Arshid Mir
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Arshid Mir has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
Reyaz Ahmad
Department of Physics, National Institute of Technology Srinagar, Dargah Hazratbal, Srinagar, Jammu and Kashmir, 190006, INDIA
6 shared publications- Aamir Sohail
Laboratory for Multifunctional Nanomaterials (LMN), P G Department of Physics, National Institute Technology, Srinagar, India
4 shared publications Asif Majeed
4 shared publicationsKhalid bin Masood
4 shared publicationsM. A. Shah
National Institute Technology Srinagar
4 shared publicationsSadaf Jamal Gilani
Department of Pharmaceutical Sciences, College of Pharmacy, Princess Nourah Bint Abdulrahman University, Riyadh, Saudi Arabia
4 shared publications
Latest Publications
- 1 November 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (31) , 2353
Ag-Induced localization and magnetic suppression in La0.7Sr0.3−xCoO3 cobaltites
- 1 November 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (31) , 2353
Ag-Induced localization and magnetic suppression in La0.7Sr0.3−xCoO3 cobaltites
- 7 May 2026
- Published by Elsevier in Micro and Nanostructures
- Vol. 216
Defect engineering in nitrogen-doped TiO2 nanotube arrays for enhanced supercapacitor performance
- 7 May 2026
- Published by Elsevier in Micro and Nanostructures
- Vol. 216
Defect engineering in nitrogen-doped TiO2 nanotube arrays for enhanced supercapacitor performance
- Open Access
- 17 February 2026
- Published by Elsevier in SSRN Electronic Journal
Defect Engineering in Nitrogen-Doped TiO2 Nanotube Arrays for Enhanced Supercapacitor Performance
Highly ordered TiO2 nanotube arrays were fabricated via a two-step anodization process and subsequently modified through controlled nitrogen doping using ammonia annealing to evaluate their suitability as supercapacitor electrodes. The effect of nitrogen concentration (0–3%) on the structural, morphological, and electrochemical properties of TiO2 nanotubes was systematically investigated. X-ray diffraction and Raman spectroscopy confirm that nitrogen incorporation induces lattice distortion and defect formation while preserving the anatase TiO2 framework. Electrochemical measurements reveal a significant enhancement in charge storage performance upon nitrogen doping, with the 2% N-doped electrode exhibiting the highest areal capacitance of ~767 mF cm−2 from cyclic voltammetry and ~733 mF cm−2 from galvanostatic charge–discharge analysis. Electrochemical impedance spectroscopy demonstrates reduced charge-transfer resistance and improved ion diffusion for the optimally doped electrode. Furthermore, the 2% N-doped TiO2 nanotube electrode shows excellent cycling stability, retaining ~94% of its initial capacitance after 5000 cycles. The improved electrochemical performance is attributed to optimized defect density, enhanced electronic conductivity, and efficient ion transport. These results demonstrate that controlled nitrogen doping is an effective strategy for improving the charge storage characteristics of TiO2 nanotube-based supercapacitor electrodes.
- 17 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDefect Engineering in Nitrogen-Doped TiO2 Nanotube Arrays for Enhanced Supercapacitor Performance
Highly ordered TiO2 nanotube arrays were fabricated via a two-step anodization process and subsequently modified through controlled nitrogen doping using ammonia annealing to evaluate their suitability as supercapacitor electrodes. The effect of nitrogen concentration (0–3%) on the structural, morphological, and electrochemical properties of TiO2 nanotubes was systematically investigated. X-ray diffraction and Raman spectroscopy confirm that nitrogen incorporation induces lattice distortion and defect formation while preserving the anatase TiO2 framework. Electrochemical measurements reveal a significant enhancement in charge storage performance upon nitrogen doping, with the 2% N-doped electrode exhibiting the highest areal capacitance of ~767 mF cm−2 from cyclic voltammetry and ~733 mF cm−2 from galvanostatic charge–discharge analysis. Electrochemical impedance spectroscopy demonstrates reduced charge-transfer resistance and improved ion diffusion for the optimally doped electrode. Furthermore, the 2% N-doped TiO2 nanotube electrode shows excellent cycling stability, retaining ~94% of its initial capacitance after 5000 cycles. The improved electrochemical performance is attributed to optimized defect density, enhanced electronic conductivity, and efficient ion transport. These results demonstrate that controlled nitrogen doping is an effective strategy for improving the charge storage characteristics of TiO2 nanotube-based supercapacitor electrodes.
- 7 November 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 546
Strategic Ti³⁺ incorporation in TiO₂ nanotube arrays via microwave-promoted borohydride reduction for high-performance energy storage
- 7 November 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 546
Strategic Ti³⁺ incorporation in TiO₂ nanotube arrays via microwave-promoted borohydride reduction for high-performance energy storage
- 17 October 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (11) , 1-16
Crystallite-engineered NiO nanoparticles via co-precipitation for high-performance ethanol gas sensing
- 17 October 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (11) , 1-16
Crystallite-engineered NiO nanoparticles via co-precipitation for high-performance ethanol gas sensing
- 7 August 2025
- Published by Springer Nature in Journal of Electronic Materials
- p. 1-10
A Comparative Investigation of Optimizing Fe- and N-Doped TiO2 Photoanodes
- 7 August 2025
- Published by Springer Nature in Journal of Electronic Materials
- p. 1-10
A Comparative Investigation of Optimizing Fe- and N-Doped TiO2 Photoanodes
- Open Access
- 20 November 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 35 (6) , 065401
P–N heterojunction NiO/ZnO nanowire based electrode for asymmetric supercapacitor applications
Nickel-based oxides are selected for their inexpensive cost, well-defined redox activity, and flexibility in adjusting nanostructures via optimization of the synthesis process. This communique explores the field of energy storage for hydrothermally synthesized NiO/ZnO nanowires by analysing their capacitive behaviour. The p-type NiO was successfully built onto the well-ordered mesoporous n-type ZnO matrix, resulting in the formation of p–n heterojunction artefacts with porous nanowire architectures. NiO/ZnO nanowire-based electrodes exhibited much higher electrochemical characteristics than bare NiO nanowires. The heterojunction at the interface between the NiO and ZnO nanoparticles, their specific surface area, as well as their combined synergetic influence, are accountable for the high specific capacitance (C s) of 1135 Fg−1 at a scan rate of 5 mV s−1. NiO/ZnO nanowires show an 18% dip in initial capacitance even after 6000 cycles, indicating excellent capacitance retention and low resistance validated by electrochemical impedance spectroscopy. In addition, the specific capacitance, energy and power density of the solid state asymmetric capacitor that was manufactured by employing NiO/ZnO as the positive electrode and activated carbon as the negative electrode were found to be 87 Fg−1, 23 Whkg−1 and 614 Wkg−1, respectively. The novel electrode based on NiO/ZnO demonstrates excellent electrochemical characteristics all of which point to its promising application in supercapacitor devices.
