Kimberly Alicia Strange Fessler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kimberly Alicia Strange Fessler has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Bradley Patton
Tetra Tech, Inc
2 shared publications- Jason R. Darvin
Savannah River National Laboratory, Aiken, SC, USA
2 shared publications - Sharon Robinson
ORNL
2 shared publications Abigail M. Waldron
Savannah River National Laboratory, 301 Gateway Drive, Aiken, 29803, SC, USA
1 shared publication- Abigail Waldron
Savannah River National Laboratory Aiken South Carolina USA
1 shared publication Alicia Fessler
ORNL
1 shared publication
Latest Publications
- 16 February 2023
- Published by SAGE Publications in Applied Spectroscopy
- Vol. 77 (5) , 449-456
Diffuse Reflectance Spectroscopy and Principal Component Analysis to Retrospectively Determine Production History of Plutonium Dioxide
Diffuse reflectance spectroscopy measurements in the shortwave infrared (930–1600 nm) spectral region were acquired for Pu 2 (C 2 O 4 ) 3 •9H 2 O and its thermal decomposition product, PuO 2 . We analyzed a total of eight PuO 2 samples that were produced at different calcination temperatures (300, 350, 450, 525, 600, 675, 750, and 900 °C). Our goal was to identify spectroscopic fingerprints that could be used to gain retrospective information regarding the production parameters of these important nuclear compounds. The diffuse reflectance spectrum of Pu 2 (C 2 O 4 ) 3 •9H 2 O features several broad bands that currently preclude detailed analysis. However, all PuO 2 samples produced relatively sharp spectral features that got sharper and more intense for samples that were produced at higher calcination temperatures. The electronic band observed at 1433 nm in the diffuse reflectance spectra of PuO 2 was found to be a sensitive indicator of crystallinity; a result that is corroborated by ancillary Raman spectroscopy measurements. Principal component analysis of diffuse reflectance spectra was able to clearly rank and categorize PuO 2 samples based on the calcination temperature that was employed during their production. Thus, we show herein that important retrospective information pertaining to the process history of PuO 2 can be gained through the relatively simplistic combination of diffuse reflectance spectroscopy and principal component analysis. This discovery presents a new method for determining the provenance and process history of PuO 2 and should have an impact in the fields of nuclear forensics and nuclear nonproliferation.
- 16 February 2023
- Published by SAGE Publications in Applied Spectroscopy
- Vol. 77 (5) , 449-456
Diffuse Reflectance Spectroscopy and Principal Component Analysis to Retrospectively Determine Production History of Plutonium Dioxide
Diffuse reflectance spectroscopy measurements in the shortwave infrared (930–1600 nm) spectral region were acquired for Pu 2 (C 2 O 4 ) 3 •9H 2 O and its thermal decomposition product, PuO 2 . We analyzed a total of eight PuO 2 samples that were produced at different calcination temperatures (300, 350, 450, 525, 600, 675, 750, and 900 °C). Our goal was to identify spectroscopic fingerprints that could be used to gain retrospective information regarding the production parameters of these important nuclear compounds. The diffuse reflectance spectrum of Pu 2 (C 2 O 4 ) 3 •9H 2 O features several broad bands that currently preclude detailed analysis. However, all PuO 2 samples produced relatively sharp spectral features that got sharper and more intense for samples that were produced at higher calcination temperatures. The electronic band observed at 1433 nm in the diffuse reflectance spectra of PuO 2 was found to be a sensitive indicator of crystallinity; a result that is corroborated by ancillary Raman spectroscopy measurements. Principal component analysis of diffuse reflectance spectra was able to clearly rank and categorize PuO 2 samples based on the calcination temperature that was employed during their production. Thus, we show herein that important retrospective information pertaining to the process history of PuO 2 can be gained through the relatively simplistic combination of diffuse reflectance spectroscopy and principal component analysis. This discovery presents a new method for determining the provenance and process history of PuO 2 and should have an impact in the fields of nuclear forensics and nuclear nonproliferation.
- 22 December 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (4) , 2990-2998
Investigating the hydrolysis of cryogenically layered molybdenum hexafluoride through a disordered hydrogen-bonded network
Molybdenum hexafluoride (MoF6) is used as a non-radioactive substitute for uranium to study the hydrolysis of metal hexafluorides.
- 22 December 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (4) , 2990-2998
Investigating the hydrolysis of cryogenically layered molybdenum hexafluoride through a disordered hydrogen-bonded network
Molybdenum hexafluoride (MoF6) is used as a non-radioactive substitute for uranium to study the hydrolysis of metal hexafluorides.
- 1 December 2022
- Published by SAGE Publications in Applied Spectroscopy
- Vol. 77 (2) , 151-159
Isotopic Signatures of Lithium Carbonate and Lithium Hydroxide Monohydrate Measured Using Raman Spectroscopy
Lithium isotopic ratios have wide ranging applications as chemical signatures, including improved understanding of geochemical processes and battery development. Measurement of isotope ratios using optical spectroscopies would provide an alternative to traditional mass spectrometric methods, which are expensive and often limited to a chemical laboratory. Raman spectra of 7 Li 2 CO 3 , 6 Li 2 CO 3 , 7 LiOH*H 2 O, and 6 LiOH*H 2 O have been measured to determine the effect of lithium isotope substitution on the Raman molecular vibrations. Thirteen peaks were observed in the spectrum of lithium carbonate, with discernable isotopic shifts occurring in eleven of the 13 vibrations, two of which have not been previously reported in the literature. The spectrum of lithium hydroxide monohydrate contained nine peaks, with discernable isotopic shifts occurring in eight of the nine vibrations, four of which have not been previously reported in the literature. The Raman spectral data reported here for lithium carbonate and lithium hydroxide monohydrate are in agreement with the previously reported works in the literature, in which the Raman active modes of these molecules were first identified and assigned. However, due to the stability and resolution of the detection system used in this work, isotopic shifts with a magnitude less than one wavenumber have been identified. Principal component regression was used to evaluate the sensitivity to isotopic content of small Raman peak shifts in Li 2 CO 3 and indicates differences greater than 2 atom% could be reliably determined. These measurements add to the body of work on lithium isotope Raman spectroscopy for these two compounds and increases the number of Raman bands which could be used for lithium isotope content analysis.
