Kyoko Kawagishi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kyoko Kawagishi has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Toshio Osada
National Institute for Materials Science
8 shared publications Makoto Osawa
5 shared publications- Toru Hara
National Institute for Materials Science
5 shared publications - Takahito Ohmura
National Institute for Materials Science
4 shared publications - Thomas Hoefler
K1 MET GmbH, Stahlstr 14, A-4020 Linz, Austria
4 shared publications - Ayako Ikeda
Research Center for Structural Materials, National Institute for Materials Science, 1-2-1 Sengen, Tsukuba 305-0047, Ibaraki, Japan
3 shared publications
Latest Publications
- Open Access
- 13 October 2026
- Published by Elsevier in SSRN Electronic Journal
Determination of the stacking fault energy in TMS-238 Ni-based single-crystal superalloy
Tensile deformation behavior of the sixth-generation single-crystal nickel-based superalloy TMS-238 at intermediate temperature (650 °C) revealed significant differences from that of conventional superalloys. The deformation is characterized by the formation of numerous extended stacking faults within the γ matrix, resulting from the dissociation of perfect matrix dislocations into Shockley partial dislocations. Although such defects have been reported previously in similar alloys, no quantitative determination of the stacking fault energy has been reported for this specific alloy. In the present work, the stacking fault energy of TMS-238 was experimentally determined from TEM observations of dissociated dislocations. A local equilibrium was established by considering the contributions of coherency stresses associated with the γ/γ' lattice misfit, the Orowan stress related to the γ-channel width, and solid-solution strengthening. The measured stacking fault energy is found to be significantly lower than the values commonly reported for other more conventional nickel-based single-crystal superalloys. This low stacking fault energy, combined with the highly negative γ/γ' lattice misfit provides a good explanation for the unusually large dissociation width between the partial dislocations and the deformation mechanisms observed in TMS-238.
- 13 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDetermination of the stacking fault energy in TMS-238 Ni-based single-crystal superalloy
Tensile deformation behavior of the sixth-generation single-crystal nickel-based superalloy TMS-238 at intermediate temperature (650 °C) revealed significant differences from that of conventional superalloys. The deformation is characterized by the formation of numerous extended stacking faults within the γ matrix, resulting from the dissociation of perfect matrix dislocations into Shockley partial dislocations. Although such defects have been reported previously in similar alloys, no quantitative determination of the stacking fault energy has been reported for this specific alloy. In the present work, the stacking fault energy of TMS-238 was experimentally determined from TEM observations of dissociated dislocations. A local equilibrium was established by considering the contributions of coherency stresses associated with the γ/γ' lattice misfit, the Orowan stress related to the γ-channel width, and solid-solution strengthening. The measured stacking fault energy is found to be significantly lower than the values commonly reported for other more conventional nickel-based single-crystal superalloys. This low stacking fault energy, combined with the highly negative γ/γ' lattice misfit provides a good explanation for the unusually large dissociation width between the partial dislocations and the deformation mechanisms observed in TMS-238.
- Open Access
- 18 August 2026
- Published by Elsevier in Materials & Design
- Vol. 270
Automated high-throughput data collection and analysis of composition-process-structure relations by utilizing casting segregation in a Ni-base superalloy
- 18 August 2026
- Published by Elsevier in Materials & Design
- Vol. 270
Open AccessAutomated high-throughput data collection and analysis of composition-process-structure relations by utilizing casting segregation in a Ni-base superalloy
- Open Access
- 19 June 2026
- Published by Elsevier in Materials & Design
- Vol. 268
Evaluation method for the interfacial strength of thermally grown Al2O3 scale and Ni-Al alloy
- 19 June 2026
- Published by Elsevier in Materials & Design
- Vol. 268
Open AccessEvaluation method for the interfacial strength of thermally grown Al2O3 scale and Ni-Al alloy
- Open Access
- 4 June 2026
- Published by Elsevier in SSRN Electronic Journal
Automated High-throughput Data Collection and Analysis of Composition-Process-Structure Relations by Utilizing Casting Segregation in a Ni-base Superalloy
We attempt to address the problem of generating large, reliable experimental datasets that interrelate composition, processing and microstructure in a short timeframe by combining a heterogeneous sample with a gradient heat treatment. Composition-Process-Structure datasets are essential for both physical and purely statistical models aiming to predict material behavior. Using the segregated microstructure of a cast single-crystal sample of Ni-base superalloy MGA1400 in combination with a temperature gradient furnace, we cover a whole range of heat treatment temperatures and compositions according to elemental partitioning. Data collection uses automatic, correlative FE-SEM and EPMA analysis for microstructure images with corresponding local concentration. Image analysis combined with precipitate shape fitting using superellipses allows evaluation of phase fractions, precipitate size/shape/aspect distributions as well as inter-precipitate distances and relative angles for investigating clustering and alignment phenomena. As a result, we were able to generate a pseudobinary phase diagram indicating the γ′ solvus. The activation energy for coarsening of γ′ was found to be mostly independent of as-segregated composition. Further, results showed lattice misfit between the γ and γ′ phase to cause precipitate shape to vary with treatment temperature, and precipitate aspect ratio to vary between the dendrite core and interdendrite regions, indicating dendritic stresses from solidification.
