Yicun Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yicun Wang has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Jianren Fan
7 shared publicationsHuangwei Zhang
6 shared publications- Kun Luo
State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China
6 shared publications - Jie Sun
Peking University
5 shared publications - Salim M. Shaik
Department of Food, Chemical & Biotechnology Singapore Institute of Technology Singapore Republic of Singapore
4 shared publications - Shumeng Xie
National University of Singapore
4 shared publications
Latest Publications
- 10 November 2026
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 164
Learnable parameter conditioning for enhancing the generalization of reduced-order models of hydrogen combustion
- 10 November 2026
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 164
Learnable parameter conditioning for enhancing the generalization of reduced-order models of hydrogen combustion
- 29 April 2026
- Published by Elsevier in Combustion and Flame
- Vol. 289
Synergistic flame stabilization and oscillation dynamics in a dual-zone supersonic combustor
- 29 April 2026
- Published by Elsevier in Combustion and Flame
- Vol. 289
Synergistic flame stabilization and oscillation dynamics in a dual-zone supersonic combustor
- 9 April 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (4)
Numerical investigation on detonation attenuation and flame acceleration in channels with obstacle arrays
- 9 April 2026
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 11 (4)
Numerical investigation on detonation attenuation and flame acceleration in channels with obstacle arrays
- 14 December 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-12
Ignition Characteristics of a Supersonic Combustor with Parallel Dual Combustion Zones
The ignition of a dual-combustion-zone supersonic combustor featuring a cavity and a backward-facing step (BFS) are investigated experimentally and numerically. The inflow conditions are Mach 2.52, stagnation pressure 1.6 MPa, and stagnation temperature 1486 K, with ethylene as the fuel at global equivalence ratios ([ ]) of 0.30, 0.35, and 0.40. The results show that cavity ignition is achieved by spark discharge for all tested conditions, where the spark generates an initial flame kernel confined in the recirculating flow. After a short growth phase limited by radical dissipation, the flame develops into a shear layer flame. In contrast, BFS ignition depends on the equivalence ratio. At [ ], ignition remains spark-driven, while at [ ] and 0.40, the BFS undergoes self-ignition followed by flame backpropagation. The self-ignition originates from combustion-induced flow restructuring. The lifted cavity flame compresses the mainstream, forming a high-temperature, high-pressure separation zone that traps fuel–air mixture and enables flame kernel formation. As the energy accumulates, coupled flow and thermal choking stabilize the flame kernel, which transitions to a self-sustained flame. It then propagates upstream through a fuel-rich channel and stabilizes as a BFS flame. These findings provide guidance for optimization and design of novel supersonic combustors.
- 14 December 2025
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- p. 1-12
Ignition Characteristics of a Supersonic Combustor with Parallel Dual Combustion Zones
The ignition of a dual-combustion-zone supersonic combustor featuring a cavity and a backward-facing step (BFS) are investigated experimentally and numerically. The inflow conditions are Mach 2.52, stagnation pressure 1.6 MPa, and stagnation temperature 1486 K, with ethylene as the fuel at global equivalence ratios ([ ]) of 0.30, 0.35, and 0.40. The results show that cavity ignition is achieved by spark discharge for all tested conditions, where the spark generates an initial flame kernel confined in the recirculating flow. After a short growth phase limited by radical dissipation, the flame develops into a shear layer flame. In contrast, BFS ignition depends on the equivalence ratio. At [ ], ignition remains spark-driven, while at [ ] and 0.40, the BFS undergoes self-ignition followed by flame backpropagation. The self-ignition originates from combustion-induced flow restructuring. The lifted cavity flame compresses the mainstream, forming a high-temperature, high-pressure separation zone that traps fuel–air mixture and enables flame kernel formation. As the energy accumulates, coupled flow and thermal choking stabilize the flame kernel, which transitions to a self-sustained flame. It then propagates upstream through a fuel-rich channel and stabilizes as a BFS flame. These findings provide guidance for optimization and design of novel supersonic combustors.
- 27 October 2025
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 41
Large eddy simulation of piloted turbulent partially cracked ammonia flames with the direct moment closure model
- 27 October 2025
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 41
Large eddy simulation of piloted turbulent partially cracked ammonia flames with the direct moment closure model
- 25 August 2025
- Published by Elsevier in Combustion and Flame
- Vol. 281
Numerical investigation of detonation initiation and propagation in non-uniformly cracked ammonia and air mixtures
- 25 August 2025
- Published by Elsevier in Combustion and Flame
- Vol. 281
Numerical investigation of detonation initiation and propagation in non-uniformly cracked ammonia and air mixtures
- 2 January 2025
- Published by Taylor & Francis in Combustion Theory and Modelling
- Vol. 29 (1) , 93-110
Large eddy simulation of spray combustion in a model swirl burner using the two-phase spray flamelet model
- 2 January 2025
- Published by Taylor & Francis in Combustion Theory and Modelling
- Vol. 29 (1) , 93-110
Large eddy simulation of spray combustion in a model swirl burner using the two-phase spray flamelet model