Tatyana Viktorovna Bobkova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tatyana Viktorovna Bobkova has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Oleg V. Potapenko
Center of New Chemical Technologies BIC, Boreskov Institute of Catalysis, Omsk, Russia
4 shared publications - Vladislav Anatolyevich Koveza
Center of New Chemical Technologies BIC, Boreskov Institute of Catalysis, Omsk, Russia
4 shared publications - Arina Sergeevna Yurtaeva
Center of New Chemical Technologies, Omsk Branch, Federal Research Center Boreskov Institute of Catalysis, Siberian Branch, Russian Academy of Sciences, Omsk, Russia
3 shared publications - Elena O. Kuziuberdina
Center for New Chemical Technologies, Boreskov Institute of Catalysis, Siberian Branch, Russian Academy of Sciences, Omsk, Russia
3 shared publications - Konstantin Igorevich Dmitriev
Центр новых химических технологий ИК СО РАН, Институт катализа СО РАН
2 shared publications O. V. Potapenko
Institute of Hydrocarbons Processing SB RAS, 54, Neftezavodskaya St., Omsk 644040, Russian Federation
2 shared publications
Latest Publications
- 1 October 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (10) , 1152-1159
The Efficiency of Fe/MFI Additives in Reducing NOx in Cracking Catalyst Regeneration Flue Gas
A series of additives based on an iron-modified MFI zeolite were investigated for their ability to reduce NOx in cracking catalyst regeneration flue gases. Their efficiency was dependent on the iron loading, the zeolite SiO2/Al2O3 ratio, and the initial cationic form used for modification. The Fe/MFI additives prepared from an NH4-form zeolite with a low SiO2/Al2O3 ratio (23) demonstrated excellent performance. Under industrially relevant catalyst regeneration conditions, the additive with an optimized iron oxide content (within a tested range of 0.5 to 2.5 wt %) reached a NOx reduction efficiency of 45.4%.
- 1 October 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (10) , 1152-1159
The Efficiency of Fe/MFI Additives in Reducing NOx in Cracking Catalyst Regeneration Flue Gas
A series of additives based on an iron-modified MFI zeolite were investigated for their ability to reduce NOx in cracking catalyst regeneration flue gases. Their efficiency was dependent on the iron loading, the zeolite SiO2/Al2O3 ratio, and the initial cationic form used for modification. The Fe/MFI additives prepared from an NH4-form zeolite with a low SiO2/Al2O3 ratio (23) demonstrated excellent performance. Under industrially relevant catalyst regeneration conditions, the additive with an optimized iron oxide content (within a tested range of 0.5 to 2.5 wt %) reached a NOx reduction efficiency of 45.4%.
- 18 March 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (4) , 478-486
Efficiency of Fe/MFI, Fe/FAU, and Fe/FER Zeolites: Reduction of NOx in Cracking Catalyst Regeneration Flue Gas
A series of additives based on Fe(III)-modified MFI, FAU, and FER zeolites were investigated with focus on their efficiency in reducing NOx in cracking catalyst regeneration flue gases. The zeolite efficiency was found to depend on the zeolite framework type and the modification method. The Fe/MFI additives exhibited excellent performance. The additives prepared by ion exchange—and distinguished by uniform distribution of highly active metal ions (Fe3+)—reached a NOx reduction efficiency of 45.4%.
- 18 March 2025
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 65 (4) , 478-486
Efficiency of Fe/MFI, Fe/FAU, and Fe/FER Zeolites: Reduction of NOx in Cracking Catalyst Regeneration Flue Gas
A series of additives based on Fe(III)-modified MFI, FAU, and FER zeolites were investigated with focus on their efficiency in reducing NOx in cracking catalyst regeneration flue gases. The zeolite efficiency was found to depend on the zeolite framework type and the modification method. The Fe/MFI additives exhibited excellent performance. The additives prepared by ion exchange—and distinguished by uniform distribution of highly active metal ions (Fe3+)—reached a NOx reduction efficiency of 45.4%.
