Tzarara López-Luke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tzarara López-Luke has a total of 73 co-authors. Here are the top co-authors by number of shared publications:
- Juan Zárate Medina
Universidad Michoacana de San Nicolás de Hidalgo, Morelia, México
4 shared publications Emmanuel Reyes-Francis
Instituto de Investigación en Metalurgia y Materiales, Universidad Michoacana de San Nicolás de Hidalgo, Morelia, Mexico
3 shared publications- María Eugenia Contreras García
Universidad Michoacana de San Nicolás de Hidalgo
3 shared publications - Teodoro Rivera Montalvo
CICATA-Legaria Instituto Politécnico Nacional Ciudad de México 11500 México
3 shared publications - Alejandro Alonso Sotolongo2 shared publications
- Beatriz Julián-López
Institute of Advanced Materials (INAM), University Jaume I, Av. Vicent Sos Baynat, s/n, 12071, Castellón de la Plana, Spain
2 shared publications
Latest Publications
- Open Access
- 23 October 2026
- Published by Elsevier in SSRN Electronic Journal
Ultrasonic Frequency Effects on the Enhanced Visible/NIR Emission and Photothermal Response of Sonochemically Synthesized ZrO2:Yb3+-Tm3+-Li+ Nanoparticles
In this work, ZrO2:Yb3+(2 mol %)–Tm3+ (0.1 mol %) –Li+(0.5 mol %) nanoparticles were synthesized by a sonochemical method assisted by hydrothermal treatment using ultrasonic frequencies of 1, 5, 10, and 25 MHz. Structural, morphological, photoluminescence, and photothermal properties were investigated. X-ray diffraction revealed the presence of tetragonal and monoclinic ZrO2 phases, with preferential stabilization of the tetragonal phase and average crystallite sizes of ~20 and ~ 17 nm, respectively. SEM analysis revealed an average particle size of 176–288 nm. The highest emission was obtained with 5 MHz, exhibited ~1.5 times enhanced Tm³⁺ upconversion emissions approximately, at 487, 656, and 798 nm under 975 nm excitation. This increase in PL is due to the optimal decrease of C-O and CO3-. The CIE chromaticity coordinates confirm consistent blue emission across various ultrasonic frequencies (1, 5, 10, and 25 MHz). Additionally, the nanoparticles exhibit a strong photothermal response, with temperatures rising to 45–69 °C after 1 min of near-infrared (NIR) irradiation. Specifically, the 10 MHz frequency promoted non-radiative dissipation, yielding the highest photothermal response of approximately 69 °C under 975 nm irradiation. This enhanced effect is likely influenced by variations in nanoparticle size resulting from the different ultrasound frequencies. This approach represents a strategy for influencing the balance between radiative and non-radiative energy dissipation, offering an opportunity to tailor ZrO2:Yb3+–Tm3+–Li+ theragnostic nanoparticles upconversion and photothermal performance.
- 23 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessUltrasonic Frequency Effects on the Enhanced Visible/NIR Emission and Photothermal Response of Sonochemically Synthesized ZrO2:Yb3+-Tm3+-Li+ Nanoparticles
In this work, ZrO2:Yb3+(2 mol %)–Tm3+ (0.1 mol %) –Li+(0.5 mol %) nanoparticles were synthesized by a sonochemical method assisted by hydrothermal treatment using ultrasonic frequencies of 1, 5, 10, and 25 MHz. Structural, morphological, photoluminescence, and photothermal properties were investigated. X-ray diffraction revealed the presence of tetragonal and monoclinic ZrO2 phases, with preferential stabilization of the tetragonal phase and average crystallite sizes of ~20 and ~ 17 nm, respectively. SEM analysis revealed an average particle size of 176–288 nm. The highest emission was obtained with 5 MHz, exhibited ~1.5 times enhanced Tm³⁺ upconversion emissions approximately, at 487, 656, and 798 nm under 975 nm excitation. This increase in PL is due to the optimal decrease of C-O and CO3-. The CIE chromaticity coordinates confirm consistent blue emission across various ultrasonic frequencies (1, 5, 10, and 25 MHz). Additionally, the nanoparticles exhibit a strong photothermal response, with temperatures rising to 45–69 °C after 1 min of near-infrared (NIR) irradiation. Specifically, the 10 MHz frequency promoted non-radiative dissipation, yielding the highest photothermal response of approximately 69 °C under 975 nm irradiation. This enhanced effect is likely influenced by variations in nanoparticle size resulting from the different ultrasound frequencies. This approach represents a strategy for influencing the balance between radiative and non-radiative energy dissipation, offering an opportunity to tailor ZrO2:Yb3+–Tm3+–Li+ theragnostic nanoparticles upconversion and photothermal performance.
