Jeong Min Park
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jeong Min Park has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Chang Goo Kang
Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute, Jeongeup-si, Republic of Korea
2 shared publications Chang Goo Kang
1 shared publicationChang-Xu Li
1 shared publicationGeon-Ju Choi
1 shared publication- Hong Joo Kim
Department of Physics, Kyungpook National University, Daegu 41566, Republic of Korea
1 shared publication Hongjoo Kim
1 shared publication
Latest Publications
- 1 July 2026
- Published by Elsevier in Optical Materials
- Vol. 179
Optical properties of CsPbBr3 nanocrystals scintillator under accelerator-based irradiation
- 1 July 2026
- Published by Elsevier in Optical Materials
- Vol. 179
Optical properties of CsPbBr3 nanocrystals scintillator under accelerator-based irradiation
- Open Access
- 12 June 2026
- Published by Elsevier in SSRN Electronic Journal
Flexible 64-Channel Indirect X-Ray Sensor Using a CsPbBr3-PVDF Scintillator Coupled to a Silicon Photodiode Array
Flexible X-ray sensors are of increasing interest for applications on curved or mechanically constrained surfaces; however, their practical implementation requires the integration of an X-ray conversion layer, a multichannel readout structure, and mechanically stable packaging within a single device platform. In this study, a flexible 64-channel indirect X-ray imaging sensor was developed by integrating a CsPbBr3–PVDF nanocomposite scintillator film with a silicon photodiode array fabricated on a polyimide-based flexible printed circuit board. The aim of this study was not to present a scintillator material report alone, but to validate a mechanically compliant multichannel X-ray sensing architecture. The fabricated array exhibited a dark current below 10 nA at a reverse bias of 10 V. After 1,000 bending cycles with a 10 mm displacement, the measured electrical variation remained below 5%, indicating stable operation under repeated mechanical deformation. Under X-ray irradiation, slit-type lead phantom measurements produced distinguishable multichannel response patterns, with contrast-to-noise ratios of 8.4–8.5 at 50–60 kV and 25 mA. Square-phantom measurements yielded a representative image signal-to-noise ratio of 2.54 and a uniformity metric of 22.97%. Open-beam measurements without a slit phantom showed an approximately linear dose-response behavior above 2.66 mGy, with an R² value of 0.9942. These results support the feasibility of the proposed scintillator-photodiode configuration as a proof-of-concept flexible multichannel X-ray sensing and imaging platform.
- 12 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessFlexible 64-Channel Indirect X-Ray Sensor Using a CsPbBr3-PVDF Scintillator Coupled to a Silicon Photodiode Array
Flexible X-ray sensors are of increasing interest for applications on curved or mechanically constrained surfaces; however, their practical implementation requires the integration of an X-ray conversion layer, a multichannel readout structure, and mechanically stable packaging within a single device platform. In this study, a flexible 64-channel indirect X-ray imaging sensor was developed by integrating a CsPbBr3–PVDF nanocomposite scintillator film with a silicon photodiode array fabricated on a polyimide-based flexible printed circuit board. The aim of this study was not to present a scintillator material report alone, but to validate a mechanically compliant multichannel X-ray sensing architecture. The fabricated array exhibited a dark current below 10 nA at a reverse bias of 10 V. After 1,000 bending cycles with a 10 mm displacement, the measured electrical variation remained below 5%, indicating stable operation under repeated mechanical deformation. Under X-ray irradiation, slit-type lead phantom measurements produced distinguishable multichannel response patterns, with contrast-to-noise ratios of 8.4–8.5 at 50–60 kV and 25 mA. Square-phantom measurements yielded a representative image signal-to-noise ratio of 2.54 and a uniformity metric of 22.97%. Open-beam measurements without a slit phantom showed an approximately linear dose-response behavior above 2.66 mGy, with an R² value of 0.9942. These results support the feasibility of the proposed scintillator-photodiode configuration as a proof-of-concept flexible multichannel X-ray sensing and imaging platform.