- 20 November 2023
- Published by IOP Publishing in Nanotechnology
- Vol. 35 (6) , 065401
Open AccessP–N heterojunction NiO/ZnO nanowire based electrode for asymmetric supercapacitor applications
Nickel-based oxides are selected for their inexpensive cost, well-defined redox activity, and flexibility in adjusting nanostructures via optimization of the synthesis process. This communique explores the field of energy storage for hydrothermally synthesized NiO/ZnO nanowires by analysing their capacitive behaviour. The p-type NiO was successfully built onto the well-ordered mesoporous n-type ZnO matrix, resulting in the formation of p–n heterojunction artefacts with porous nanowire architectures. NiO/ZnO nanowire-based electrodes exhibited much higher electrochemical characteristics than bare NiO nanowires. The heterojunction at the interface between the NiO and ZnO nanoparticles, their specific surface area, as well as their combined synergetic influence, are accountable for the high specific capacitance (C s) of 1135 Fg−1 at a scan rate of 5 mV s−1. NiO/ZnO nanowires show an 18% dip in initial capacitance even after 6000 cycles, indicating excellent capacitance retention and low resistance validated by electrochemical impedance spectroscopy. In addition, the specific capacitance, energy and power density of the solid state asymmetric capacitor that was manufactured by employing NiO/ZnO as the positive electrode and activated carbon as the negative electrode were found to be 87 Fg−1, 23 Whkg−1 and 614 Wkg−1, respectively. The novel electrode based on NiO/ZnO demonstrates excellent electrochemical characteristics all of which point to its promising application in supercapacitor devices.
- 8 September 2023
- Published by Springer Nature
- p. 277-282
Photoelectrochemical Response of Titania Photoanode Fabricated via Microwave Irradiation
- 8 September 2023
- Published by Springer Nature
- p. 277-282
Photoelectrochemical Response of Titania Photoanode Fabricated via Microwave Irradiation
- 29 August 2023
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 28 (1) , 1-18
Tin (Sn)-doped hematite (α-SnxFe2-xO3) nanostructures as high-performance electrodes for supercapacitor application
- 29 August 2023
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 28 (1) , 1-18
Tin (Sn)-doped hematite (α-SnxFe2-xO3) nanostructures as high-performance electrodes for supercapacitor application
- 1 February 2023
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 12 (2) , 021007
Microwave-Assisted Hydrothermal Synthesis of Fe-Doped TiO2 Photoanode for Photocatalytic Hydrogen Evolution
One-dimensional TiO2 nanostructures like nanotubes, nanowires, and nanorods have received huge attention due to their photocatalytic hydrogen-generating ability. However, its wide band gap and high charge carrier recombination rate hampered the efficiency with which it converts solar energy into hydrogen. To improve this application, metallic doping employing a quick and easy synthesis method should be proposed. In this study, we report on the microwave-assisted hydrothermal synthesis of iron-doped TiO2 nanowires on an FTO substrate. The formation of TiO2 nano-wires was validated by structural and morphological analysis carried out using XRD and SEM imaging respectively. EDX was employed to provide a breakdown of their chemical composition to verify the presence of dopants in the samples. The impact of Fe-doping on optical and photoelectrochemical properties was studied. Electrochemical impedance spectroscopy was used to determine the mechanisms behind charge accumulation and charge transfer properties. The Mott-Schottky plot was used to examine the donor density and the flat-band potential of the pristine and Fe-doped TiO2 samples.
- 1 February 2023
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 12 (2) , 021007
Microwave-Assisted Hydrothermal Synthesis of Fe-Doped TiO2 Photoanode for Photocatalytic Hydrogen Evolution
One-dimensional TiO2 nanostructures like nanotubes, nanowires, and nanorods have received huge attention due to their photocatalytic hydrogen-generating ability. However, its wide band gap and high charge carrier recombination rate hampered the efficiency with which it converts solar energy into hydrogen. To improve this application, metallic doping employing a quick and easy synthesis method should be proposed. In this study, we report on the microwave-assisted hydrothermal synthesis of iron-doped TiO2 nanowires on an FTO substrate. The formation of TiO2 nano-wires was validated by structural and morphological analysis carried out using XRD and SEM imaging respectively. EDX was employed to provide a breakdown of their chemical composition to verify the presence of dopants in the samples. The impact of Fe-doping on optical and photoelectrochemical properties was studied. Electrochemical impedance spectroscopy was used to determine the mechanisms behind charge accumulation and charge transfer properties. The Mott-Schottky plot was used to examine the donor density and the flat-band potential of the pristine and Fe-doped TiO2 samples.