Ye Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ye Zhou has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Dunshan Yu
Peking Univ, Sch Integrated Circuits, Beijing 100871, Peoples R China
2 shared publications Shanzhe Yu
Peking Univ, Sch Integrated Circuits, Beijing 100871, Peoples R China
2 shared publications- Wengao Lu
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications - Yacong Zhang
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications - Zhongjian Chen
School of Integrated Circuits, Peking University, Beijing, China
2 shared publications Baojun Qin
Rail Transit Branch of China Communications Construction Co., Ltd, Beijing, China
1 shared publication
Latest Publications
- RetractedOpen Access
- 3 October 2022
- Published by Wiley in Journal of Sensors
- Vol. 2022, 1-12
A Low Power ROIC with Extended Counting ADC Based on Circuit Noise Analysis for Sensor Arrays in IoT System
As the Internet of Things (IoT) is rapidly integrated into our daily life, the demand for high performance readout integrated circuit (ROIC) design for sensor arrays is boosting. This paper presents a low power, low noise ROIC with 14-bit column-parallel extended counting (EC) ADCs for sensor arrays targeting the IoT applications. The proposed EC-ADC adopts a pseudodifferential architecture to cancel even-order nonlinearity. The analog front-end is a stage, which employs a current-reuse topology to boost the transconductance and reduce noise without increasing current consumption. The upper 9-bit conversion is implemented during integration, and the residual voltage is converted by a 5-bit single-slope (SS) ADC, where the comparator is reused. A ping-pong integrator is proposed to reduce the reset time and improve linearity, eliminating the power-hungry CTIA structure. The ROIC is designed in 0.18 μm 1P5M CMOS process for a sensor array. Power consumption of the ROIC is 33 mW, and each column ADC consumes 40.1 μW. Simulation results show an input-referred noise of 0.89 LSB (1.74 μVrms), an integral nonlinearity of +0.92/-0.70 LSB, an ENOB of 12.87 bits, and a FoM of 131.1 fJ/step.
- 3 October 2022
- Published by Wiley in Journal of Sensors
- Vol. 2022, 1-12
RetractedOpen AccessA Low Power ROIC with Extended Counting ADC Based on Circuit Noise Analysis for Sensor Arrays in IoT System
As the Internet of Things (IoT) is rapidly integrated into our daily life, the demand for high performance readout integrated circuit (ROIC) design for sensor arrays is boosting. This paper presents a low power, low noise ROIC with 14-bit column-parallel extended counting (EC) ADCs for sensor arrays targeting the IoT applications. The proposed EC-ADC adopts a pseudodifferential architecture to cancel even-order nonlinearity. The analog front-end is a stage, which employs a current-reuse topology to boost the transconductance and reduce noise without increasing current consumption. The upper 9-bit conversion is implemented during integration, and the residual voltage is converted by a 5-bit single-slope (SS) ADC, where the comparator is reused. A ping-pong integrator is proposed to reduce the reset time and improve linearity, eliminating the power-hungry CTIA structure. The ROIC is designed in 0.18 μm 1P5M CMOS process for a sensor array. Power consumption of the ROIC is 33 mW, and each column ADC consumes 40.1 μW. Simulation results show an input-referred noise of 0.89 LSB (1.74 μVrms), an integral nonlinearity of +0.92/-0.70 LSB, an ENOB of 12.87 bits, and a FoM of 131.1 fJ/step.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 698-704
Formation law and quality evaluation of slurry permeability membrane in high permeability formation
Based on the self-designed experimental device, slurry infiltration tests in different strata and pressures were carried out. The influence of slurry parameters on the film formation effect was analyzed with the water filtration quantity as the index of evaluation, and the control index suitable for the field engineering was proposed. The results show that, for formation process with high permeability and larger average pore size, it takes longer to form filter cake, and the stability of the filter cake is better; to obtain a stable filter cake on the surface of a high permeability stratum, particle size distribution and gravity matching with the stratum need to be chosen when preparing the slurry to ensure the content of particles entering the pores of the stratum. At the same time, viscosity-increasing components were added to increase the viscosity, which significantly enhances the binding force between the slurry and the particles and improving the stability of the filter cake; Water filtration quantity ratio above 0.6 can form a high-quality slurry film. Considering the actual construction efficiency, it is recommended that the ratio was controlled at 0.4~0.6.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 698-704
Formation law and quality evaluation of slurry permeability membrane in high permeability formation
