A. Tayel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
A. Tayel has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed B. El Basaty
Basic Science Department Faculty of Technology and Education Capital University (Formerly Helwan University) Cairo Egypt
2 shared publications - Abdelmoneim Saleh
Basic Science Department, Higher Technological Institute, 10th of Ramadan City, Egypt
1 shared publication - Ahmed Abdel Moez
Solid State Electronics Laboratory, Solid State Physics Department, Physics Research Division, National Research Centre, 33 El-Bohouth Street, Dokki, Giza 12622, Egypt
1 shared publication Ahmed I. Ali
1 shared publication- Ahmed Ibrahim Ali
Department of Basic Science, Faculty of Technology and Education, Helwan University, Cairo, Egypt
1 shared publication - Ahmed M. Deghady
Basic Science Department, Higher Technological Institute, 10th of Ramadan City, Cairo, Egypt
1 shared publication
Latest Publications
- 21 September 2022
- Published by IOP Publishing in Physica Scripta
- Vol. 97 (10) , 105709
Effect of 0.3 wt% TiO 2 nanoparticles on the thermal, structural, and mechanical properties of Sn 3.8 Ag 0.7 Cu 1.0 Zn solder alloy
The Sn–3.8Ag-0.7Cu −1.0 wt% Zn (SACZ) plain solder alloy was reinforced by 0.3 wt% of TiO 2 nanoparticles (NP). SEM, XRD, DSC, and stress-strain characterization techniques were used to examine the synthesized samples. The morphology of the samples is uniform and the grain size of the SACZ-TiO 2 sample is refined compared to the plain solder. The TiO 2 addition improved the crystallinity of the SACZ sample. Furthermore, the melting temperature of the prepared samples has the same value even if its pasty range is decreased by adding TiO 2 NP. The mechanical properties of the examined samples were investigated at different temperatures and different strain rates. The activation energy (Q) of the SACZ-TiO 2 is lower than that of the SACZ sample. The results of this study confirm that the 0.3 wt% TiO 2 addition improves the physical properties of SACZ alloy.
- 21 September 2022
- Published by IOP Publishing in Physica Scripta
- Vol. 97 (10) , 105709
Effect of 0.3 wt% TiO 2 nanoparticles on the thermal, structural, and mechanical properties of Sn 3.8 Ag 0.7 Cu 1.0 Zn solder alloy
The Sn–3.8Ag-0.7Cu −1.0 wt% Zn (SACZ) plain solder alloy was reinforced by 0.3 wt% of TiO 2 nanoparticles (NP). SEM, XRD, DSC, and stress-strain characterization techniques were used to examine the synthesized samples. The morphology of the samples is uniform and the grain size of the SACZ-TiO 2 sample is refined compared to the plain solder. The TiO 2 addition improved the crystallinity of the SACZ sample. Furthermore, the melting temperature of the prepared samples has the same value even if its pasty range is decreased by adding TiO 2 NP. The mechanical properties of the examined samples were investigated at different temperatures and different strain rates. The activation energy (Q) of the SACZ-TiO 2 is lower than that of the SACZ sample. The results of this study confirm that the 0.3 wt% TiO 2 addition improves the physical properties of SACZ alloy.
- 11 June 2021
- Published by IOP Publishing in Chinese Physics B
- Vol. 31 (1) , 018103
Synthesis and study the influence of yttrium doping on band structure, optical, non-linear optical and dielectric results for Ca12Al14O33 (C12A7) single crystals grown using traveling-solvent floating zone (TSFZ) method
Ca12Al14O33 (C12A7) and Y0.02Ca11.98Al14O33 (Y-C12A7) single crystals were grown by using the traveling-solvent floating zone (TSFZ) method. The temperature was increased to avoid the bubbles and cracks which may be formed during the preparation of the ingot material. We have started with the flux higher than the normal to avoid the bubbles and make good treatment for the solid-liquid interface. The structures of both Ca12Al14O33 (C12A7) and Y0.02Ca11.98Al14O33 (Y-C12A7) were studied by using x-ray diffraction (XRD). Optical properties for C12A7 and Y-C12A7 single crystals have been studied in order to determine the optical parameters such as optical energy gap (E g), refractive index n, oscillating energy (E o), dispersion energy (E d), volume energy loss function (VELF), and surface energy loss function (SELF). Finally, a new result for these samples is that the third-order nonlinear optical susceptibility (χ (3)) was determined. The results have been discussed with effect of Y-doping on the C12A7 single crystals for optical and industrial applications.
- 11 June 2021
- Published by IOP Publishing in Chinese Physics B
- Vol. 31 (1) , 018103
Synthesis and study the influence of yttrium doping on band structure, optical, non-linear optical and dielectric results for Ca12Al14O33 (C12A7) single crystals grown using traveling-solvent floating zone (TSFZ) method
Ca12Al14O33 (C12A7) and Y0.02Ca11.98Al14O33 (Y-C12A7) single crystals were grown by using the traveling-solvent floating zone (TSFZ) method. The temperature was increased to avoid the bubbles and cracks which may be formed during the preparation of the ingot material. We have started with the flux higher than the normal to avoid the bubbles and make good treatment for the solid-liquid interface. The structures of both Ca12Al14O33 (C12A7) and Y0.02Ca11.98Al14O33 (Y-C12A7) were studied by using x-ray diffraction (XRD). Optical properties for C12A7 and Y-C12A7 single crystals have been studied in order to determine the optical parameters such as optical energy gap (E g), refractive index n, oscillating energy (E o), dispersion energy (E d), volume energy loss function (VELF), and surface energy loss function (SELF). Finally, a new result for these samples is that the third-order nonlinear optical susceptibility (χ (3)) was determined. The results have been discussed with effect of Y-doping on the C12A7 single crystals for optical and industrial applications.