Cong-Bin Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Cong-Bin Liu has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Jinbing Cheng
Henan International Joint Laboratory of MXene Materials Microstructure, College of Physics and Electronic Engineering, Nanyang Normal University, Nanyang 473061, China
2 shared publications C. Dong
Wuhan National High Magnetic Field Center, Huazhong University of Science and Technology, Wuhan 430074, China
1 shared publication- Chunying Pu
College of Physics and Electronic Engineering, Nanyang Normal University, Nanyang 473061, China
1 shared publication D. Chen
College of Physics and Electronic Engineering, Xinyang Normal University, Xinyang 464000, China
1 shared publication- Deyang Zhang
Henan Joint International Research Laboratory of New Energy Storage Technology, Xinyang Normal University, Xinyang 464000, P. R. China
1 shared publication - H. J. Hu
College of Physics and Electronic Engineering, Xinyang Normal University, Xinyang 464000, China
1 shared publication
Latest Publications
- 4 December 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (22) , 224405
Ferroelectricity and multiferroic quantum critical behaviors inWe present isothermal ferroelectric (FE) and quasiadiabatic phase diagrams for single-crystal with magnetic fields () along the axis, obtained through magnetization, polarization (), and magnetocaloric effect measurements under pulsed magnetic fields up to 30 T. The FE diagram reveals two FE phases, denoted as FE-I and FE-II, with overlapping boundaries at low temperatures (). At 2 K, the signal along exhibits a positive value in FE-I, transitioning to a negative value in FE-II with increasing . During the descending- process, reverses, with FE-II displaying positive polarization and FE-I displaying negative, indicative of dynamic ferroelectric behavior. Above 3 K, a paraelectric (PE) phase emerges, effectively separating the two FE phases. This PE phase correlates with the 1/2 plateau observed in the magnetization curve. Simultaneously, as increases, the negative signals of FE-I and FE-II sequentially reverse to positive, leading to the gradual diminishment of the signal reversal of along the axis due to the history of sweeping. The magnetic Grüneisen parameter diverges near the field on both sides of the 1/2 plateau, providing evidence of multiferroic quantum criticality. Employing symmetry analysis, we propose a chiral “water-strider” type spin configuration to elucidate the origin of ferroelectricity and the magnetization process. The high-field FE phase may be associated with the quintuplet excitation of the Co1 dimer in the presence of magnetic fields.- 4 December 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (22) , 224405
Ferroelectricity and multiferroic quantum critical behaviors inWe present isothermal ferroelectric (FE) and quasiadiabatic phase diagrams for single-crystal with magnetic fields () along the axis, obtained through magnetization, polarization (), and magnetocaloric effect measurements under pulsed magnetic fields up to 30 T. The FE diagram reveals two FE phases, denoted as FE-I and FE-II, with overlapping boundaries at low temperatures (). At 2 K, the signal along exhibits a positive value in FE-I, transitioning to a negative value in FE-II with increasing . During the descending- process, reverses, with FE-II displaying positive polarization and FE-I displaying negative, indicative of dynamic ferroelectric behavior. Above 3 K, a paraelectric (PE) phase emerges, effectively separating the two FE phases. This PE phase correlates with the 1/2 plateau observed in the magnetization curve. Simultaneously, as increases, the negative signals of FE-I and FE-II sequentially reverse to positive, leading to the gradual diminishment of the signal reversal of along the axis due to the history of sweeping. The magnetic Grüneisen parameter diverges near the field on both sides of the 1/2 plateau, providing evidence of multiferroic quantum criticality. Employing symmetry analysis, we propose a chiral “water-strider” type spin configuration to elucidate the origin of ferroelectricity and the magnetization process. The high-field FE phase may be associated with the quintuplet excitation of the Co1 dimer in the presence of magnetic fields.- Open Access
Modeling Clock Comparison Experiments to Test Special Relativity
The clock comparison experiments to test special relativity mainly include the Michelson–Morley experiment, Kennedy–Thorndike experiment, Ives–Stilwell experiment and the comparison experiment of atomic clocks in two locations. These experiments can be roughly classified as the comparison of two types of clocks: optical clocks and atomic clocks. Through the comparison of such clocks, Lorentz invariance breaking parameters in the RMS framework can be tested. However, in such experiments, the structural effects of optical clocks have been fully considered, yet the structural effects of atomic clocks have not been carefully studied. Based on this, this paper analyzes the structural effects of atomic clocks in detail and divides the experiments into six types: the comparison of two atomic clocks, two optical clocks, and atomic clocks and optical clocks placed in different and the same locations. Finally, correction parameters for the experimental measurements are given.
Open AccessModeling Clock Comparison Experiments to Test Special Relativity
The clock comparison experiments to test special relativity mainly include the Michelson–Morley experiment, Kennedy–Thorndike experiment, Ives–Stilwell experiment and the comparison experiment of atomic clocks in two locations. These experiments can be roughly classified as the comparison of two types of clocks: optical clocks and atomic clocks. Through the comparison of such clocks, Lorentz invariance breaking parameters in the RMS framework can be tested. However, in such experiments, the structural effects of optical clocks have been fully considered, yet the structural effects of atomic clocks have not been carefully studied. Based on this, this paper analyzes the structural effects of atomic clocks in detail and divides the experiments into six types: the comparison of two atomic clocks, two optical clocks, and atomic clocks and optical clocks placed in different and the same locations. Finally, correction parameters for the experimental measurements are given.
- Open Access
MoS2 Transistors with Low Schottky Barrier Contact by Optimizing the Interfacial Layer Thickness
Molybdenum disulfide (MoS2) has attracted great attention from researchers because of its large band gap, good mechanical toughness and stable physical properties; it has become the ideal material for the next-generation optoelectronic devices. However, the large Schottky barrier height (ΦB) and contact resistance are obstacles hampering the fabrication of high-power MoS2 transistors. The electronic transport characteristics of MoS2 transistors with two different contact structures are investigated in detail, including a copper (Cu) metal–MoS2 channel and copper (Cu) metal–TiO2-MoS2 channel. Contact optimization is conducted by adjusting the thickness of the TiO2 interlayer between the metal and MoS2. The metal-interlayer-semiconductor (MIS) structure with a 1.5 nm thick TiO2 layer has a smaller Schottky barrier of 22 meV. The results provide insights into the engineering of MIS contacts and interfaces to improve transistor characteristics.
Open AccessMoS2 Transistors with Low Schottky Barrier Contact by Optimizing the Interfacial Layer Thickness
Molybdenum disulfide (MoS2) has attracted great attention from researchers because of its large band gap, good mechanical toughness and stable physical properties; it has become the ideal material for the next-generation optoelectronic devices. However, the large Schottky barrier height (ΦB) and contact resistance are obstacles hampering the fabrication of high-power MoS2 transistors. The electronic transport characteristics of MoS2 transistors with two different contact structures are investigated in detail, including a copper (Cu) metal–MoS2 channel and copper (Cu) metal–TiO2-MoS2 channel. Contact optimization is conducted by adjusting the thickness of the TiO2 interlayer between the metal and MoS2. The metal-interlayer-semiconductor (MIS) structure with a 1.5 nm thick TiO2 layer has a smaller Schottky barrier of 22 meV. The results provide insights into the engineering of MIS contacts and interfaces to improve transistor characteristics.