- 4 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessAutomated High-throughput Data Collection and Analysis of Composition-Process-Structure Relations by Utilizing Casting Segregation in a Ni-base Superalloy
We attempt to address the problem of generating large, reliable experimental datasets that interrelate composition, processing and microstructure in a short timeframe by combining a heterogeneous sample with a gradient heat treatment. Composition-Process-Structure datasets are essential for both physical and purely statistical models aiming to predict material behavior. Using the segregated microstructure of a cast single-crystal sample of Ni-base superalloy MGA1400 in combination with a temperature gradient furnace, we cover a whole range of heat treatment temperatures and compositions according to elemental partitioning. Data collection uses automatic, correlative FE-SEM and EPMA analysis for microstructure images with corresponding local concentration. Image analysis combined with precipitate shape fitting using superellipses allows evaluation of phase fractions, precipitate size/shape/aspect distributions as well as inter-precipitate distances and relative angles for investigating clustering and alignment phenomena. As a result, we were able to generate a pseudobinary phase diagram indicating the γ′ solvus. The activation energy for coarsening of γ′ was found to be mostly independent of as-segregated composition. Further, results showed lattice misfit between the γ and γ′ phase to cause precipitate shape to vary with treatment temperature, and precipitate aspect ratio to vary between the dendrite core and interdendrite regions, indicating dendritic stresses from solidification.
- Open Access
- 20 June 2025
- Published by Elsevier in Materials & Design
- Vol. 256
Automated system for high-throughput process-structure-property dataset generation of structural materials: A γ/γ′ superalloy case study
- 20 June 2025
- Published by Elsevier in Materials & Design
- Vol. 256
Open AccessAutomated system for high-throughput process-structure-property dataset generation of structural materials: A γ/γ′ superalloy case study
- Open Access
- 29 April 2025
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 941
Elastic moduli of 6th generation Ni-base single crystal superalloy TMS-238 and its tie-lined γ and γ′ phases
- 29 April 2025
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 941
Open AccessElastic moduli of 6th generation Ni-base single crystal superalloy TMS-238 and its tie-lined γ and γ′ phases
- 2 September 2023
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 885
Short fatigue crack growth mechanism in Ni-Co based superalloy at elevated temperatures and in oxidative atmospheres
- 2 September 2023
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 885
Short fatigue crack growth mechanism in Ni-Co based superalloy at elevated temperatures and in oxidative atmospheres
- Open Access
- 16 January 2023
- Published by Elsevier in Materials & Design
- Vol. 226
Virtual heat treatment for γ-γ′ two-phase Ni-Al alloy on the materials Integration system, MInt
- 16 January 2023
- Published by Elsevier in Materials & Design
- Vol. 226
Open AccessVirtual heat treatment for γ-γ′ two-phase Ni-Al alloy on the materials Integration system, MInt
- 5 September 2022
- Published by Elsevier in Scripta Materialia
- Vol. 222, 115026
Three-dimensional high-resolution crystallographic observation of the entire volume of microstructurally small fatigue cracks in Ni-Co based superalloy
- 5 September 2022
- Published by Elsevier in Scripta Materialia
- Vol. 222, 115026
Three-dimensional high-resolution crystallographic observation of the entire volume of microstructurally small fatigue cracks in Ni-Co based superalloy
- 24 April 2022
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 53 (7) , 2452-2458
Unveiling the Mechanism of Improved Oxidation Resistance for CaO Crucible Melting Using Ni-Al Alloy
- 24 April 2022
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 53 (7) , 2452-2458
Unveiling the Mechanism of Improved Oxidation Resistance for CaO Crucible Melting Using Ni-Al Alloy