Chunchao Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chunchao Yu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Zhixiong Yang
Kunming Institute of Physics, Kunming 650223, China
3 shared publications - Boyang Wang
Kunming Institute of Physics, Kunming 650223, China
2 shared publications - Kun Li
Kunming Institute of Physics, Kunming 650223, China
2 shared publications - Mingyao Yuan
Kunming Institute of Physics, Kunming 650223, China
2 shared publications - Jie Feng
School of Physics and Electronic Information, Yunnan Normal University, Kunming 650500, China
1 shared publication - Lingling Pang
Kunming Institute of Physics, Kunming 650223, China
1 shared publication
Latest Publications
- Open Access
Spectral Measurements of Muzzle Flash with a Temporally and Spatially Modulated LWIR-Imaging Fourier Transform Spectrometer
It is important to obtain information on an instantaneous target. A high-speed camera can capture a picture of an immediate scene, but spectral information about the object cannot be retrieved. Spectrographic analysis is a key tool for identifying chemicals. Detecting dangerous gas quickly can help ensure personal safety. In this paper, a temporally and spatially modulated long-wave infrared (LWIR)-imaging Fourier transform spectrometer was used to realize hyperspectral imaging. The spectral range was 700~1450 cm−1 (7~14.5 μm). The frame rate of infrared imaging was 200 Hz. The muzzle-flash area of guns with calibers of 5.56 mm, 7.62 mm, and 14.5 mm were detected. LWIR images of muzzle flash were obtained. Spectral information on muzzle flash was obtained using instantaneous interferograms. The main peak of the spectrum of the muzzle flash appeared at 970 cm−1 (10.31 μm). Two secondary peaks near 930 cm−1 (10.75 μm) and 1030 cm−1 (9.71 μm) were observed. Radiance and brightness temperature were also measured. The spatiotemporal modulation of the LWIR-imaging Fourier transform spectrometer provides a new method for rapid spectral detection. The high-speed identification of hazardous gas leakage can ensure personal safety.
Open AccessSpectral Measurements of Muzzle Flash with a Temporally and Spatially Modulated LWIR-Imaging Fourier Transform Spectrometer
It is important to obtain information on an instantaneous target. A high-speed camera can capture a picture of an immediate scene, but spectral information about the object cannot be retrieved. Spectrographic analysis is a key tool for identifying chemicals. Detecting dangerous gas quickly can help ensure personal safety. In this paper, a temporally and spatially modulated long-wave infrared (LWIR)-imaging Fourier transform spectrometer was used to realize hyperspectral imaging. The spectral range was 700~1450 cm−1 (7~14.5 μm). The frame rate of infrared imaging was 200 Hz. The muzzle-flash area of guns with calibers of 5.56 mm, 7.62 mm, and 14.5 mm were detected. LWIR images of muzzle flash were obtained. Spectral information on muzzle flash was obtained using instantaneous interferograms. The main peak of the spectrum of the muzzle flash appeared at 970 cm−1 (10.31 μm). Two secondary peaks near 930 cm−1 (10.75 μm) and 1030 cm−1 (9.71 μm) were observed. Radiance and brightness temperature were also measured. The spatiotemporal modulation of the LWIR-imaging Fourier transform spectrometer provides a new method for rapid spectral detection. The high-speed identification of hazardous gas leakage can ensure personal safety.
- Open Access
Chemical Gas Telemetry System Based on Multispectral Infrared Imaging
Environmental monitoring, public safety, safe production, and other areas all benefit greatly from the use of gas detection technologies. The infrared image of a gas could be used to determine its type from a long distance in gas detection. The infrared image can show the spatial distribution of the gas cloud and the background, allowing for long-distance and non-contact detection during safety production and hazardous chemical accident rescue. In this study, a gas detection system based on multispectral infrared imaging is devised, which can detect a variety of gases and determine the types of gas by separating the infrared radiation. It is made up of an imaging optical system, an uncooled focal plane detector, a filter controller, and a data gathering and processing system. The resolution of the infrared image is 640 × 512 and the working band of the system is 6.5~15 μm. The system can detect traces of pollutants in ambient air or gas clouds at higher concentrations. Ammonia, sulfur hexafluoride, methane, sulfur dioxide, and dimethyl methyl phosphonate were all successfully detected in real time. Ammonia clouds could be detected at a distance of 1124.5 m.
