Huaimin Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Huaimin Zhou has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Shengchi Zhu
Southeast University
4 shared publications - Zhenxin Cao
Southeast University
4 shared publications - Guohu Deng
State Key Laboratory of Millimeter Waves, Southeast University, Nanjing, China
2 shared publications - Xin Quan
State Key Laboratory of Millimeter Waves, Southeast University, Nanjing, China
2 shared publications - Changzhi Xu
State Key Laboratory of Millimeter Waves, Southeast University, Nanjing, China
1 shared publication - Dongliang Liu
National Astronomical Observatories, Chinese Academy of Sciences
1 shared publication
Latest Publications
- 4 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (12) , 12358-12363
Common-Mode Resonance Suppressing Surface for Tightly Coupled Array
Common-mode resonance in traditional tightly coupled arrays (TCAs) limits bandwidth severely. In this communication, a common-mode resonance suppressing surface (CRSS) is proposed to mitigate the common-mode resonance. The CRSS is a surface etched with slots along the polarized direction placed below the antenna array to replace the ground of traditional TCAs. The CRSS cuts off the surface current on the ground, and thus the common-mode resonance is mitigated. Furthermore, a dual-linear polarized TCA embedded with the CRSS is simulated and manufactured, and the results show that it achieves an impedance bandwidth of 9.3:1 (0.6-5.58 GHz) and more than 90% radiation efficiency for broadside with the active VSWR≤3.0. Besides, such array remains the same bandwidth while scanning up to 60° in E-plane and D-plane and scanning up to 45° in H-plane with the active VSWR≤3.5. Therefore, the CRSS shows very promising application in engineering.
- 4 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 70 (12) , 12358-12363
Common-Mode Resonance Suppressing Surface for Tightly Coupled Array
Common-mode resonance in traditional tightly coupled arrays (TCAs) limits bandwidth severely. In this communication, a common-mode resonance suppressing surface (CRSS) is proposed to mitigate the common-mode resonance. The CRSS is a surface etched with slots along the polarized direction placed below the antenna array to replace the ground of traditional TCAs. The CRSS cuts off the surface current on the ground, and thus the common-mode resonance is mitigated. Furthermore, a dual-linear polarized TCA embedded with the CRSS is simulated and manufactured, and the results show that it achieves an impedance bandwidth of 9.3:1 (0.6-5.58 GHz) and more than 90% radiation efficiency for broadside with the active VSWR≤3.0. Besides, such array remains the same bandwidth while scanning up to 60° in E-plane and D-plane and scanning up to 45° in H-plane with the active VSWR≤3.5. Therefore, the CRSS shows very promising application in engineering.
- Open Access
- 3 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 105556-105563
A Low-Profile and Wide-Angle Scanning Planar Ultrawideband Modular Antenna With Ultra-Thin Loading Window
Ultrawideband phased antenna array has been widely used in communications, radars and detection. However, the high profile and poor wide-angle scanning characteristics have always been the critical limitation for many available ultrawideband antenna applications. In this paper, an ultra-thin loading window (UTLW) is proposed to replace the wide-angle impedance matching (WAIM) superstrate in the planar ultrawideband modular antenna arrays (PUMA), and reduces the profile height greatly. The UTLW consists of two strips in parallel, and each strip is loaded with one resistor and two capacitors. Following the equivalent circuit model (ECM) of the PUMA, the resistance and capacitance are specially designed to make the complex impedance of the UTLW equal to the impedance introduced by the WAIM. A dual-polarized PUMA with an UTLW achieves 6-18 GHz impedance bandwidth with active VSWR ${\mathbf \le }~2.6$ for scanning up to 60° and active VSWR ${\mathbf \le }~3$ for scanning up to 70° in E/D/H plane. The profile height of the proposed PUMA is only less than $0.07\boldsymbol {\lambda _{l}}$ , or, $0.24\boldsymbol {\lambda _{h}}$ with reference to the typical Nyquist half-wavelength spacing frequency. A $20\,\,\bf {\mathbf \times }\,\,20$ prototype PUMA with the UTLW was fabricated and its measured results were found consistent with the simulation results.
