Catherine M. F. Rae
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Catherine M. F. Rae has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
L. Zhang
2 shared publications- An-Chou Yeh
Department of Materials Science and Engineering, National Tsing Hua University, 101, Sec. 2, Kuang-Fu Road, Hsinchu 300044, Taiwan
1 shared publication - Aya Suzuki
Shinshu Univ. Dept. of Bioscience and Textile Technology
1 shared publication - Ayan Bhowmik
Department of Materials Science and Engineering Indian Institute of Technology Delhi Hauz Khas New Delhi 110016 India
1 shared publication B. Broomfield
Rolls-Royce plc, PO Box 31, Derby DE24 8BJ, UK
1 shared publication- Christopher H. Zenk
Department of Materials Science and Engineering Friedrich-Alexander-Universität Erlangen-Nürnberg Martensstr. 5 D-91058 Erlangen Germany
1 shared publication
Latest Publications
- Open Access
- 20 September 2022
- Published by Elsevier in Acta Materialia
- Vol. 241
Nucleation of superlattice intrinsic stacking faults via cross-slip in nickel-based superalloys
- 20 September 2022
- Published by Elsevier in Acta Materialia
- Vol. 241
Open AccessNucleation of superlattice intrinsic stacking faults via cross-slip in nickel-based superalloys
- Open Access
- 30 May 2020
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 51 (8) , 4008-4021
Role of the Secondary Phase η During High-Temperature Compression of ATI 718Plus®
High-temperature compression tests were performed on a Ni-base superalloy with a multi-phase microstructure. Particular attention was given on the influence of the η phase on recrystallization of ATI 718Plus®. The compression tests were performed at two temperatures over a variety of strains and strain rates. Meta-dynamic recrystallization was studied by exposing the samples to a set dwell time at the test temperature after deformation. Electron backscatter diffraction (EBSD) was used to investigate the microstructures after the tests. Secondary electron imaging (SEI) and scanning transmission electron microscopy (STEM) were utilized in order to investigate the deformation behavior of η and obtaining a detailed understanding of the recrystallization mechanism. The secondary η phase was found to increase the recrystallized fraction compared to η free tests. However, clusters of thin lamellar η inhibited recrystallization. The flow curve softening was distinctly stronger in the microstructure containing precipitates. It could be shown by SE images that this was due to the breakage and realignment of η. In addition, η was also found to accommodate the stresses by a remarkable deformation without breaking up. This was considered to be due to the composite nature of the precipitate as well as the ongoing recrystallization in the surrounding matrix.
- 30 May 2020
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 51 (8) , 4008-4021
Open AccessRole of the Secondary Phase η During High-Temperature Compression of ATI 718Plus®
High-temperature compression tests were performed on a Ni-base superalloy with a multi-phase microstructure. Particular attention was given on the influence of the η phase on recrystallization of ATI 718Plus®. The compression tests were performed at two temperatures over a variety of strains and strain rates. Meta-dynamic recrystallization was studied by exposing the samples to a set dwell time at the test temperature after deformation. Electron backscatter diffraction (EBSD) was used to investigate the microstructures after the tests. Secondary electron imaging (SEI) and scanning transmission electron microscopy (STEM) were utilized in order to investigate the deformation behavior of η and obtaining a detailed understanding of the recrystallization mechanism. The secondary η phase was found to increase the recrystallized fraction compared to η free tests. However, clusters of thin lamellar η inhibited recrystallization. The flow curve softening was distinctly stronger in the microstructure containing precipitates. It could be shown by SE images that this was due to the breakage and realignment of η. In addition, η was also found to accommodate the stresses by a remarkable deformation without breaking up. This was considered to be due to the composite nature of the precipitate as well as the ongoing recrystallization in the surrounding matrix.
- 21 October 2014
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 94 (34) , 3914-3944
Microstructure and mechanical properties of Cr–Ta–Si Laves phase-based alloys at elevated temperatures
- 21 October 2014
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 94 (34) , 3914-3944
Microstructure and mechanical properties of Cr–Ta–Si Laves phase-based alloys at elevated temperatures
- Open Access
- 1 May 2009
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 165, 012002
Secondary Reaction Zone Formations in coated Ni-base Single Crystal Superalloys
- 1 May 2009
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 165, 012002
Open AccessSecondary Reaction Zone Formations in coated Ni-base Single Crystal Superalloys
- 1 February 2009
- Published by SAGE Publications in Materials Science and Technology
- Vol. 25 (2) , 228-235
Primary creep in single crystal superalloys: Some comments on effects of composition and microstructure
Creep at low temperatures in current single crystal superalloys is characterised by a large but orientation dependent primary creep strain followed by prolonged secondary creep at a rate closely linked to the primary creep strain. The processes of incubation, nucleation and propagation are described and the linked effects of alloy composition and microstructure are discussed in relation to these processes. It is shown that the incubation period is relatively insensitive to the alloy composition but that heat treatments which vary the γ′ size can have a larger effect on the early stages of creep. The key to high primary creep appears to be the mobility of the dislocation ribbons nucleated and this is sensitive to the alloy composition. Fault energies in both the γ and the γ′ are important in determining the form of the dislocation ribbons. Early results suggest that ruthenium may have a beneficial effect reducing the primary creep of fourth generation alloys.
- 1 February 2009
- Published by SAGE Publications in Materials Science and Technology
- Vol. 25 (2) , 228-235
Primary creep in single crystal superalloys: Some comments on effects of composition and microstructure
Creep at low temperatures in current single crystal superalloys is characterised by a large but orientation dependent primary creep strain followed by prolonged secondary creep at a rate closely linked to the primary creep strain. The processes of incubation, nucleation and propagation are described and the linked effects of alloy composition and microstructure are discussed in relation to these processes. It is shown that the incubation period is relatively insensitive to the alloy composition but that heat treatments which vary the γ′ size can have a larger effect on the early stages of creep. The key to high primary creep appears to be the mobility of the dislocation ribbons nucleated and this is sensitive to the alloy composition. Fault energies in both the γ and the γ′ are important in determining the form of the dislocation ribbons. Early results suggest that ruthenium may have a beneficial effect reducing the primary creep of fourth generation alloys.
- Open Access
- 1 January 2008
- Published by The Minerals, Metals and Materials Society
- p. 81-90
Linking the Properties, Processing and Chemistry of Advanced Single Crystal Ni-Base Superalloys
- 1 January 2008
- Published by The Minerals, Metals and Materials Society
- p. 81-90
Open AccessLinking the Properties, Processing and Chemistry of Advanced Single Crystal Ni-Base Superalloys