Yuqian Bao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yuqian Bao has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Wenbo Yang
School of Electrical Engineering, Xidian University, Xian, China
4 shared publications Hui Wu
School of Electrical Engineering, Xidian University, Xian, China
3 shared publicationsGaogao Liu
School of Electronic and Engineering Xidian University Xi'an China
2 shared publications- Gaogao Liu
School of Electronic Engineering, Xidian University, Xi’an 710071, China
2 shared publications - Youming Wang
School of Electrical Engineering, Xidian University, Xian, China
2 shared publications Ning Yue
School of Electronic and Engineering Xidian University Xi'an China
1 shared publication
Latest Publications
- 2 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 20 (1545598X) , 1-5
Implementation of MIMO-SAR Imaging Based on Jamming Signal
Special attention has been devoted to joint waveforms based on radar signals to mitigate the tension of spectrum resources and simultaneously play a multifunctional role. Aiming at the shortcomings of conventional detection and jamming dual-functional systems where wide beams are difficult to detect with high accuracy, while narrow beams are difficult to cover a wide range of jamming, this letter designs a MIMO-SAR system with jamming capabilities. The characteristic of this signal is to use MIMO system multiple antennas to transmit frequency diversity wideband code division jamming signals to effectively generate wideband suppression jamming for conventional radars, including frequency-agile radars. At the same time, the wide beam characteristics of MIMO antennas can ensure the physical range of jamming. In addition, for the imaging part, DBF technology can be used to form the beam in a specific direction at the receiving end, resulting in high resolution. Simulation experiments confirm the system’s ability to achieve high-resolution imaging of specific target areas while maintaining robust jamming capabilities.
- 2 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 20 (1545598X) , 1-5
Implementation of MIMO-SAR Imaging Based on Jamming Signal
Special attention has been devoted to joint waveforms based on radar signals to mitigate the tension of spectrum resources and simultaneously play a multifunctional role. Aiming at the shortcomings of conventional detection and jamming dual-functional systems where wide beams are difficult to detect with high accuracy, while narrow beams are difficult to cover a wide range of jamming, this letter designs a MIMO-SAR system with jamming capabilities. The characteristic of this signal is to use MIMO system multiple antennas to transmit frequency diversity wideband code division jamming signals to effectively generate wideband suppression jamming for conventional radars, including frequency-agile radars. At the same time, the wide beam characteristics of MIMO antennas can ensure the physical range of jamming. In addition, for the imaging part, DBF technology can be used to form the beam in a specific direction at the receiving end, resulting in high resolution. Simulation experiments confirm the system’s ability to achieve high-resolution imaging of specific target areas while maintaining robust jamming capabilities.
- Open Access
- 10 August 2023
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 17 (10) , 1524-1537
A GPU‐based real‐time processing system for frequency division multiple‐input‐multiple‐output radar
Multiple‐Input‐Multiple‐Output (MIMO) radar has the characteristic of multiple antenna channels, bringing on a big data volume for signal processing. Therefore, the trade‐off between detection ability and computational efficiency is always considered. In this article, an optimisation system is proposed to enhance the real‐time performance of frequency division MIMO radar without compromising accuracy. For the scenario of low‐altitude small target detection, a signal processing acceleration method is proposed and a MIMO radar optimisation system based on graphics processing unit (GPU) architecture is built. The signal model of frequency division MIMO radar is first established, improving the classical signal processing flow efficiency from the perspective of reducing fast Fourier transform (FFT) times and windowing operation times. To achieve an advanced acceleration, the parallel architecture of ArrayFire‐library in GPU is then employed. Distinct minimum parallel units are extracted by analysing the principle of digital beamforming (DBF), pulse compression, moving target detection (MTD), and constant false‐alarm rate (CFAR) algorithms. And the corresponding parallel algorithms are designed to constitute a parallel acceleration system of frequency division MIMO. Simulation results indicate that the proposed method significantly improves the efficiency of MIMO system with a maximum acceleration ratio of 65 times, meeting the real‐time processing requirements.
- 10 August 2023
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 17 (10) , 1524-1537
Open AccessA GPU‐based real‐time processing system for frequency division multiple‐input‐multiple‐output radar
Multiple‐Input‐Multiple‐Output (MIMO) radar has the characteristic of multiple antenna channels, bringing on a big data volume for signal processing. Therefore, the trade‐off between detection ability and computational efficiency is always considered. In this article, an optimisation system is proposed to enhance the real‐time performance of frequency division MIMO radar without compromising accuracy. For the scenario of low‐altitude small target detection, a signal processing acceleration method is proposed and a MIMO radar optimisation system based on graphics processing unit (GPU) architecture is built. The signal model of frequency division MIMO radar is first established, improving the classical signal processing flow efficiency from the perspective of reducing fast Fourier transform (FFT) times and windowing operation times. To achieve an advanced acceleration, the parallel architecture of ArrayFire‐library in GPU is then employed. Distinct minimum parallel units are extracted by analysing the principle of digital beamforming (DBF), pulse compression, moving target detection (MTD), and constant false‐alarm rate (CFAR) algorithms. And the corresponding parallel algorithms are designed to constitute a parallel acceleration system of frequency division MIMO. Simulation results indicate that the proposed method significantly improves the efficiency of MIMO system with a maximum acceleration ratio of 65 times, meeting the real‐time processing requirements.
