Yansong Bai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yansong Bai has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Hongjin Yu
College of Safety and Emergency Management Engineering, Taiyuan University of Technology, Taiyuan 030024, China
2 shared publications - Ziwen Li
College of Safety and Emergency Management Engineering, Taiyuan University of Technology, Taiyuan 030024, China
2 shared publications - Hongqing Hu
College of Safety and Emergency Management Engineering, Taiyuan University of Technology, Taiyuan 030024, China
1 shared publication - Yinji Wang
College of Safety and Emergency Management Engineering, Taiyuan University of Technology, Taiyuan 030024, China
1 shared publication
Latest Publications
- Open Access
- 1 December 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (23) , 16483
Molecular Dynamics Simulation of CH4 Displacement through Different Sequential Injections of CO2/N2
As a clean energy source, coalbed methane (CBM) produces almost no exhaust gas after combustion, and its extraction and efficient utilization play a key role in supporting sustainable development. Therefore, molecular dynamics simulations were used to research the diffusion of CH4 in coal after injecting CO2/N2 in different sequences and to clarify the efficiency of CBM extraction under different injection sequences, so as to contribute to sustainable development. The results show that the adsorption amounts of CO2 and N2 in different injection sequences are obviously different. To narrow the gap between the two injection amounts, the injection pressure of N2 can be appropriately increased and that of CO2 can be reduced, or N2 can be injected preferentially instead of CO2. When CO2 is injected first, the interaction energy between CH4 and coal is stronger and increases slightly with displacement time as a whole. The interaction energy curve of the N2 injection decreases, and the displacement effect becomes worse and worse. From the diffusion and relative concentration distribution of CH4, it can be seen that the diffusion of CH4 molecules outside the grain cell is more obvious when N2 is injected first. In terms of the number of CH4 molecules diffusing outside the crystal cell, it is less when CO2 is injected first than when N2 is injected first. The average value of the velocity distribution of CH4 increases slightly when CO2 is injected first and decreases significantly when N2 is injected first, but the average value is overall higher for N2 injection first. From the difference in diffusion coefficients before and after the gas injection, it can be seen that the decrease in permeability due to the expansion of the coal matrix by CO2 is more obvious than the increase in permeability due to the contraction of the coal matrix by N2.
- 1 December 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (23) , 16483
Open AccessMolecular Dynamics Simulation of CH4 Displacement through Different Sequential Injections of CO2/N2
As a clean energy source, coalbed methane (CBM) produces almost no exhaust gas after combustion, and its extraction and efficient utilization play a key role in supporting sustainable development. Therefore, molecular dynamics simulations were used to research the diffusion of CH4 in coal after injecting CO2/N2 in different sequences and to clarify the efficiency of CBM extraction under different injection sequences, so as to contribute to sustainable development. The results show that the adsorption amounts of CO2 and N2 in different injection sequences are obviously different. To narrow the gap between the two injection amounts, the injection pressure of N2 can be appropriately increased and that of CO2 can be reduced, or N2 can be injected preferentially instead of CO2. When CO2 is injected first, the interaction energy between CH4 and coal is stronger and increases slightly with displacement time as a whole. The interaction energy curve of the N2 injection decreases, and the displacement effect becomes worse and worse. From the diffusion and relative concentration distribution of CH4, it can be seen that the diffusion of CH4 molecules outside the grain cell is more obvious when N2 is injected first. In terms of the number of CH4 molecules diffusing outside the crystal cell, it is less when CO2 is injected first than when N2 is injected first. The average value of the velocity distribution of CH4 increases slightly when CO2 is injected first and decreases significantly when N2 is injected first, but the average value is overall higher for N2 injection first. From the difference in diffusion coefficients before and after the gas injection, it can be seen that the decrease in permeability due to the expansion of the coal matrix by CO2 is more obvious than the increase in permeability due to the contraction of the coal matrix by N2.
- Open Access
- 19 September 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (18) , 11789
Numerical Simulation of CO2-ECBM Based on Multi-Physical Field Coupling Model
In this paper, heat injection and CO2 injection are combined, and the influence of coal seam parameters on CO2-ECBM is analyzed to improve the production of CH4 and CO2 reserves and the effective control of both greenhouse gases. A multi-physical field coupling model of CO2-ECBM was established based on Darcy’s law, Fick’s law of diffusion, the extended Langmuir model for adsorption, and the equation of state. Numerical simulation of CO2-ECBM under different coal seam parameters was carried out by COMSOL Multiphysics. The results show that increasing the injection pressure of the CO2 injection well and the initial pressure of the coal seam can effectively increase the gas pressure and concentration gradient, which has a positive effect on improving the extraction concentration of CH4 and the sequestration concentration of CO2 in the coal seam. The increase of the initial temperature of the coal seam will promote the desorption and diffusion of the binary elemental gas, resulting in a decrease in the concentration of coalbed methane and a decrease in the displacement effect. In the process of displacement, the greater the initial permeability, the greater the fracture opening of the coal seam, which is more conducive to the seepage transport of the gas. The closer to the position of the injection well, the better the displacement effect and the lower the permeability rate ratio.
- 19 September 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (18) , 11789
Open AccessNumerical Simulation of CO2-ECBM Based on Multi-Physical Field Coupling Model
In this paper, heat injection and CO2 injection are combined, and the influence of coal seam parameters on CO2-ECBM is analyzed to improve the production of CH4 and CO2 reserves and the effective control of both greenhouse gases. A multi-physical field coupling model of CO2-ECBM was established based on Darcy’s law, Fick’s law of diffusion, the extended Langmuir model for adsorption, and the equation of state. Numerical simulation of CO2-ECBM under different coal seam parameters was carried out by COMSOL Multiphysics. The results show that increasing the injection pressure of the CO2 injection well and the initial pressure of the coal seam can effectively increase the gas pressure and concentration gradient, which has a positive effect on improving the extraction concentration of CH4 and the sequestration concentration of CO2 in the coal seam. The increase of the initial temperature of the coal seam will promote the desorption and diffusion of the binary elemental gas, resulting in a decrease in the concentration of coalbed methane and a decrease in the displacement effect. In the process of displacement, the greater the initial permeability, the greater the fracture opening of the coal seam, which is more conducive to the seepage transport of the gas. The closer to the position of the injection well, the better the displacement effect and the lower the permeability rate ratio.