ICIndrojeet Chakraborty

Indrojeet Chakraborty

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Indrojeet Chakraborty has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A q‐Z Source‐Based Modified Bidirectional Three‐Port Converter for Battery‐Assisted Solar PV Applications

    by Indrojeet Chakraborty, Sreejith S, Sovit Kumar Pradhan

    In this paper, two separate q‐Z source‐based three‐port converters (TPC) with modified bidirectional networks (BDNs) that offer significant voltage gain for photovoltaic (PV)‐battery applications are proposed. Both designs allow the converter operation to be carried out in four different modes where the power from primary source can flow to the battery as well as the load and the battery alone can also feed power to the load, at lower duty cycle. The designs are based on a q‐Z source converter and use a modified bidirectional path to accommodate the battery port. The main advantage of using one of the two proposed topology is that it provides a common ground for the primary source input (PV), the bidirectional energy storage port, and the output port. In addition to the above mentioned four modes of operation, in the proposed topology, an external switch can be used to charge the battery from the PV source in the absence of the load as well. On the basis of these two distinct advantages, one of the two designs is analyzed in detail. A noncomplex control algorithm is designed to facilitate the battery operation depending upon load power requirement. There are two different duty ratios to control the operation of five MOSFETs to regulate the output voltage. In addition, the converter offers suitable features such as low voltage stress (V) across devices, continuous input current, and common ground (comm.g.) for all three ports, to be used for renewable energy source (RES) applications. The validation of the analytical analysis of the converter is done in a Matlab simulink environment, and the results are presented. For validating the performance of the proposed converter, a 250‐V, 450‐W prototype is implemented and tested at 10 kHz. The converter in stand‐alone mode can attain an efficiency of around 94.5%.


  • A High Gain Enhanced Boost Bidirectional DC-DC Converter for Battery-Supercapacitor Applications

    by Indrojeet Chakraborty, Sreejith S, Sovit Kumar Pradhan

    In this paper, an Enhanced Bidirectional Boost DC-DC Converter (EBBDC) offering high voltage gain with reduced switch voltage stresses is presented. The converter uses a lesser number of components as compared to similar bidirectional topologies. It is suitable for battery/ supercapacitor charging-discharging applications in hybrid energy storage systems. The EBBDC is a non-isolated topology having a common ground for input and output which makes it suitable for use in other industrial control applications. The steady-state operation is discussed in detail for both step-up and step-down modes, as well as the small signal analysis for the converter is carried out in this paper. To corroborate the theoretical analysis of the EBBDC, a 200W, 200V prototype is tested in PSIM and the results are presented.

  • A novel non-isolated high gain multiport DC-DC converter for integrating fuel cell/solar PV and battery energy storage system

    by Sovit Kumar Pradhan, Sreejith Sekaran, Indrojeet Chakraborty

    This paper presents a novel non-isolated capacitor-assisted quasi-Z-source (CA-QZS) multiport DC-DC boost converter, which operates as a dual-input single-output high gain boost converter. It consists of a bidirectional port for the smooth operation of the energy storage system, and a unidirectional port for the solar/fuel cell to deliver power to the battery and the load. The availability of common ground between input and output ports, high voltage conversion ratio, and continuous current of the unidirectional port are the main features of this novel design, making it suitable for a wider range of applications. A typical switching strategy is followed to regulate the output voltage as well as control input power from the sources. As a battery-incorporated system, the converter’s performance is determined by its selection between three operating modes. Therefore, the CA-QZS converter offers a viable interface for the management of battery energy storage systems. A comparative study is performed with other multi-port converters to highlight the advantages. It is observed that the voltage conversion ratio of 10, can be achieved at a low duty ratio of 0.3. To evaluate the effectiveness of the proposed topology, a prototype is developed with a nominal output power rating of 200W and an output voltage of 200 V.


  • An enhanced DC-DC boost converter based stand-alone PV-Battery OFF-Grid system with voltage balancing capability for fluctuating environmental and load conditions

    by Indrojeet Chakraborty, Sreejith Sekaran, Sovit Kumar Pradhan

    There is a requirement for a suitable DC-DC converter which can exhibit satisfactory performance in the case of OFF-Grid PV systems. This paper proposes a PV-Battery stand-alone system with an enhanced DC-DC boost converter and an efficient voltage balancing technique. The converter is designed to achieve the desired voltage gain at a lower duty-ratio as compared to the existing converter topology used in conventional stand-alone systems, thereby reducing the voltage stress across the switching devices. For extracting maximum power from the solar panel at every given point of operation, the Incremental Conductance Technique is used. A non-complex voltage balancing technique maintains the DC bus voltage constant with fast dynamic response. The system is highly reliable in case of converter fault and exhibits less initial transient time each time it is put to test. The performance of the proposed system is tested under varying input and varying load conditions with maximum overall system efficiency of around 93%. The stability of the system is investigated using a small signal model of the converter. The proposed stand-alone PV/Battery system is designed to handle a 1 KW load at 180 V DC voltage fed by 1.5 KW solar panel and 100Ah/24 V Li-ion Battery. The dynamic performance of the proposed system is verified through OPAL-RT 4510 platform.