- 7 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 20 (1545598X) , 1-5
MIMO FBMC-Based Joint Radar Imaging and Electronic Jamming
A novel waveform for joint imaging and jamming based on multiple-input multiple-output (MIMO) frequency division multicarrier modulation is proposed in this letter. The frequency division signal of the MIMO system can increase the jamming bandwidth. Since multiple forwarding will form multiple frequency points, forming frequency division MIMO and reducing the effect of anti-jamming measures such as frequency hopping. For inverse synthetic aperture radar (ISAR), the digital beamforming (DBF) of MIMO radar can perform beam direction in a specific direction during signal processing, so that it has high-resolution imaging capability. The results show that the proposed waveform for the joint radar imaging and electronical jamming can simultaneously perform high-resolution imaging under the premise of satisfying the jamming capability.
- 7 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 20 (1545598X) , 1-5
MIMO FBMC-Based Joint Radar Imaging and Electronic Jamming
A novel waveform for joint imaging and jamming based on multiple-input multiple-output (MIMO) frequency division multicarrier modulation is proposed in this letter. The frequency division signal of the MIMO system can increase the jamming bandwidth. Since multiple forwarding will form multiple frequency points, forming frequency division MIMO and reducing the effect of anti-jamming measures such as frequency hopping. For inverse synthetic aperture radar (ISAR), the digital beamforming (DBF) of MIMO radar can perform beam direction in a specific direction during signal processing, so that it has high-resolution imaging capability. The results show that the proposed waveform for the joint radar imaging and electronical jamming can simultaneously perform high-resolution imaging under the premise of satisfying the jamming capability.
- Open Access
- 9 September 2022
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 17 (1) , 47-62
Joint radar communication system design based on filter bank multicarrier modulation scheme
Since orthogonal frequency division multiplexing (OFDM) signals are sensitive to Doppler shift, OFDM signals with cyclic prefix (CP) not only reduce the communication rate but also result in symmetric pseudo peaks in the ambiguity function of the radar, which eventually lead to the degradation of the performance of the joint radar communication system (JRCS). In this study, a novel JRCS is proposed based on the filter bank multicarrier (FBMC) waveform for the inverse synthetic aperture radar (ISAR) imaging and communication system. On the one hand, FBMC waveforms are capable of low orthogonality between subcarriers, which can counter Doppler and multipath effects. On the other hand, FBMC waveforms do not require CP, so the false targets can be avoided and spectral efficiency can be improved. The influence of multipath effect and Doppler shift on FBMC waveform in an integrated system is analysed in detail, and a Doppler compensation algorithm suitable for FBMC‐integrated waveform is proposed. The phase error caused by target motion can be iteratively compensated to obtain a well‐focussed ISAR image. Finally, considering the ISAR image entropy after motion compensation as the evaluation metric, extensive simulation experiments verify the noise robustness and effectiveness of the proposed algorithm. Compared with the conventional OFDM and CP‐OFDM schemes, the simulation verifies that the proposed waveform design and processing method has better performance in the ISAR imaging and communication integrated system.
- 9 September 2022
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 17 (1) , 47-62
Open AccessJoint radar communication system design based on filter bank multicarrier modulation scheme
Since orthogonal frequency division multiplexing (OFDM) signals are sensitive to Doppler shift, OFDM signals with cyclic prefix (CP) not only reduce the communication rate but also result in symmetric pseudo peaks in the ambiguity function of the radar, which eventually lead to the degradation of the performance of the joint radar communication system (JRCS). In this study, a novel JRCS is proposed based on the filter bank multicarrier (FBMC) waveform for the inverse synthetic aperture radar (ISAR) imaging and communication system. On the one hand, FBMC waveforms are capable of low orthogonality between subcarriers, which can counter Doppler and multipath effects. On the other hand, FBMC waveforms do not require CP, so the false targets can be avoided and spectral efficiency can be improved. The influence of multipath effect and Doppler shift on FBMC waveform in an integrated system is analysed in detail, and a Doppler compensation algorithm suitable for FBMC‐integrated waveform is proposed. The phase error caused by target motion can be iteratively compensated to obtain a well‐focussed ISAR image. Finally, considering the ISAR image entropy after motion compensation as the evaluation metric, extensive simulation experiments verify the noise robustness and effectiveness of the proposed algorithm. Compared with the conventional OFDM and CP‐OFDM schemes, the simulation verifies that the proposed waveform design and processing method has better performance in the ISAR imaging and communication integrated system.