- 1 January 2025
- Published by Akademizdatcenter Nauka in Нефтехимия / Petroleum Chemistry
- Vol. 65 (2) , 134-146
NEW METHOD OF SYNTHESIS OF ADDITIVES FOR REDUCING THE CONTENT OF SULFUR OXIDES IN REGENERATION GASES OF THE CATALYTIC CRACKING PROCESS
Нефтехимия, NEW METHOD OF SYNTHESIS OF ADDITIVES FOR REDUCING THE CONTENT OF SULFUR OXIDES IN REGENERATION GASES OF THE CATALYTIC CRACKING PROCESS
- 1 January 2025
- Published by Akademizdatcenter Nauka in Нефтехимия / Petroleum Chemistry
- Vol. 65 (2) , 134-146
NEW METHOD OF SYNTHESIS OF ADDITIVES FOR REDUCING THE CONTENT OF SULFUR OXIDES IN REGENERATION GASES OF THE CATALYTIC CRACKING PROCESS
Нефтехимия, NEW METHOD OF SYNTHESIS OF ADDITIVES FOR REDUCING THE CONTENT OF SULFUR OXIDES IN REGENERATION GASES OF THE CATALYTIC CRACKING PROCESS
- 4 August 2024
- Published by The Russian Academy of Sciences in Neftehimiâ
- Vol. 64 (1) , 5-18
Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор)
Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор) Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор)
- 4 August 2024
- Published by The Russian Academy of Sciences in Neftehimiâ
- Vol. 64 (1) , 5-18
Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор)
Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор) Добавки к катализатору крекинга для снижения содержания токсичных компонентов в дымовых газах (обзор)
- 1 August 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (8) , 862-869
The Effect of Modification Method of ZSM-5 Zeolite with Zinc on the Product Composition in Cracking of Hydrocarbon Feedstock
The influence of the zinc incorporation method (ion exchange, impregnation) and its content (from 0.25 to 0.75 wt %) in ZSM-5 zeolite on the physicochemical characteristics of the zeolite (textural parameters, concentration of acid sites) and on the catalytic activity of cracking catalysts with the additives containing the modified zeolites in transformations of hydrotreated vacuum gasoil was studied. The zinc introduction by impregnation leads to a slight decrease in the zeolite specific surface area and micropore volume from 420 to 380 m2/g and from 0.131 to 0.117 cm3/g, respectively, and the total concentration of acid sites at the maximal zinc content increases by 17% compared to unmodified ZSM-5. Modification of the zeolite samples with zinc by ion exchange does not alter the main pore structure parameters compared to the initial zeolite, whereas the acid site concentration reaches the highest values (up to 2025 μmol/g). With an increase in the zinc content of ZSM-5 zeolite, with both modification methods (ion exchange, impregnation), the yield of the gasoline fraction and aromatic hydrocarbons in liquid products of cracking of hydrotreated vacuum gasoil increases.
- 1 August 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (8) , 862-869
The Effect of Modification Method of ZSM-5 Zeolite with Zinc on the Product Composition in Cracking of Hydrocarbon Feedstock
The influence of the zinc incorporation method (ion exchange, impregnation) and its content (from 0.25 to 0.75 wt %) in ZSM-5 zeolite on the physicochemical characteristics of the zeolite (textural parameters, concentration of acid sites) and on the catalytic activity of cracking catalysts with the additives containing the modified zeolites in transformations of hydrotreated vacuum gasoil was studied. The zinc introduction by impregnation leads to a slight decrease in the zeolite specific surface area and micropore volume from 420 to 380 m2/g and from 0.131 to 0.117 cm3/g, respectively, and the total concentration of acid sites at the maximal zinc content increases by 17% compared to unmodified ZSM-5. Modification of the zeolite samples with zinc by ion exchange does not alter the main pore structure parameters compared to the initial zeolite, whereas the acid site concentration reaches the highest values (up to 2025 μmol/g). With an increase in the zinc content of ZSM-5 zeolite, with both modification methods (ion exchange, impregnation), the yield of the gasoline fraction and aromatic hydrocarbons in liquid products of cracking of hydrotreated vacuum gasoil increases.
