DJDongdong Jia

Dongdong Jia

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dongdong Jia has a total of 38 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • An Approach to Electron Optical System Design for Dual-Pencil-Beam Traveling Wave Tubes

    by Dongdong Jia, Hairong Yin, Pengcheng Yin, Wuyang Fan, Jian Zhang, Yue Ouyang, Jinchi Cai, Jin Xu, Lingna Yue, Yong Xu, et al.

    Achieving a high compression factor and stable long-distance transmission of electron beams presents significant challenges for developing multibeam devices, especially those that employ multiple pencil beams. Uniform magnetic (UM) field focusing structures, although viable, are often limited by their bulkiness and weight. This article presents a novel approach for designing dual-beam electron guns with significantly enhanced electron beam compression. The proposed methodology, implemented in W-band overmoded traveling wave tubes (TWTs), demonstrates exceptional performance, achieving a remarkable beam compression factor of 57 at a total current of 0.2 A ( $2\times 0.1$ A). In addition, a compact periodic cusped magnetic structure with a notch is proposed to effectively confine dual pencil beams. Co-simulation results of the electron optical system demonstrate a transmission efficiency of 99.2% over a distance of 100 mm.

  • Demonstration of an Upgrading G-Band Rhombic Grating Slotted Sine Waveguide TWT

    by Jian Zhang, Jinchi Cai, Jin Xu, Pengcheng Yin, Xiancai Lin, DongDong Jia, Wuyang Fan, Dengwei Yang, Zixuan Su, Wei Li, et al.

    In this article, a novel rhombic grating slotted sine waveguide (RGS-SWG) is proposed for high-power terahertz traveling-wave tube (THz TWT), which has been conceived, fabricated, and tested. By reconfiguring a previously reported staggered U-shaped groove sine waveguide (SUGSWG) from a rectangular grating to a rhombus grating, the RGS-SWG represents the low ohmic loss (32% lower) and high interaction impedance (23% higher) under similar dispersion properties. Particle-in-cell (PIC) simulation results showcase that the maximum saturation output power and efficiency bandwidth product (EBP) of RGS-SWG TWT are 226 W and 148%⋅GHz, which are 26% and 32% larger than those of the SUGSWG TWT under the same operating voltage of 23 kV and current of 126 mA. Subsequently, a G-band electron gun and double periodic permanent magnetic focusing system were designed for a circular electron beam to pass through the circuit tunnel without being intercepted. Finally, the nano computer numerical control technology was used to realize the fabrication and transmission test of the novel RGS-SWG slow wave structure (SWS). The cold test results demonstrate that the ohmic loss at 220 GHz is 0.15 dB/mm, and the measurement results agree well with the theoretical design of S parameters in the operating frequency band, which verifies the possibility of realizing this novel RGS-SWG structure and validates the remarkable potential in RGS-SWG TWTs for THz applications.


  • Studies on Traveling Wave Tubes With the Bunching Mechanism of Resistive Wall and the Circuit-Field Synchronous Interaction

    by Yue Ouyang, Hairong Yin, Jinchi Cai, Dongdong Jia, Pengcheng Yin, Wuyang Fan, Lingna Yue, Jin Xu, Yong Xu, Yanyu Wei, et al.

    There is no interaction between the circuit wave and the electron beam in resistive wall amplifiers (RWAs), and the further bunching of the electron beam is caused by the interaction between the electron beam and the space charge field driven by the surface plasmons in the resistive wall. However, due to the inability of the resistive wall structure to excite space charge waves, a coupling system is necessary to pre-modulate the electron beam. Consequently, the tube length of RWAs is relatively longer for the same gain. This article aims to integrate the bunching mechanism of RWAs with the interaction mechanism of traditional traveling wave tubes (TWTs), so that there is both an aiding effect of the space charge field on bunching and a synchronous interaction between the circuit-field and the electron beam in a TWT. The calculation results suggest that this new integrated mechanism not only reduces the tube length but also improves the gain.

  • A Nonlinear Theory of the Beam-Wave Interaction in a Resistive Wall Amplifier

    by Yue Ouyang, Hairong Yin, Jinchi Cai, Dongdong Jia, Pengcheng Yin, Wuyang Fan, Lingna Yue, Jin Xu, Guoqing Zhao, Yanyu Wei, et al.

    Based on the special interaction mechanism of the resistive wall amplifier (RWA) that there is no interaction between the circuit wave and the electron beam, and the further bunching of the electron beam is caused by the interaction between the electron beam and the space charge field driven by the plasma wave in the resistive wall, a nonlinear theory of the beam-wave interaction in RWAs is built in this article, and a corresponding 1-D code is developed. The 1-D large-signal model, which is not based on the equivalent circuit, is a universal model. Energy exchange is calculated based on the energy formula obtained from the electron equation of motion. A special method is used to represent the propagation and growth of space charge waves. And a special method was used to obtain an analytical expression for the space charge field when the current density expression was given. There is a good agreement between the results calculated by the large-signal code and by CST and previous experiments.