- 1 December 2022
- Published by SAGE Publications in Applied Spectroscopy
- Vol. 77 (2) , 151-159
Isotopic Signatures of Lithium Carbonate and Lithium Hydroxide Monohydrate Measured Using Raman Spectroscopy
Lithium isotopic ratios have wide ranging applications as chemical signatures, including improved understanding of geochemical processes and battery development. Measurement of isotope ratios using optical spectroscopies would provide an alternative to traditional mass spectrometric methods, which are expensive and often limited to a chemical laboratory. Raman spectra of 7 Li 2 CO 3 , 6 Li 2 CO 3 , 7 LiOH*H 2 O, and 6 LiOH*H 2 O have been measured to determine the effect of lithium isotope substitution on the Raman molecular vibrations. Thirteen peaks were observed in the spectrum of lithium carbonate, with discernable isotopic shifts occurring in eleven of the 13 vibrations, two of which have not been previously reported in the literature. The spectrum of lithium hydroxide monohydrate contained nine peaks, with discernable isotopic shifts occurring in eight of the nine vibrations, four of which have not been previously reported in the literature. The Raman spectral data reported here for lithium carbonate and lithium hydroxide monohydrate are in agreement with the previously reported works in the literature, in which the Raman active modes of these molecules were first identified and assigned. However, due to the stability and resolution of the detection system used in this work, isotopic shifts with a magnitude less than one wavenumber have been identified. Principal component regression was used to evaluate the sensitivity to isotopic content of small Raman peak shifts in Li 2 CO 3 and indicates differences greater than 2 atom% could be reliably determined. These measurements add to the body of work on lithium isotope Raman spectroscopy for these two compounds and increases the number of Raman bands which could be used for lithium isotope content analysis.
- Open Access
- 7 April 2022
- Published by Wiley in Advanced Science
- Vol. 9 (16) , e2106032
Closo‐Borate Gel Polymer Electrolyte with Remarkable Electrochemical Stability and a Wide Operating Temperature Window
A major challenge in the pursuit of higher‐energy‐density lithium batteries for carbon‐neutral‐mobility is electrolyte compatibility with a lithium metal electrode. This study demonstrates the robust and stable nature of a closo‐borate based gel polymer electrolyte (GPE), which enables outstanding electrochemical stability and capacity retention upon extensive cycling. The GPE developed herein has an ionic conductivity of 7.3 × 10−4 S cm−2 at room temperature and stability over a wide temperature range from −35 to 80 °C with a high lithium transference number ( = 0.51). Multinuclear nuclear magnetic resonance and Fourier transform infrared are used to understand the solvation environment and interaction between the GPE components. Density functional theory calculations are leveraged to gain additional insight into the coordination environment and support spectroscopic interpretations. The GPE is also established to be a suitable electrolyte for extended cycling with four different active electrode materials when paired with a lithium metal electrode. The GPE can also be incorporated into a flexible battery that is capable of being cut and still functional. The incorporation of a closo‐borate into a gel polymer matrix represents a new direction for enhancing the electrochemical and physical properties of this class of materials.
- 7 April 2022
- Published by Wiley in Advanced Science
- Vol. 9 (16) , e2106032
Open AccessCloso‐Borate Gel Polymer Electrolyte with Remarkable Electrochemical Stability and a Wide Operating Temperature Window
A major challenge in the pursuit of higher‐energy‐density lithium batteries for carbon‐neutral‐mobility is electrolyte compatibility with a lithium metal electrode. This study demonstrates the robust and stable nature of a closo‐borate based gel polymer electrolyte (GPE), which enables outstanding electrochemical stability and capacity retention upon extensive cycling. The GPE developed herein has an ionic conductivity of 7.3 × 10−4 S cm−2 at room temperature and stability over a wide temperature range from −35 to 80 °C with a high lithium transference number ( = 0.51). Multinuclear nuclear magnetic resonance and Fourier transform infrared are used to understand the solvation environment and interaction between the GPE components. Density functional theory calculations are leveraged to gain additional insight into the coordination environment and support spectroscopic interpretations. The GPE is also established to be a suitable electrolyte for extended cycling with four different active electrode materials when paired with a lithium metal electrode. The GPE can also be incorporated into a flexible battery that is capable of being cut and still functional. The incorporation of a closo‐borate into a gel polymer matrix represents a new direction for enhancing the electrochemical and physical properties of this class of materials.
- 1 May 2021
- Published by Elsevier in Spectrochimica Acta Part B: Atomic Spectroscopy
- Vol. 179, 106108
A demonstration of spatial heterodyne spectrometers for remote LIBS, Raman spectroscopy, and 1D imaging
- 1 May 2021
- Published by Elsevier in Spectrochimica Acta Part B: Atomic Spectroscopy
- Vol. 179, 106108
A demonstration of spatial heterodyne spectrometers for remote LIBS, Raman spectroscopy, and 1D imaging
- 17 February 2021
- Published by Springer Nature
- p. 183-199
Use of an Infrared Spectroscopic Method for Isotopic Analysis of Gaseous Uranium Hexafluoride
- 17 February 2021
- Published by Springer Nature
- p. 183-199
Use of an Infrared Spectroscopic Method for Isotopic Analysis of Gaseous Uranium Hexafluoride