- Open Access
- 7 November 2024
- Published by Elsevier in Optical Materials
- Vol. 157
Scintillation properties of flexible scintillator composed on polydimethylsiloxane integrated with Lu2GdAl3Ga2O12:Pr2O3 phosphors
- 7 November 2024
- Published by Elsevier in Optical Materials
- Vol. 157
Open AccessScintillation properties of flexible scintillator composed on polydimethylsiloxane integrated with Lu2GdAl3Ga2O12:Pr2O3 phosphors
- Open Access
- 7 August 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (16) , 1324
Gamma-Irradiation-Induced Electrical Characteristic Variations in MoS2 Field-Effect Transistors with Buried Local Back-Gate Structure
The impact of radiation on MoS2-based devices is an important factor in the utilization of two-dimensional semiconductor-based technology in radiation-sensitive environments. In this study, the effects of gamma irradiation on the electrical variations in MoS2 field-effect transistors with buried local back-gate structures were investigated, and their related effects on Al2O3 gate dielectrics and MoS2/Al2O3 interfaces were also analyzed. The transfer and output characteristics were analyzed before and after irradiation. The current levels decreased by 15.7% under an exposure of 3 kGy. Additionally, positive shifts in the threshold voltages of 0.50, 0.99, and 1.15 V were observed under irradiations of 1, 2, and 3 kGy, respectively, compared to the non-irradiated devices. This behavior is attributable to the comprehensive effects of hole accumulation in the Al2O3 dielectric interface near the MoS2 side and the formation of electron trapping sites at the interface, which increased the electron tunneling at the MoS2 channel/dielectric interface.
- 7 August 2024
- Published by MDPI AG in Nanomaterials
- Vol. 14 (16) , 1324
Open AccessGamma-Irradiation-Induced Electrical Characteristic Variations in MoS2 Field-Effect Transistors with Buried Local Back-Gate Structure
The impact of radiation on MoS2-based devices is an important factor in the utilization of two-dimensional semiconductor-based technology in radiation-sensitive environments. In this study, the effects of gamma irradiation on the electrical variations in MoS2 field-effect transistors with buried local back-gate structures were investigated, and their related effects on Al2O3 gate dielectrics and MoS2/Al2O3 interfaces were also analyzed. The transfer and output characteristics were analyzed before and after irradiation. The current levels decreased by 15.7% under an exposure of 3 kGy. Additionally, positive shifts in the threshold voltages of 0.50, 0.99, and 1.15 V were observed under irradiations of 1, 2, and 3 kGy, respectively, compared to the non-irradiated devices. This behavior is attributable to the comprehensive effects of hole accumulation in the Al2O3 dielectric interface near the MoS2 side and the formation of electron trapping sites at the interface, which increased the electron tunneling at the MoS2 channel/dielectric interface.
- Open Access
- 1 October 2022
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (10) , 105901
Improvement of charge collection efficiency of the CdZnTe detectors by decreasing the Te inclusions
CdZnTe is a promising material for room-temperature radiation semiconductor detectors. However, their radiation response performance might be deteriorated owing to defects within the material such as Te inclusions. This study employs the Cd thermal annealing process to reduce the size of these Te inclusions. An ampoule containing Cd powder and CdZnTe was sealed under the vacuum conditions of 2.5 × 10−5 Torr for Cd-vapor annealing. Subsequently, the ampoule was annealed at 783 K for 64 h. An IR camera was used to observe the distribution of Te inclusions in the CdZnTe before and after annealing. As a second experiment, NH4F + H2O2 passivation was performed to suppress the increased leakage current due to Cd-vapor annealing. Then an 241Am radioisotope source was used to obtain a radiation response spectrum. The improved charge collection efficiency was about 35%.
- 1 October 2022
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (10) , 105901
Open AccessImprovement of charge collection efficiency of the CdZnTe detectors by decreasing the Te inclusions
CdZnTe is a promising material for room-temperature radiation semiconductor detectors. However, their radiation response performance might be deteriorated owing to defects within the material such as Te inclusions. This study employs the Cd thermal annealing process to reduce the size of these Te inclusions. An ampoule containing Cd powder and CdZnTe was sealed under the vacuum conditions of 2.5 × 10−5 Torr for Cd-vapor annealing. Subsequently, the ampoule was annealed at 783 K for 64 h. An IR camera was used to observe the distribution of Te inclusions in the CdZnTe before and after annealing. As a second experiment, NH4F + H2O2 passivation was performed to suppress the increased leakage current due to Cd-vapor annealing. Then an 241Am radioisotope source was used to obtain a radiation response spectrum. The improved charge collection efficiency was about 35%.