  • Open Access

    Enhancing interaction efficiency in traveling-wave devices with multiple beamlets and beam–beam interference

    by Dongdong Jia, Hairong Yin, Jun Cheng, Jinchi Cai, Jin Xu, Lingna Yue, Min Hu, Diwei Liu, W. X. Wang, Yanyu Wei

    We demonstrate that beam–beam interference can significantly enhance the efficiency of multi-beam traveling-wave devices. Our theoretical analysis explains that a positive coupling of the space-charge field enhances the beam–wave interaction, resulting in increased efficiency in multi-beam devices with beam–beam interference. We validate this mechanism by performing particle-in-cell simulations on 670 GHz grid-loaded rectangular waveguide backward-wave oscillators. Both the multi-beam and single-beam devices exhibit the same dispersion of operating modes and operate under identical conditions. The simulation results indicate that the efficiency of the multi-beam device is up to 1.58 times higher than that of the single-beam device. Additionally, simulations are performed on the same structure at 340 and 1030 GHz, demonstrating efficiency improvements that support the proposed mechanism. These findings present a novel approach for increasing the efficiency of traveling-wave devices.

  • Design and Cold-Test of 0.34-THz Modified Slotted Sine Waveguide Traveling Wave Tube

    by Jinjing Luo, Jin Xu, Pengcheng Yin, Jian Zhang, Dongdong Jia, Jinchi Cai, Linna Yue, Hairong Yin, Zhanliang Wang, Yanyu Wei

    The sine waveguide slow wave structure (SWG SWS), which has the advantages of being simple to fabricate, high transmission, low reflection, and insertion loss, has been considered as a potential construction in the terahertz region. Nevertheless, the existing ideal SWG SWS could not be fabricated by nano-computer numerical control (nano-CNC) machining. A modified slotted SWG (MS-SWG) SWS that evolved from the ideal slotted SWG (IS-SWG) SWS is suggested in this study. The cold-test results prove the feasibility of the processing scheme and the S $_{\mathbf{\text{11}}}$ $<$ $-$ 15 dB ranges from 330 to 390 GHz. The particle-in-cell (PIC) results reveal that the presented SWS can produce output power of 17.4 W at 340 GHz with gain of 33.9 dB. The 3-dB bandwidth is 11 GHz from 334 to 345 GHz. The simulation findings reveal a flow rate of 100% for the matched electron-optical system (EOS), which includes an electron gun, a periodic permanent magnet (PPM), and a single-stage depressed collector.


  • Study of a 0.67 THz TWT Based on Slotted Quasi Sine Waveguide

    by Jinjing Luo, Jin Xu, Pengcheng Yin, Jian Zhang, Dongdong Jia, Wuyang Fan, Yue Ouyang, Jinchi Cai, Lingna Yue, Hairong Yin, et al.

    A 670 GHz slotted quasi sine waveguide (S-QSWG) slow wave structure (SWS) has been designed and simulated in this article. The high frequency characteristics, transmission characteristic and beam-wave interaction are simulated by CST STUDIO SUITE software. A two-section circuit is proposed and the cold simulation result shows the reflection loss is less than -15 dB in the frequency range of 658–698 GHz. Results of beam-wave interaction demonstrates the circuit can produce maximum output power of 1.9 W at 670 GHz with operating voltage of 24.1 kV, operating current of 17 mA and input power of 3 mW, the corresponding maximum gain at 670 GHz is 28 dB.

  • Design and Analysis of a 0.33-THz Sine-Shaped Folded Waveguide Traveling Wave Tube

    by Jinjing Luo, Jin Xu, Pengcheng Yin, Jian Zhang, Dongdong Jia, Wuyang Fan, Yue Ouyang, Lingna Yue, Jinchi Cai, Hairong Yin, et al.

    Folded waveguide (FWG) traveling wave tube (TWT) is an attractive choice for a high-power amplifier. This article proposes a novel slow wave structure (SWS) called sine-shaped FWG (S-FWG), which is derived from conventional FWG. With the feature of transforming the arc-shaped segment of the traditional FWG into the sinusoidal waveguide, the proposed structure could be quickly optimized by modifying the amplitude of the two sine curves, and it has an ability to produce a greater interaction impedance compared to the traditional FWG SWS with the same frequency band, which, under the same operating conditions, is expected to result in a higher output power. Using CST Microwave Studio, the high-frequency properties and beam–wave interaction were simulated. Simulation results indicate that the S-FWG TWT reaches a maximum output power of 16.82 W and a gain of 32.25 dB at 330 GHz with an operating voltage of 19.4 kV, a beam current of 30 mA, and an input power of 10 mW. The S-FWG SWS should therefore be regarded as a promising SWS for the high-power terahertz (THz) traveling wave amplifier.


  • Bandwidth enhancement for over-mode traveling-wave amplifiers

    by Dongdong Jia, Hairong Yin, Jin Xu, Lingna Yue, Ruichao Yang, Pengcheng Yin, Jinjing Luo, Jian Zhang, Jinchi Cai, G. Guo, et al.

    To increase the bandwidth of conventional over-mode traveling wave tubes (TWTs) with single-mode existing (SME) in an operation band, a theory on over-mode TWTs with multi-modes coexisting (MME) in the operation band is presented in this paper. To verify this theory, G-band dual-beam and shunted coupled Hughes-type coupled-cavity TWTs with MME and SME are investigated. The particle-in-cell simulation analysis confirms that, compared with SME TWT, the MME TWT can not only operate stably but also has 2.24 times bandwidth and a large increase in the output power.