Yang Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yang Gao has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Xiaotong Zhang
State Key Laboratory of Superhard Materials, Jilin University, Changchun 130012, China
2 shared publications - Yonghao Han
State Key Laboratory of High Pressure and Superhard Materials, College of Physics, Jilin University 1 , Changchun 130012
2 shared publications - Bao Liu
School of Science, Northeast Electric Power University, Jilin 132012, China
1 shared publication - Bin Yang
Center for High Pressure Science and Technology Advanced Research 3 , Beijing 100094
1 shared publication Dawei Jiang
State Key Laboratory of Superhard Materials, Jilin University, Changchun 130012, China
1 shared publication- Di Peng
Shanghai Key Laboratory of Material Frontiers Research in Extreme Environments (MFree), Shanghai Advanced Research in Physical Sciences (SHARPS), Shanghai, China
1 shared publication
Latest Publications
- Open Access
- 10 October 2025
- Published by AIP Publishing in Matter and Radiation at Extremes
- Vol. 10 (6)
Pressure-driven crystal symmetry and carrier concentration optimization for superior thermoelectric transport properties in layered AgCrSe2
Phase engineering has proven to be an effective strategy for achieving superior thermoelectric performance, while pressure is an excellent means of expanding the phase space of a material. In this paper, the effect of pressure-induced phase transition on improving the crystal symmetry and enhancing the thermoelectric properties of AgCrSe2 under high pressure and high temperature are reported. A structural phase transition from the low-symmetry R3m phase to the high-symmetry P3̄m1 phase is discovered below 1 GPa, which increases band degeneracy and contributes to a high electrical conductivity. For the metallic P3̄m1 phase, the electrons surrounding the Se2− anion gradually transfer to the Ag+ and Cr3+ cations as the pressure increases, decreasing the density of states around the Fermi level and thus optimizing the carrier concentration, thereby increasing the Seebeck coefficient while maintaining a high electrical conductivity. Consequently, an ultrahigh power factor of 864 μW·m−1·K−2 is achieved at 5 GPa and 297 K. This study provides new insights into improving thermoelectric transport properties by applying physical pressure to enhance crystal symmetry and optimize thermoelectric parameters, and also indicates that phase engineering is a compelling strategy to discover or design novel high-performance thermoelectric materials starting from low-symmetry compounds.
- 10 October 2025
- Published by AIP Publishing in Matter and Radiation at Extremes
- Vol. 10 (6)
Open AccessPressure-driven crystal symmetry and carrier concentration optimization for superior thermoelectric transport properties in layered AgCrSe2
Phase engineering has proven to be an effective strategy for achieving superior thermoelectric performance, while pressure is an excellent means of expanding the phase space of a material. In this paper, the effect of pressure-induced phase transition on improving the crystal symmetry and enhancing the thermoelectric properties of AgCrSe2 under high pressure and high temperature are reported. A structural phase transition from the low-symmetry R3m phase to the high-symmetry P3̄m1 phase is discovered below 1 GPa, which increases band degeneracy and contributes to a high electrical conductivity. For the metallic P3̄m1 phase, the electrons surrounding the Se2− anion gradually transfer to the Ag+ and Cr3+ cations as the pressure increases, decreasing the density of states around the Fermi level and thus optimizing the carrier concentration, thereby increasing the Seebeck coefficient while maintaining a high electrical conductivity. Consequently, an ultrahigh power factor of 864 μW·m−1·K−2 is achieved at 5 GPa and 297 K. This study provides new insights into improving thermoelectric transport properties by applying physical pressure to enhance crystal symmetry and optimize thermoelectric parameters, and also indicates that phase engineering is a compelling strategy to discover or design novel high-performance thermoelectric materials starting from low-symmetry compounds.
- 4 July 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (29) , 19606-19611
Study on pressure-induced isostructural phase transition and electrical transport properties of BiOBr
In this work, we prepared a BiOBr powder sample by the coprecipitation method for in situ high-pressure AC impedance spectroscopy tests, in situ high-pressure Raman measurements and in situ high-pressure X-ray diffraction experiments to explore its structural properties and electrical transport processes under compression. Two pressure-driven isostructural phase transitions, T–T′ and T′–T′′ (T – tetragonal, T′ – tetragonal 1 and T′′ – tetragonal 2), were discovered at around 10.0 and 15.0 GPa, respectively. The pressure-induced changes in the crystal structure and electrical transport of BiOBr can provide a reference for explaining the mechanism of the isostructural phase transition of other similar compounds after compression.
- 4 July 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (29) , 19606-19611
Study on pressure-induced isostructural phase transition and electrical transport properties of BiOBr
In this work, we prepared a BiOBr powder sample by the coprecipitation method for in situ high-pressure AC impedance spectroscopy tests, in situ high-pressure Raman measurements and in situ high-pressure X-ray diffraction experiments to explore its structural properties and electrical transport processes under compression. Two pressure-driven isostructural phase transitions, T–T′ and T′–T′′ (T – tetragonal, T′ – tetragonal 1 and T′′ – tetragonal 2), were discovered at around 10.0 and 15.0 GPa, respectively. The pressure-induced changes in the crystal structure and electrical transport of BiOBr can provide a reference for explaining the mechanism of the isostructural phase transition of other similar compounds after compression.