- Open Access
- 8 June 2026
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 58 (8) , 342
First-principles calculations of shift-current response in III–V and II–VI zincblende semiconductors
- 8 June 2026
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 58 (8) , 342
Open AccessFirst-principles calculations of shift-current response in III–V and II–VI zincblende semiconductors
- 29 April 2026
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 360
A novel approach to charge carrier transport in Gd0.98Eu0.02AlO3 perovskite
- 29 April 2026
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 360
A novel approach to charge carrier transport in Gd0.98Eu0.02AlO3 perovskite
- 18 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (3) , 2879-2886
Multifunctional Fe3O4-ZrO2:Yb3+/Er3+ hybrid nanoparticles with magnetic, upconverting luminescence, white-light emission and photothermal properties
- 18 December 2025
- Published by Elsevier in Ceramics International
- Vol. 52 (3) , 2879-2886
Multifunctional Fe3O4-ZrO2:Yb3+/Er3+ hybrid nanoparticles with magnetic, upconverting luminescence, white-light emission and photothermal properties
- 4 December 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (2) , 1141-1156
Photoelectrochemical Study of the Performance Enhancement of CNT-Based Counter Electrodes by Adding N-S Doped rGO in QD Solar Cells
- 4 December 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 54 (2) , 1141-1156
Photoelectrochemical Study of the Performance Enhancement of CNT-Based Counter Electrodes by Adding N-S Doped rGO in QD Solar Cells
- Open Access
- 25 September 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (19) , 9992
Correction to “Microwave-Mediated Synthesis of Lead-Free Cesium Titanium Bromide Double Perovskite: A Sustainable Approach”
[This corrects the article DOI: 10.1021/acs.chemmater.3c03108.].
- 25 September 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (19) , 9992
Open AccessCorrection to “Microwave-Mediated Synthesis of Lead-Free Cesium Titanium Bromide Double Perovskite: A Sustainable Approach”
[This corrects the article DOI: 10.1021/acs.chemmater.3c03108.].
- Open Access
- 2 February 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (3) , 1728-1736
Microwave-Mediated Synthesis of Lead-Free Cesium Titanium Bromide Double Perovskite: A Sustainable Approach
Theoretical studies have identified cesium titanium bromide (Cs2TiBr6), a vacancy-ordered double perovskite, as a promising lead-free and earth-abundant candidate to replace Pb-based perovskites in photovoltaics. Our research is focused on overcoming the limitations associated with the current Cs2TiBr6 syntheses, which often involve high-vacuum and high-temperature evaporation techniques, high-energy milling, or intricate multistep solution processes conducted under an inert atmosphere, constraints that hinder industrial scalability. This study presents a straightforward, low-energy, and scalable solution procedure using microwave radiation to induce the formation of highly crystalline Cs2TiBr6 in a polar solvent. This methodology, where the choice of the solvent plays a crucial role, not only reduces the energy costs associated with perovskite production but also imparts exceptional stability to the resulting solid, in comparison with previous reports. This is a critical prerequisite for any technological advancement. The low-defective material demonstrates unprecedented structural stability under various stimuli such as moisture, oxygen, elevated temperatures (over 130 °C), and continuous exposure to white light illumination. In summary, our study represents an important step forward in the efficient and cost-effective synthesis of Cs2TiBr6, offering a compelling solution for the development of eco-friendly, earth-abundant Pb-free perovskite materials.
- 2 February 2024
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 36 (3) , 1728-1736
Open AccessMicrowave-Mediated Synthesis of Lead-Free Cesium Titanium Bromide Double Perovskite: A Sustainable Approach
Theoretical studies have identified cesium titanium bromide (Cs2TiBr6), a vacancy-ordered double perovskite, as a promising lead-free and earth-abundant candidate to replace Pb-based perovskites in photovoltaics. Our research is focused on overcoming the limitations associated with the current Cs2TiBr6 syntheses, which often involve high-vacuum and high-temperature evaporation techniques, high-energy milling, or intricate multistep solution processes conducted under an inert atmosphere, constraints that hinder industrial scalability. This study presents a straightforward, low-energy, and scalable solution procedure using microwave radiation to induce the formation of highly crystalline Cs2TiBr6 in a polar solvent. This methodology, where the choice of the solvent plays a crucial role, not only reduces the energy costs associated with perovskite production but also imparts exceptional stability to the resulting solid, in comparison with previous reports. This is a critical prerequisite for any technological advancement. The low-defective material demonstrates unprecedented structural stability under various stimuli such as moisture, oxygen, elevated temperatures (over 130 °C), and continuous exposure to white light illumination. In summary, our study represents an important step forward in the efficient and cost-effective synthesis of Cs2TiBr6, offering a compelling solution for the development of eco-friendly, earth-abundant Pb-free perovskite materials.
- 6 September 2023
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 201, 111019
Thermoluminescent glow curve of Gd1-xRExAlO3 (RE=Dy or Pr) beta irradiated phosphors
- 6 September 2023
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 201, 111019
Thermoluminescent glow curve of Gd1-xRExAlO3 (RE=Dy or Pr) beta irradiated phosphors
- 10 June 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (9) , 5834-5842
Experimental Parameters Effect on the ITO/PEDOT:PSS/MAPbI3/PCBM/Ag Inverted Organic Perovskite Photovoltaic Solar Cell Efficiency
- 10 June 2023
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 52 (9) , 5834-5842
Experimental Parameters Effect on the ITO/PEDOT:PSS/MAPbI3/PCBM/Ag Inverted Organic Perovskite Photovoltaic Solar Cell Efficiency