- 3 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 105556-105563
Open AccessA Low-Profile and Wide-Angle Scanning Planar Ultrawideband Modular Antenna With Ultra-Thin Loading Window
Ultrawideband phased antenna array has been widely used in communications, radars and detection. However, the high profile and poor wide-angle scanning characteristics have always been the critical limitation for many available ultrawideband antenna applications. In this paper, an ultra-thin loading window (UTLW) is proposed to replace the wide-angle impedance matching (WAIM) superstrate in the planar ultrawideband modular antenna arrays (PUMA), and reduces the profile height greatly. The UTLW consists of two strips in parallel, and each strip is loaded with one resistor and two capacitors. Following the equivalent circuit model (ECM) of the PUMA, the resistance and capacitance are specially designed to make the complex impedance of the UTLW equal to the impedance introduced by the WAIM. A dual-polarized PUMA with an UTLW achieves 6-18 GHz impedance bandwidth with active VSWR ${\mathbf \le }~2.6$ for scanning up to 60° and active VSWR ${\mathbf \le }~3$ for scanning up to 70° in E/D/H plane. The profile height of the proposed PUMA is only less than $0.07\boldsymbol {\lambda _{l}}$ , or, $0.24\boldsymbol {\lambda _{h}}$ with reference to the typical Nyquist half-wavelength spacing frequency. A $20\,\,\bf {\mathbf \times }\,\,20$ prototype PUMA with the UTLW was fabricated and its measured results were found consistent with the simulation results.
- Open Access
- 1 September 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (19) , 33980-33993
Ultra-wide transmission band frequency-selective rasorber using 2.5-D miniaturized structures
In this paper, a miniaturized frequency-selective rasorber (FSR) with an ultra-wide transmission band (| S21 | <1 dB) is presented. The FSR is made up of a lossless multi-layer cascaded frequency-selective surface (FSS) with a 2.5-D lossy layer above, separated by an air gap. Modified metallic Jerusalem crosses loaded with lumped resistors serve as the unit cell of the lossy layer. An equivalent parallel LC circuit with high inductance and extremely low parasitic capacitance is introduced by zigzag strips and vias, which broaden the transmission band significantly. The equivalent circuit model (ECM) is constructed to provide further insight into the structure. Simulation results show that the proposed FSR exhibits an ultra-wide transmission band of 1-dB from 6.20 to 17.97 GHz (97.4%) with a minimum insertion loss of 0.074 dB. Meanwhile, an 80% absorption band covering 2.58-4.13 GHz is achieved below the passband. For demonstration, an experimental prototype of the 2.5-D FSR is fabricated and measured, and the simulated and measured results are reasonably consistent.
- 1 September 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (19) , 33980-33993
Open AccessUltra-wide transmission band frequency-selective rasorber using 2.5-D miniaturized structures
In this paper, a miniaturized frequency-selective rasorber (FSR) with an ultra-wide transmission band (| S21 | <1 dB) is presented. The FSR is made up of a lossless multi-layer cascaded frequency-selective surface (FSS) with a 2.5-D lossy layer above, separated by an air gap. Modified metallic Jerusalem crosses loaded with lumped resistors serve as the unit cell of the lossy layer. An equivalent parallel LC circuit with high inductance and extremely low parasitic capacitance is introduced by zigzag strips and vias, which broaden the transmission band significantly. The equivalent circuit model (ECM) is constructed to provide further insight into the structure. Simulation results show that the proposed FSR exhibits an ultra-wide transmission band of 1-dB from 6.20 to 17.97 GHz (97.4%) with a minimum insertion loss of 0.074 dB. Meanwhile, an 80% absorption band covering 2.58-4.13 GHz is achieved below the passband. For demonstration, an experimental prototype of the 2.5-D FSR is fabricated and measured, and the simulated and measured results are reasonably consistent.