Based on the self-designed experimental device, slurry infiltration tests in different strata and pressures were carried out. The influence of slurry parameters on the film formation effect was analyzed with the water filtration quantity as the index of evaluation, and the control index suitable for the field engineering was proposed. The results show that, for formation process with high permeability and larger average pore size, it takes longer to form filter cake, and the stability of the filter cake is better; to obtain a stable filter cake on the surface of a high permeability stratum, particle size distribution and gravity matching with the stratum need to be chosen when preparing the slurry to ensure the content of particles entering the pores of the stratum. At the same time, viscosity-increasing components were added to increase the viscosity, which significantly enhances the binding force between the slurry and the particles and improving the stability of the filter cake; Water filtration quantity ratio above 0.6 can form a high-quality slurry film. Considering the actual construction efficiency, it is recommended that the ratio was controlled at 0.4~0.6.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 265-269
Evaluation System of BIM Application Ability Based on Engineering Information Design
In order to more intuitively evaluate the application ability of BIM in engineering informatization design, this paper constructs an AHP evaluation model to comprehensively evaluate the informatization application depth of engineering projects. The overall model evaluates the application capability of information design from five dimensions: information management and control, technical operation, organization and management, comprehensive benefits, and potential innovation. The research results show that the two dimensions of information and technology have a more significant impact on the overall evaluation. The evaluation method has good operability and certain scientificity.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 265-269
Evaluation System of BIM Application Ability Based on Engineering Information Design
In order to more intuitively evaluate the application ability of BIM in engineering informatization design, this paper constructs an AHP evaluation model to comprehensively evaluate the informatization application depth of engineering projects. The overall model evaluates the application capability of information design from five dimensions: information management and control, technical operation, organization and management, comprehensive benefits, and potential innovation. The research results show that the two dimensions of information and technology have a more significant impact on the overall evaluation. The evaluation method has good operability and certain scientificity.
- Open Access
- 19 January 2021
- Published by Taylor & Francis
Optoelectronic Organic–Inorganic Semiconductor Heterojunctions
Optoelectronic Organic-Inorganic Semiconductor Heterojunctions summarizes advances in the development of organic-inorganic semiconductor heterojunctions, points out challenges and possible solutions for material/device design, and evaluates prospects for commercial applications. Introduces the concept and basic mechanism of semiconductor heterojunctions Describes a series of organic-inorganic semiconductor heterojunctions with desirable electrical and optical properties for optoelectronic devices Discusses typical devices such as solar cells, photo-detectors, and optoelectronic memories Outlines the materials and device challenges as well as possible strategies to promote the commercial translation of semiconductor heterojunctions-based optoelectronic devices Aimed at graduate students and researchers working in solid-state materials and electronics, this book offers a comprehensive yet accessible view of the state of the art and future directions.
- 19 January 2021
- Published by Taylor & Francis
Open AccessOptoelectronic Organic–Inorganic Semiconductor Heterojunctions
Optoelectronic Organic-Inorganic Semiconductor Heterojunctions summarizes advances in the development of organic-inorganic semiconductor heterojunctions, points out challenges and possible solutions for material/device design, and evaluates prospects for commercial applications. Introduces the concept and basic mechanism of semiconductor heterojunctions Describes a series of organic-inorganic semiconductor heterojunctions with desirable electrical and optical properties for optoelectronic devices Discusses typical devices such as solar cells, photo-detectors, and optoelectronic memories Outlines the materials and device challenges as well as possible strategies to promote the commercial translation of semiconductor heterojunctions-based optoelectronic devices Aimed at graduate students and researchers working in solid-state materials and electronics, this book offers a comprehensive yet accessible view of the state of the art and future directions.
- 1 May 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Polarization mode control in high contrast subwavelength grating VCSEL
We experimentally demonstrate deterministic polarization mode control in VCSEL utilizing a single-layer high-index-contrast subwavelength grating mirror. Orthogonal polarization suppression ratio of 36 and 28 dB was obtained under both CW and large-signal pulsed operation.
- 1 May 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Polarization mode control in high contrast subwavelength grating VCSEL
We experimentally demonstrate deterministic polarization mode control in VCSEL utilizing a single-layer high-index-contrast subwavelength grating mirror. Orthogonal polarization suppression ratio of 36 and 28 dB was obtained under both CW and large-signal pulsed operation.