signal-to-noise ratio is 20 dB.
Open AccessPhase-Shift Laser Ranging Technology Based on Multi-Frequency Carrier Phase Modulation
Compared to traditional phase laser ranging technology, phase-shift laser ranging technology based on carrier phase modulation has significant advantages, such as simple modulation and demodulation, as well as simultaneous ranging and velocity measurements with high precision. To expand the range and ensure the ranging precision in carrier phase modulation in phase-shift laser ranging technology, we propose a phase-shift laser ranging system based on multi-frequency carrier phase modulation. We analyzed the effects of the stagger coefficient, modulation depth, and signal-to-noise ratio on the ranging precision by simulation. Finally, we built an experimental system with a range of 300 m by choosing appropriate parameters and conducting linearity and range precision tests. The experimental results show that the system has good linearity, and the ranging precision can reach 1 cm when the signal-to-noise ratio is 20 dB.
- 6 July 2022
- Published by Optica Publishing Group in Optics Letters
- Vol. 47 (14) , 3419-3422
All-fiber low-frequency shifter based on acousto–optic interaction and its heterodyne vibration response
We demonstrate two all-fiber low-frequency shift schemes based on the acousto–optic interaction in a few-mode fiber (FMF). Two acoustically induced fiber gratings (AIFGs) are cascaded in reverse to achieve an efficient cycle conversion between LP11 and LP01 core modes in the FMF while obtaining a frequency shift of 1.8 MHz. In addition, a long-period fiber grating (LPFG) is employed to replace the AIFG, which achieves a lower frequency shift of 0.9 MHz, and its tunable wavelength range exceeds 100 nm. Both schemes show the characteristics of an upward frequency shift. Moreover, we also present a heterodyne detection system based on the above frequency shift schemes, which is verified in response to micro-vibration signals ranging from tens to hundreds of kilohertz, as well as speech signals in a lower frequency range. The experimental results show that these all-fiber frequency shift schemes have potential applications, such as in fiber optic hydrophones, laser speech detection, and fiber optic sensors.
- 6 July 2022
- Published by Optica Publishing Group in Optics Letters
- Vol. 47 (14) , 3419-3422
All-fiber low-frequency shifter based on acousto–optic interaction and its heterodyne vibration response
We demonstrate two all-fiber low-frequency shift schemes based on the acousto–optic interaction in a few-mode fiber (FMF). Two acoustically induced fiber gratings (AIFGs) are cascaded in reverse to achieve an efficient cycle conversion between LP11 and LP01 core modes in the FMF while obtaining a frequency shift of 1.8 MHz. In addition, a long-period fiber grating (LPFG) is employed to replace the AIFG, which achieves a lower frequency shift of 0.9 MHz, and its tunable wavelength range exceeds 100 nm. Both schemes show the characteristics of an upward frequency shift. Moreover, we also present a heterodyne detection system based on the above frequency shift schemes, which is verified in response to micro-vibration signals ranging from tens to hundreds of kilohertz, as well as speech signals in a lower frequency range. The experimental results show that these all-fiber frequency shift schemes have potential applications, such as in fiber optic hydrophones, laser speech detection, and fiber optic sensors.
- 25 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (21) , 6057-6062
A Lower Frequency Shift Based on Mode Conversion for Optical Heterodyne Micro-Vibration Measurement
We experimentally obtain a lower frequency shift based on mode conversion by using a mode-selective coupler (MSC) and an acoustically induced fiber grating (AIFG) for optical heterodyne micro-vibration measurement. Through efficient conversion between LP11 and LP01 core modes in a few-mode fiber, a mode conversion frequency shifter (MCFS) can be achieved and the magnitude of frequency shift is several hundred kHz, which is generally challenging for traditional bulk acousto-optic frequency shifter. Moreover, the signal-to-signal beating interference (SSBI) can be eliminated by using the MCFS without requirement of guard band. The scheme of optical heterodyne micro-vibration measurement based on the MCFS has a high-quality signal-to-noise ratio (SNR) over 85 dB. An all-fiber Bragg grating (FBG) scheme is also designed to improve the measurement sensitivity of heterodyne detection, which has a measurable vibration frequency range of 1 Hz to 300 kHz and minimal detectable amplitude of 0.019 nm. The all-fiber MCFS has the advantages of compactness, easy integration and can be applied directly to satellite ground station and laser feedback tomography.
- 25 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (21) , 6057-6062
A Lower Frequency Shift Based on Mode Conversion for Optical Heterodyne Micro-Vibration Measurement
We experimentally obtain a lower frequency shift based on mode conversion by using a mode-selective coupler (MSC) and an acoustically induced fiber grating (AIFG) for optical heterodyne micro-vibration measurement. Through efficient conversion between LP11 and LP01 core modes in a few-mode fiber, a mode conversion frequency shifter (MCFS) can be achieved and the magnitude of frequency shift is several hundred kHz, which is generally challenging for traditional bulk acousto-optic frequency shifter. Moreover, the signal-to-signal beating interference (SSBI) can be eliminated by using the MCFS without requirement of guard band. The scheme of optical heterodyne micro-vibration measurement based on the MCFS has a high-quality signal-to-noise ratio (SNR) over 85 dB. An all-fiber Bragg grating (FBG) scheme is also designed to improve the measurement sensitivity of heterodyne detection, which has a measurable vibration frequency range of 1 Hz to 300 kHz and minimal detectable amplitude of 0.019 nm. The all-fiber MCFS has the advantages of compactness, easy integration and can be applied directly to satellite ground station and laser feedback tomography.