Khan Mohammad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Khan Mohammad has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Farha Khan
Department of Electrical Engineering Aligarh Muslim University Aligarh Uttar Pradesh India amu.ac.in
1 shared publication - Hasan Alrajhi
Department of Electrical Engineering, Umm Al-Qura University, Mecca, Saudi Arabia
1 shared publication - M. Saad Bin Arif
Aligarh Muslim University
1 shared publication - Mohd Faraz Ahmad
Department of Electrical Engineering, Z. H. College of Engineering & Technology, Aligarh Muslim University, Aligarh 202001, India
1 shared publication - Mohd Sarfaraz Alam
Aligarh Muslim University
1 shared publication - Mohmmad Ahmad
Rajkiya Engineering College Bijnor
1 shared publication
Latest Publications
- Open Access
- 1 March 2025
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 16 (1) , 344-354
Proposed high gain single DC-source SC-MLI topology for solar PV grid integration applications
Multilevel inverters (MLIs) are a key solution for converting DC to AC power. In this article, an improved single-source SC-MLI topology is developed for solar PV applications. It consists of 12 unidirectional switches, 3 capacitors, and 3 diodes to provide sextuple voltage boosting with a lower cost function. Since the capacitor's voltage is self-balanced, there is no need for an additional circuit or sensors, bringing down the circuit's complexity. A simple and fundamental frequency-based control strategy, nearest-level pulse width modulation, is applied to assess the viability of the proposed topology. As a result, the proposed topology has an efficiency of over 97%, and it can generate 13 levels with a total harmonic distortion (THD) of 6.51%. Comparative analysis is performed to show the feasibility of the proposed topology which outperformed other 13-level similar topologies in terms of component count, cost factor, and boosting factor. The proposed topology's performance is evaluated under static and dynamic loads. Furthermore, the thermal analysis is performed using PLECS software to determine the efficiency of the circuit topology. Finally, the feasibility of the proposed circuit is verified for solar PV application.
- 1 March 2025
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 16 (1) , 344-354
Open AccessProposed high gain single DC-source SC-MLI topology for solar PV grid integration applications
Multilevel inverters (MLIs) are a key solution for converting DC to AC power. In this article, an improved single-source SC-MLI topology is developed for solar PV applications. It consists of 12 unidirectional switches, 3 capacitors, and 3 diodes to provide sextuple voltage boosting with a lower cost function. Since the capacitor's voltage is self-balanced, there is no need for an additional circuit or sensors, bringing down the circuit's complexity. A simple and fundamental frequency-based control strategy, nearest-level pulse width modulation, is applied to assess the viability of the proposed topology. As a result, the proposed topology has an efficiency of over 97%, and it can generate 13 levels with a total harmonic distortion (THD) of 6.51%. Comparative analysis is performed to show the feasibility of the proposed topology which outperformed other 13-level similar topologies in terms of component count, cost factor, and boosting factor. The proposed topology's performance is evaluated under static and dynamic loads. Furthermore, the thermal analysis is performed using PLECS software to determine the efficiency of the circuit topology. Finally, the feasibility of the proposed circuit is verified for solar PV application.
- Open Access
- 1 September 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 13 (3) , 1704-1712
Performance evaluation of a PMDC motor with battery storage control and MPPT based solar photovoltaic system
This paper analyzes and demonstrates the performance of a solar photovoltaic (SPV)-fed permanent magnet DC (PMDC) motor under various operating conditions. In this configuration, a 5HP PMDC is coupled to a SPV system and a boost converter has been interfaced between them to regulate the DC output voltage acquired from the SPV system. The switching pulse to the converter has been provided by the maximum power point tracking (MPPT) controller (P&O and INC) in order to acquire maximum and desired power across the DC link with varying irradiance. A battery energy storage system (BESS) is often used in association with this configuration caused by the non-linear nature of the SPV system and to overcome the volatility of the DC connection affected by environmental effects. For this purpose, a double loop PI controller is analyzed, and examined the DC link. Additionally, the operation of bidirectional DC-DC converter in buck and boost mode during battery charging and discharging is also performed. This operation ensures maintaining a constant and continuous power across the DC link to regulate the PMDC motor consistently. A comparison of results has also been presented for both incremental and conductance (INC) and P&O controllers. The mathematical modeling of configuration has been performed in MATLAB/Simulink software. The results and key findings have been tabulated and even elaborated graphically.
- 1 September 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 13 (3) , 1704-1712
Open AccessPerformance evaluation of a PMDC motor with battery storage control and MPPT based solar photovoltaic system
This paper analyzes and demonstrates the performance of a solar photovoltaic (SPV)-fed permanent magnet DC (PMDC) motor under various operating conditions. In this configuration, a 5HP PMDC is coupled to a SPV system and a boost converter has been interfaced between them to regulate the DC output voltage acquired from the SPV system. The switching pulse to the converter has been provided by the maximum power point tracking (MPPT) controller (P&O and INC) in order to acquire maximum and desired power across the DC link with varying irradiance. A battery energy storage system (BESS) is often used in association with this configuration caused by the non-linear nature of the SPV system and to overcome the volatility of the DC connection affected by environmental effects. For this purpose, a double loop PI controller is analyzed, and examined the DC link. Additionally, the operation of bidirectional DC-DC converter in buck and boost mode during battery charging and discharging is also performed. This operation ensures maintaining a constant and continuous power across the DC link to regulate the PMDC motor consistently. A comparison of results has also been presented for both incremental and conductance (INC) and P&O controllers. The mathematical modeling of configuration has been performed in MATLAB/Simulink software. The results and key findings have been tabulated and even elaborated graphically.