- 23 August 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2007 (1) , 020003
The influence of Y – type zeolite cationic composition on the model hydrocarbons transformations in the presence of heterocyclic sulfur and nitrogen compounds in the catalytic cracking conditions
The effect of the rare earth elements (REEs) content in range from 0 to 3 wt.% in the cracking catalyst on n-undecane and cumene transformations in the presence of heterocyclic sulfur and nitrogen compounds was studied. The catalyst samples acidity increased at raising the REEs content in the catalysts up to 2 wt.%. The catalyst acidity was sharply reduced with a further increase in the REEs. This phenomenon led to an enhanced conversion of the feed and a decreased formation of highly poisonous nitrogen compounds. The relative conversions of n-undecane and cumene in the presence of nitrogen and sulfur compounds were 95 and 97 rel.%, accordingly.
- 23 August 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2007 (1) , 020003
The influence of Y – type zeolite cationic composition on the model hydrocarbons transformations in the presence of heterocyclic sulfur and nitrogen compounds in the catalytic cracking conditions
The effect of the rare earth elements (REEs) content in range from 0 to 3 wt.% in the cracking catalyst on n-undecane and cumene transformations in the presence of heterocyclic sulfur and nitrogen compounds was studied. The catalyst samples acidity increased at raising the REEs content in the catalysts up to 2 wt.%. The catalyst acidity was sharply reduced with a further increase in the REEs. This phenomenon led to an enhanced conversion of the feed and a decreased formation of highly poisonous nitrogen compounds. The relative conversions of n-undecane and cumene in the presence of nitrogen and sulfur compounds were 95 and 97 rel.%, accordingly.
- 1 July 2014
- Published by Pleiades Publishing Ltd in Catalysis in Industry
- Vol. 6 (3) , 218-222
Poisoning effect of nitrogen compounds on the transformation of model hydrocarbons and real feed under catalytic cracking conditions
The effect of the content and nature of nitrogen compounds on the distribution of target products in transforming model hydrocarbons under cracking conditions over equilibrium zeolite-containing catalyst was studied. Using cracking of n-undecane as an example, a nearly 50% drop in the conversion and in yields of propane-propene (PPF) and butane-butene fractions (BBF) was observed when the pyrrol content in the feed was raised to 3000 ppm of nitrogen. Increasing the nitrogen content in the feed led to a nonlinear reduction in the rate constants of n-undecane cracking. It was found that the dependence of the yields of PPF, BBF, and isobutane in BBF on the conversion remained constant upon the cracking of n-undecane with various of nitrogen compounds; poisoning was likely to proceeds only because the acidic sites of the catalyst were blocked. The high poisoning effect of pyrrol and indole upon the cracking of n-undecane and decalin (strong proton donors) was observed along with the formation of ammonia. Quinoline exhibited high poisoning ability in the catalytic cracking of cumene with low [H]-donor activity. Quinoline poisoned catalysts to a greater degree than indole, during the catalytic cracking of non-hydrofined vacuum gasoil with a high content of aromatic structures. Indole exhibited the highest poisoning ability in processing heavy hydrocracking residue which was rich of paraffin-naphthene hydrocarbons.
- 1 July 2014
- Published by Pleiades Publishing Ltd in Catalysis in Industry
- Vol. 6 (3) , 218-222
Poisoning effect of nitrogen compounds on the transformation of model hydrocarbons and real feed under catalytic cracking conditions
The effect of the content and nature of nitrogen compounds on the distribution of target products in transforming model hydrocarbons under cracking conditions over equilibrium zeolite-containing catalyst was studied. Using cracking of n-undecane as an example, a nearly 50% drop in the conversion and in yields of propane-propene (PPF) and butane-butene fractions (BBF) was observed when the pyrrol content in the feed was raised to 3000 ppm of nitrogen. Increasing the nitrogen content in the feed led to a nonlinear reduction in the rate constants of n-undecane cracking. It was found that the dependence of the yields of PPF, BBF, and isobutane in BBF on the conversion remained constant upon the cracking of n-undecane with various of nitrogen compounds; poisoning was likely to proceeds only because the acidic sites of the catalyst were blocked. The high poisoning effect of pyrrol and indole upon the cracking of n-undecane and decalin (strong proton donors) was observed along with the formation of ammonia. Quinoline exhibited high poisoning ability in the catalytic cracking of cumene with low [H]-donor activity. Quinoline poisoned catalysts to a greater degree than indole, during the catalytic cracking of non-hydrofined vacuum gasoil with a high content of aromatic structures. Indole exhibited the highest poisoning ability in processing heavy hydrocracking residue which was rich of paraffin-naphthene hydrocarbons.