Open AccessChemical Gas Telemetry System Based on Multispectral Infrared Imaging
Environmental monitoring, public safety, safe production, and other areas all benefit greatly from the use of gas detection technologies. The infrared image of a gas could be used to determine its type from a long distance in gas detection. The infrared image can show the spatial distribution of the gas cloud and the background, allowing for long-distance and non-contact detection during safety production and hazardous chemical accident rescue. In this study, a gas detection system based on multispectral infrared imaging is devised, which can detect a variety of gases and determine the types of gas by separating the infrared radiation. It is made up of an imaging optical system, an uncooled focal plane detector, a filter controller, and a data gathering and processing system. The resolution of the infrared image is 640 × 512 and the working band of the system is 6.5~15 μm. The system can detect traces of pollutants in ambient air or gas clouds at higher concentrations. Ammonia, sulfur hexafluoride, methane, sulfur dioxide, and dimethyl methyl phosphonate were all successfully detected in real time. Ammonia clouds could be detected at a distance of 1124.5 m.
- Open Access
- 7 October 2022
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 19 (19) , 12828
CO Detection System Based on TDLAS Using a 4.625 μm Interband Cascaded Laser
During industrial operations and in confined places, carbon monoxide (CO) may collect in harmful proportions if ventilation is insufficient or appliances are not properly maintained. When the concentration of CO is too high, it might result in suffocation, coma, or even death. The detection of tiny concentrations of CO plays an important role in safe production. Due to the selective absorption of specific wavelengths of light by gas molecules, lasers have a wide range of applications in the field of gas detection. In this paper, a tunable diode laser absorption spectroscopy (TDLAS) system for CO detection was constructed using an interband cascaded laser (ICL) with a central wavelength of 4.625 μm. The modulated signal generated by the FPGA module was output to the laser controller to modulate the laser. The signal received by the detector was input to the FPGA module. After lock-in amplification, the second harmonic signal of high frequency modulation was output. Several concentrations of CO that were dispersed via static gas distribution were identified. A CO detection system with an open optical path was constructed, and the detection distance was about 8 m. The minimum detectable concentration is around 10.32 ppmm. The concentration of CO in the open optical path was 510.6 ppmm, according to the calibration of the detected concentration. The remote detection system based on TDLAS using an ICL can be used to monitor CO in the open optical path.
- 7 October 2022
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 19 (19) , 12828
Open AccessCO Detection System Based on TDLAS Using a 4.625 μm Interband Cascaded Laser
During industrial operations and in confined places, carbon monoxide (CO) may collect in harmful proportions if ventilation is insufficient or appliances are not properly maintained. When the concentration of CO is too high, it might result in suffocation, coma, or even death. The detection of tiny concentrations of CO plays an important role in safe production. Due to the selective absorption of specific wavelengths of light by gas molecules, lasers have a wide range of applications in the field of gas detection. In this paper, a tunable diode laser absorption spectroscopy (TDLAS) system for CO detection was constructed using an interband cascaded laser (ICL) with a central wavelength of 4.625 μm. The modulated signal generated by the FPGA module was output to the laser controller to modulate the laser. The signal received by the detector was input to the FPGA module. After lock-in amplification, the second harmonic signal of high frequency modulation was output. Several concentrations of CO that were dispersed via static gas distribution were identified. A CO detection system with an open optical path was constructed, and the detection distance was about 8 m. The minimum detectable concentration is around 10.32 ppmm. The concentration of CO in the open optical path was 510.6 ppmm, according to the calibration of the detected concentration. The remote detection system based on TDLAS using an ICL can be used to monitor CO in the open optical path.