Saeed Salimian Rizi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Saeed Salimian Rizi has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Alex Chiasson
Department of Engineering Physics, McMaster University, Hamilton, ON L8S 4L8, Canada
1 shared publication - Chang-Qing Xu
Department of Engineering Physics, McMaster University, Hamilton, ON L8S 4L7, Canada
1 shared publication - Daniel Poitras
National Research Council Canada
1 shared publication E Hajinia
Iranian National Center for Laser Science and Technology, PO Box 14665-576, Tehran, Iran
1 shared publicationH Nabavi
Iranian National Center for Laser Science and Technology, PO Box 14665-576, Tehran, Iran
1 shared publication- Liam Flannigan
Department of Engineering Physics, McMaster University, Hamilton, Canada
1 shared publication
Latest Publications
- Open Access
Efficient, Compact Mid-Infrared Sources: A Systematic Study of Intracavity Difference-Frequency Generation
This study presents a compact intracavity difference-frequency generation (DFG) source designed for mid-infrared (mid-IR) applications. By optimizing overlap between the pump and signal beams, we obtained a black-box efficiency () of 3.4% W⁻1 and a maximum DFG output power of 63 mW at a wavelength of 3437 nm for a 50 mm long periodically poled lithium niobate (PPLN) crystal. The mid-IR laser was systematically studied for various PPLN lengths (29 mm, 40 mm, and 50 mm), demonstrating extensive tunability across a range of mid-IR wavelengths. Stability assessments over short-term (2 min) and long-term (2 h) periods were also investigated, showing stability values of 0.91% and 1.08%, respectively. These advancements position our DFG laser as a promising candidate for potential applications in greenhouse gas detection and satellite communication, addressing the growing demand for reliable and efficient mid-IR sources.Open AccessEfficient, Compact Mid-Infrared Sources: A Systematic Study of Intracavity Difference-Frequency Generation
This study presents a compact intracavity difference-frequency generation (DFG) source designed for mid-infrared (mid-IR) applications. By optimizing overlap between the pump and signal beams, we obtained a black-box efficiency () of 3.4% W⁻1 and a maximum DFG output power of 63 mW at a wavelength of 3437 nm for a 50 mm long periodically poled lithium niobate (PPLN) crystal. The mid-IR laser was systematically studied for various PPLN lengths (29 mm, 40 mm, and 50 mm), demonstrating extensive tunability across a range of mid-IR wavelengths. Stability assessments over short-term (2 min) and long-term (2 h) periods were also investigated, showing stability values of 0.91% and 1.08%, respectively. These advancements position our DFG laser as a promising candidate for potential applications in greenhouse gas detection and satellite communication, addressing the growing demand for reliable and efficient mid-IR sources. - 25 August 2022
- Published by IOP Publishing in Laser Physics
- Vol. 32 (9) , 095001
Simulation and experimental investigation of a 6.6 ps passively mode-locked TEM 00 Nd:YVO 4 /KTP green laser based on SESAM
The design, construction, and characterization of a diode-pumped SESAM mode-locked TE M 00 Nd:YV O 4 green laser were reported. Based on the simulation results, the technical route for the construction and optimization of the resonator was determined. A KTP was used as the intracavity frequency doubling crystal. The maximum output average power at 532 nm was 500 mW with a repetition rate of 82 MHz at a pump power of 5 W. In addition, the measured and simulated beam quality was about M 2 < 1.4 , indicating the single-mode operation of the laser. Moreover, the spectral characteristics of the laser at 1064 nm and 532 nm were analyzed. The time duration of the pulses at 1064 nm was about 9.4 ps. The theoretical calculations based on the time-bandwidth product evaluation method predicted the time duration of 6.6 ps for the pulses at 532 nm.
- 25 August 2022
- Published by IOP Publishing in Laser Physics
- Vol. 32 (9) , 095001
Simulation and experimental investigation of a 6.6 ps passively mode-locked TEM 00 Nd:YVO 4 /KTP green laser based on SESAM
The design, construction, and characterization of a diode-pumped SESAM mode-locked TE M 00 Nd:YV O 4 green laser were reported. Based on the simulation results, the technical route for the construction and optimization of the resonator was determined. A KTP was used as the intracavity frequency doubling crystal. The maximum output average power at 532 nm was 500 mW with a repetition rate of 82 MHz at a pump power of 5 W. In addition, the measured and simulated beam quality was about M 2 < 1.4 , indicating the single-mode operation of the laser. Moreover, the spectral characteristics of the laser at 1064 nm and 532 nm were analyzed. The time duration of the pulses at 1064 nm was about 9.4 ps. The theoretical calculations based on the time-bandwidth product evaluation method predicted the time duration of 6.6 ps for the pulses at 532 nm.