Ying Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ying Zhang has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Kexin Li
School of Automation and Information Engineering, Xi’an University of Technology, Xi’an 710048, China
2 shared publications - Yufeng Yang
School of Automation and Information Engineering, Xi’an University of Technology, Xi’an 710048, China
2 shared publications - Haibo Mou1 shared publication
- Haibo Mou
School of Automation and Information Engineering, Xi’an University of Technology, Xi’an 710048, China
1 shared publication - Jiawei Ren1 shared publication
- Jiawei Ren
School of Automation and Information Engineering, Xi’an University of Technology, Xi’an 710048, China
1 shared publication
Latest Publications
- Open Access
Orthogonal Frequency Division Multiplexing for Visible Light Communication Based on Minimum Shift Keying Modulation
With the rapid development of visible light communication (VLC) technology, traditional modulation schemes can no longer meet the high demands for bandwidth efficiency and signal stability in complex application scenarios. In particular, in orthogonal frequency division multiplexing (OFDM) systems, issues such as the nonlinearity of Light-Emitting Diodes (LEDs) and carrier frequency offset have worsened system performance. To address these challenges, this paper proposes an N-order Minimum Shift Keying (NMSK) OFDM system with Fast Hartley Transform (FHT) for signal mapping. Monte Carlo simulations systematically compare the performance of low-order and high-order NMSK modulations under various conditions. The results indicate that low-order NMSK exhibits superior robustness against bit errors and interference, while high-order NMSK can maintain a stable PAPR and provide higher spectral efficiency in high-bandwidth demand scenarios. Further experiments validate the stability of high-order NMSK in high-density multi-user and Industrial Internet of Things (IIoT) environments, proving its adaptability and effectiveness in such scenarios. The high-order NMSK modulation scheme provides strong support for the reliability and bandwidth efficiency of future 6G VLC networks, offering significant application prospects.
Open AccessOrthogonal Frequency Division Multiplexing for Visible Light Communication Based on Minimum Shift Keying Modulation
With the rapid development of visible light communication (VLC) technology, traditional modulation schemes can no longer meet the high demands for bandwidth efficiency and signal stability in complex application scenarios. In particular, in orthogonal frequency division multiplexing (OFDM) systems, issues such as the nonlinearity of Light-Emitting Diodes (LEDs) and carrier frequency offset have worsened system performance. To address these challenges, this paper proposes an N-order Minimum Shift Keying (NMSK) OFDM system with Fast Hartley Transform (FHT) for signal mapping. Monte Carlo simulations systematically compare the performance of low-order and high-order NMSK modulations under various conditions. The results indicate that low-order NMSK exhibits superior robustness against bit errors and interference, while high-order NMSK can maintain a stable PAPR and provide higher spectral efficiency in high-bandwidth demand scenarios. Further experiments validate the stability of high-order NMSK in high-density multi-user and Industrial Internet of Things (IIoT) environments, proving its adaptability and effectiveness in such scenarios. The high-order NMSK modulation scheme provides strong support for the reliability and bandwidth efficiency of future 6G VLC networks, offering significant application prospects.
- Open Access
Performance Analysis of a Single Light Source Bidirectional Visible Light Communication Reverse Reflection Link
Visible light communication has the advantages of large bandwidth, high security, and no RF interference, among which LED light sources are an important light source for indoor visible light communication. The use of LED as a light source for visible full-duplex communication is both to meet the lighting requirements and to ensure high-speed transmission of information. The uplink using the “cat’s eye” reverse modulation system can greatly reduce the system complexity of the reverse reflector. In order to analyze the factors affecting the optical power at the receiving end of the uplink of the indoor single light source visible light communication, this paper establishes the indoor visible light full-duplex communication system model and deduces the calculation method of the effective incidence angle of the uplink transmission light and the movable range of the reverse reflection end according to the model. The results show that when the link distance of the BK7 lens is 3 m, the lens aperture is increased from 100 mm to 150 mm, the lens focal length is increased from 100 mm to 150 mm, the travel distance of the reverse reflector is increased by 60%, and the effective range of the incidence angle is increased by about twice. In the absence of link loss, each 1 m increase in link distance increases the maximum travel distance of the reverse reflector by 0.8 m. Increasing the lens aperture, decreasing the focal length, and increasing the link distance can improve the movable range of the reverse reflector, and the effective incidence angle changes more gently with the position of the reverse reflector.
