Hai-Jun Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hai-Jun Liu has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Chenglin Du
State Key Laboratory of Mobile Network and Mobile Multimedia Technology, Shenzhen 518055, China
1 shared publication - Dehan Wang
Department of Electronic Engineering, Tsinghua University, Beijing, China
1 shared publication - Jiejie Zhu
National Engineering Research Center of Wide Band-Gap Semiconductor, Faculty of Integrated Circuit, Xidian University, Xian, China
1 shared publication - Kai Cui
RCH System Design Department, ZTE Corporation, Xi’an 710047, China
1 shared publication - Kai Kang
University of Electronic Science and Technology of China
1 shared publication - Ran Ye
State Key Laboratory of Mobile Network and Mobile Multimedia Technology, Shenzhen 518055, China
1 shared publication
Latest Publications
- Open Access
- 15 February 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (2) , 220
A 3.2–3.6 GHz GaN Doherty Power Amplifier Module Based on a Compact Low-Loss Combiner
In this paper, a 3.2–3.6 GHz two-stage Doherty power amplifier (PA) module is proposed for fifth-generation (5G) massive multiple-input multiple-output (MIMO) base stations. A detailed design method and procedure for a compact and low-loss combiner suitable for the Doherty PA module are introduced. Based on the proposed combiner, a Doherty PA module is implemented using gallium nitride (GaN) transistors and surface-mounted devices (SMDs) with a packaged size of 8 × 8 mm2. The proposed two-stage Doherty PA module achieves a 3 dB small-signal bandwidth of 3.1–3.9 GHz and a peak gain of 31.7 dB. From 3.2 to 3.6 GHz, the saturated output power is 40.4–41.1 dBm. Moreover, the measured saturated drain efficiency (DE) and 8 dB power back-off (PBO) DE reach 51–56.6% and 45.5–48.6%, respectively.
- 15 February 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (2) , 220
Open AccessA 3.2–3.6 GHz GaN Doherty Power Amplifier Module Based on a Compact Low-Loss Combiner
In this paper, a 3.2–3.6 GHz two-stage Doherty power amplifier (PA) module is proposed for fifth-generation (5G) massive multiple-input multiple-output (MIMO) base stations. A detailed design method and procedure for a compact and low-loss combiner suitable for the Doherty PA module are introduced. Based on the proposed combiner, a Doherty PA module is implemented using gallium nitride (GaN) transistors and surface-mounted devices (SMDs) with a packaged size of 8 × 8 mm2. The proposed two-stage Doherty PA module achieves a 3 dB small-signal bandwidth of 3.1–3.9 GHz and a peak gain of 31.7 dB. From 3.2 to 3.6 GHz, the saturated output power is 40.4–41.1 dBm. Moreover, the measured saturated drain efficiency (DE) and 8 dB power back-off (PBO) DE reach 51–56.6% and 45.5–48.6%, respectively.
- Open Access
Effect of Source Field Plate Cracks on the Electrical Performance of AlGaN/GaN HEMT Devices
In the current study, the effects of cracks in source field plates (SFPs) on the electrical performance of AlGaN/GaN high electron mobility transistors (HEMTs) are investigated systematically using numerical simulation. In detail, the influence of crack width and junction angle in SFPs on device performance is studied. The results indicate that the SFP structure increases the breakdown voltage of a device, but the occurrence of cracks causes premature breakdown, which is confirmed experimentally by the structural analysis of these devices after breakdown. With an increase in crack width, the electrical performance becomes worse. A beveled SFP architecture is proposed by increasing the angle at the SFP junction to reduce the probability of cracking and enhance the reliability of the device. However, with an increase in bevel angle, the modulation effect of the SFP on the channel electric field is gradually weakened. Therefore, it is necessary to balance the relationship between electrical performance and bevel angle according to the actual demands. This work provides potential support for SFP structural optimization design for AlGaN/GaN HEMTs.
Open AccessEffect of Source Field Plate Cracks on the Electrical Performance of AlGaN/GaN HEMT Devices
In the current study, the effects of cracks in source field plates (SFPs) on the electrical performance of AlGaN/GaN high electron mobility transistors (HEMTs) are investigated systematically using numerical simulation. In detail, the influence of crack width and junction angle in SFPs on device performance is studied. The results indicate that the SFP structure increases the breakdown voltage of a device, but the occurrence of cracks causes premature breakdown, which is confirmed experimentally by the structural analysis of these devices after breakdown. With an increase in crack width, the electrical performance becomes worse. A beveled SFP architecture is proposed by increasing the angle at the SFP junction to reduce the probability of cracking and enhance the reliability of the device. However, with an increase in bevel angle, the modulation effect of the SFP on the channel electric field is gradually weakened. Therefore, it is necessary to balance the relationship between electrical performance and bevel angle according to the actual demands. This work provides potential support for SFP structural optimization design for AlGaN/GaN HEMTs.