- 10 February 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (8) , 6288-6294
Effects of high pressure on the lattice structure and electrical transport properties of BiOI
To reveal the pressure effects on BiOX semiconductors, we performed in-situ Raman spectroscopy and electrical transport measurements on BiOI up to 26.1 GPa and 19.2 GPa. BiOI showed good structural stability, while the electron conduction characteristics maintained dominance throughout the pressure range. The influence of grain boundary conduction disappeared at pressures above 9.2 GPa. With pressure elevation, the pressure-induced lattice fragmentation and grain refinement introduced a large number of relevant levels in the energy gap and resulted in a significant increase in the conductivity of BiOI under compression. The conductivity increased by 106 at 19.2 GPa from the initial value and maintained an increase of 102 after depressurization until ambient conditions were attained. At the same time, the space charge polarization of the crystal interface layer became weaker with pressure elevation resulting in a decrease in the relative permittivity of BiOI. The calculation results of the complex permittivity showed that the frequency of orientation polarization response decreases with pressure elevation, and the complex permittivity becomes constant in the high-frequency region. Our work proves that pressure could significantly increase the carrier concentration and mobility, thus effectively improving the conductivity of BiOX semiconductors.
- 10 February 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (8) , 6288-6294
Effects of high pressure on the lattice structure and electrical transport properties of BiOI
To reveal the pressure effects on BiOX semiconductors, we performed in-situ Raman spectroscopy and electrical transport measurements on BiOI up to 26.1 GPa and 19.2 GPa. BiOI showed good structural stability, while the electron conduction characteristics maintained dominance throughout the pressure range. The influence of grain boundary conduction disappeared at pressures above 9.2 GPa. With pressure elevation, the pressure-induced lattice fragmentation and grain refinement introduced a large number of relevant levels in the energy gap and resulted in a significant increase in the conductivity of BiOI under compression. The conductivity increased by 106 at 19.2 GPa from the initial value and maintained an increase of 102 after depressurization until ambient conditions were attained. At the same time, the space charge polarization of the crystal interface layer became weaker with pressure elevation resulting in a decrease in the relative permittivity of BiOI. The calculation results of the complex permittivity showed that the frequency of orientation polarization response decreases with pressure elevation, and the complex permittivity becomes constant in the high-frequency region. Our work proves that pressure could significantly increase the carrier concentration and mobility, thus effectively improving the conductivity of BiOX semiconductors.
- 5 December 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (49) , 20983-20989
Pressure Effect on Self-Trapped Exciton and Dopant Energy Transfer in Neodymium-Doped CsPbBr3 Perovskite Nanocrystals
- 5 December 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (49) , 20983-20989
Pressure Effect on Self-Trapped Exciton and Dopant Energy Transfer in Neodymium-Doped CsPbBr3 Perovskite Nanocrystals
- 1 October 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (10) , 103904
Water-cooling diamond anvil cells: An approach to temperature–pressure relation in heated experiments
Temperature induced pressure drift in the diamond anvil cell (DAC) is a major issue in high-pressure high-temperature experiments. It is commonly acknowledged that these drifts originate from multiple factors, but no systematic descriptions have been made so far. By introducing an internal water-cooling system in the DAC, we have performed a systematic investigation into temperature induced pressure drifts to reveal the mechanism behind them and to find a proper experimental procedure to achieve minimal pressure variation in DAC’s heating experiment. It is revealed in this experiment that pressure variation during heating processes originates from multiple temperature related factors of the DAC. The variation itself can be considered as a rebalancing process of the compression forces on the sample chamber initiated by the disturbance caused by temperature elevation. It is possible to suppress pressure variation by maintaining the temperature of the DAC body at room temperature to ensure the consistency of compression on the sample chamber. At the same time, the best procedure for the heating experiments is to properly pre-heat the sample chamber equipped with the internal water-cooling system before performing the in situ measurements on the temperature-related properties at the pressurized and heated conditions. Our discovery provides a reliable procedure for the sample heating process in the DAC and helps resolve the complex mystery of the influence of the combination of pressure and temperature in high-pressure high-temperature experiments.
- 1 October 2022
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 93 (10) , 103904
Water-cooling diamond anvil cells: An approach to temperature–pressure relation in heated experiments
Temperature induced pressure drift in the diamond anvil cell (DAC) is a major issue in high-pressure high-temperature experiments. It is commonly acknowledged that these drifts originate from multiple factors, but no systematic descriptions have been made so far. By introducing an internal water-cooling system in the DAC, we have performed a systematic investigation into temperature induced pressure drifts to reveal the mechanism behind them and to find a proper experimental procedure to achieve minimal pressure variation in DAC’s heating experiment. It is revealed in this experiment that pressure variation during heating processes originates from multiple temperature related factors of the DAC. The variation itself can be considered as a rebalancing process of the compression forces on the sample chamber initiated by the disturbance caused by temperature elevation. It is possible to suppress pressure variation by maintaining the temperature of the DAC body at room temperature to ensure the consistency of compression on the sample chamber. At the same time, the best procedure for the heating experiments is to properly pre-heat the sample chamber equipped with the internal water-cooling system before performing the in situ measurements on the temperature-related properties at the pressurized and heated conditions. Our discovery provides a reliable procedure for the sample heating process in the DAC and helps resolve the complex mystery of the influence of the combination of pressure and temperature in high-pressure high-temperature experiments.