Open AccessPerformance Analysis of a Single Light Source Bidirectional Visible Light Communication Reverse Reflection Link
Visible light communication has the advantages of large bandwidth, high security, and no RF interference, among which LED light sources are an important light source for indoor visible light communication. The use of LED as a light source for visible full-duplex communication is both to meet the lighting requirements and to ensure high-speed transmission of information. The uplink using the “cat’s eye” reverse modulation system can greatly reduce the system complexity of the reverse reflector. In order to analyze the factors affecting the optical power at the receiving end of the uplink of the indoor single light source visible light communication, this paper establishes the indoor visible light full-duplex communication system model and deduces the calculation method of the effective incidence angle of the uplink transmission light and the movable range of the reverse reflection end according to the model. The results show that when the link distance of the BK7 lens is 3 m, the lens aperture is increased from 100 mm to 150 mm, the lens focal length is increased from 100 mm to 150 mm, the travel distance of the reverse reflector is increased by 60%, and the effective range of the incidence angle is increased by about twice. In the absence of link loss, each 1 m increase in link distance increases the maximum travel distance of the reverse reflector by 0.8 m. Increasing the lens aperture, decreasing the focal length, and increasing the link distance can improve the movable range of the reverse reflector, and the effective incidence angle changes more gently with the position of the reverse reflector.
- Open Access
- 10 November 2023
- Published by MDPI AG in Preprints.org
Performance Analysis of Single Light Source Bidirectional Visible Light Communication Reverse Reflection Link
The LED light source is an important light source for indoor visible light communication. It has the characteristics of a large divergence angle and a high transmission rate. Therefore, using LED as the light source for visible light full-duplex communication can not only satisfy the lighting requirements but also transmit information at high speed. To analyze the factors that affect the optical power of the indoor single-light source visible light communication uplink receiving end, an indoor visible light communication model was established, and mathematical calculation formulas were derived based on the model establishment, and the maximum movable range formula of the retroreflective end under specific conditions was derived; The reliability of the formula was verified with the help of Zemax simulation software. Theoretical analysis and experimental results show that increasing the movement range of the retroreflective end can be achieved by increasing the lens diameter, reducing the focal length, and increasing the link distance.
- 10 November 2023
- Published by MDPI AG in Preprints.org
Open AccessPerformance Analysis of Single Light Source Bidirectional Visible Light Communication Reverse Reflection Link
The LED light source is an important light source for indoor visible light communication. It has the characteristics of a large divergence angle and a high transmission rate. Therefore, using LED as the light source for visible light full-duplex communication can not only satisfy the lighting requirements but also transmit information at high speed. To analyze the factors that affect the optical power of the indoor single-light source visible light communication uplink receiving end, an indoor visible light communication model was established, and mathematical calculation formulas were derived based on the model establishment, and the maximum movable range formula of the retroreflective end under specific conditions was derived; The reliability of the formula was verified with the help of Zemax simulation software. Theoretical analysis and experimental results show that increasing the movement range of the retroreflective end can be achieved by increasing the lens diameter, reducing the focal length, and increasing the link distance.
- Open Access
- 23 May 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (11) , 6356
Shadow Effect of Human Obstacles on Indoor Visible Light Communication System with Multiple Light Sources
When the direct visible-light channel is affected by people walking or other obstacles, the shadow effect formed in the receiver space affects communication performance and can even lead to communication interruption. In this paper, two numerical methods for calculating the shadow area of the human body were proposed for an indoor multi-light communication system. The influence of shadows on system performance was analyzed using the mean square errors of illuminance and signal-to-noise ratio, as well as the interrupt probability, as parameters. The results showed that shadows had a great influence on the performance of the visible-light communication system. When the number of light sources was fixed, the shadow effect could be effectively reduced by optimizing the layout of the light sources. These research results can provide a theoretical basis for improving the stability of visible-light communication systems.
- 23 May 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (11) , 6356
Open AccessShadow Effect of Human Obstacles on Indoor Visible Light Communication System with Multiple Light Sources
When the direct visible-light channel is affected by people walking or other obstacles, the shadow effect formed in the receiver space affects communication performance and can even lead to communication interruption. In this paper, two numerical methods for calculating the shadow area of the human body were proposed for an indoor multi-light communication system. The influence of shadows on system performance was analyzed using the mean square errors of illuminance and signal-to-noise ratio, as well as the interrupt probability, as parameters. The results showed that shadows had a great influence on the performance of the visible-light communication system. When the number of light sources was fixed, the shadow effect could be effectively reduced by optimizing the layout of the light sources. These research results can provide a theoretical basis for improving the stability of visible-light communication systems.
- 17 January 2018
- Published by Springer Nature in Photonic Network Communications
- Vol. 35 (3) , 316-324
Connectivity properties for UAVs networks in wireless ultraviolet communication
- 17 January 2018
- Published by Springer Nature in Photonic Network Communications
- Vol. 35 (3) , 316-324
Connectivity properties for UAVs networks in wireless ultraviolet communication