Lin Deng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lin Deng has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Boling Lan
Key Laboratory of Advanced Technologies of Materials (Ministry of Education) School of Materials Science and Engineering Southwest Jiaotong University Chengdu 610031 P. R. China
2 shared publications- Guo Tian
Guangdong Provincial Key Laboratory of Quantum Engineering and Quantum Materials and Institute for Advanced Materials, South China Academy of Advanced Optoelectronics, South China Normal University, Guangzhou 510006, China
2 shared publications - Hongrui Zhang
Key Laboratory of Advanced Technologies of Materials (Ministry of Education) School of Materials Science and Engineering Southwest Jiaotong University Chengdu 610031 P. R. China
2 shared publications - Shenglong Wang
Key Laboratory of Advanced Technologies of Materials (Ministry of Education), School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu, PR China
2 shared publications - Weili Deng
Key Laboratory of Advanced Technologies of Materials, Ministry of Education, School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu, 610031, China
2 shared publications - Weiqing Yang
School of Materials Science and Engineering Key Laboratory of Advanced Technologies of Materials (Ministry of Education) Southwest Jiaotong University Chengdu China
2 shared publications
Latest Publications
- 6 August 2025
- Published by Springer Nature in Journal of Mountain Science
- Vol. 22 (8) , 2765-2792
Unveiling dominant factors for gully distribution in wildfire-affected areas using explainable AI: A case study of Xiangjiao catchment, Southwest China
- 6 August 2025
- Published by Springer Nature in Journal of Mountain Science
- Vol. 22 (8) , 2765-2792
Unveiling dominant factors for gully distribution in wildfire-affected areas using explainable AI: A case study of Xiangjiao catchment, Southwest China
- Open Access
- 2 May 2023
- Published by Wiley in Advanced Functional Materials
- Vol. 33 (18)
Bioinspired MXene‐Based Piezoresistive Sensor with Two‐stage Enhancement for Motion Capture (Adv. Funct. Mater. 18/2023)
- 2 May 2023
- Published by Wiley in Advanced Functional Materials
- Vol. 33 (18)
Open AccessBioinspired MXene‐Based Piezoresistive Sensor with Two‐stage Enhancement for Motion Capture (Adv. Funct. Mater. 18/2023)
- 8 March 2023
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 5 (3) , 1730-1737
Ultrathin Epidermal P(VDF-TrFE) Piezoelectric Film for Wearable Electronics
- 8 March 2023
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 5 (3) , 1730-1737
Ultrathin Epidermal P(VDF-TrFE) Piezoelectric Film for Wearable Electronics
- Open Access
- 2 September 2022
- Published by GeoScienceWorld in Lithosphere
- Vol. 2022 (1)
Late Quaternary Fault Activity of the Southern Segment of the Daliangshan Fault along the Southeastern Margin of the Tibetan Plateau and Its Implications for Fault Rupture Behaviour at Stepovers
Stepovers have been widely suggested to be important structural boundaries that control earthquake rupture extent and therefore the size of earthquakes. Previous studies suggested that ~4-5 km wide stepovers are likely to arrest fault rupture. However, recent earthquake cases show that even much wider stepovers (e.g., ≥7-8 km wide) sometimes may not effectively impede seismic rupture propagation, which requires us to further explore cascading rupture mechanism of large earthquakes at wider stepovers. Here, we constrained slip rates and paleoseismic earthquakes of two fault sections that bound a constraining stepover with width of approximately 7-8 km along the southern segment of the Daliangshan fault along the southeastern margin of the Tibetan Plateau. Multiple landform offset and radiocarbon dating results constrained that the two fault sections show a moderate slip rate at approximately 5 mm/yr. Moreover, three or four paleoseismic events Z through W, in 1489 AD, 620-515 BC, 4475-3700 BC, and 6265-4510 BC, were revealed on the Jiaojihe fault section. Based on the aforementioned results, we suggest that the most recent seismic event might exhibit a jump over the restraining stepover, whereas ruptures of the older events might be arrested by the stepover. Furthermore, we suggest that moderate slip-rate faults might have similar potential with that of high slip-rate faults to rupture through wider stepovers, which increases us in understanding the generation of cascading ruptures on strike-slip faults and is helpful for evaluating seismic hazards.
- 2 September 2022
- Published by GeoScienceWorld in Lithosphere
- Vol. 2022 (1)
Open AccessLate Quaternary Fault Activity of the Southern Segment of the Daliangshan Fault along the Southeastern Margin of the Tibetan Plateau and Its Implications for Fault Rupture Behaviour at Stepovers
Stepovers have been widely suggested to be important structural boundaries that control earthquake rupture extent and therefore the size of earthquakes. Previous studies suggested that ~4-5 km wide stepovers are likely to arrest fault rupture. However, recent earthquake cases show that even much wider stepovers (e.g., ≥7-8 km wide) sometimes may not effectively impede seismic rupture propagation, which requires us to further explore cascading rupture mechanism of large earthquakes at wider stepovers. Here, we constrained slip rates and paleoseismic earthquakes of two fault sections that bound a constraining stepover with width of approximately 7-8 km along the southern segment of the Daliangshan fault along the southeastern margin of the Tibetan Plateau. Multiple landform offset and radiocarbon dating results constrained that the two fault sections show a moderate slip rate at approximately 5 mm/yr. Moreover, three or four paleoseismic events Z through W, in 1489 AD, 620-515 BC, 4475-3700 BC, and 6265-4510 BC, were revealed on the Jiaojihe fault section. Based on the aforementioned results, we suggest that the most recent seismic event might exhibit a jump over the restraining stepover, whereas ruptures of the older events might be arrested by the stepover. Furthermore, we suggest that moderate slip-rate faults might have similar potential with that of high slip-rate faults to rupture through wider stepovers, which increases us in understanding the generation of cascading ruptures on strike-slip faults and is helpful for evaluating seismic hazards.