Anders Persson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anders Persson has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Olle Lundh
Lund University
5 shared publications - Andrea Angella
Lund University
3 shared publications - Cornelia Gustafsson
Lund University
3 shared publications - Erik Löfquist
Lund University
3 shared publications - Bastian Aurand
Heinrich Heine Univ Dusseldorf, Inst Laser & Plasmaphys, D-40225 Dusseldorf, Germany
2 shared publications C.-G. Wahlström
Lund University 1 Department of Physics P.O. Box 118, 22100 Lund, Sweden
2 shared publications
Latest Publications
- Open Access
- 10 February 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 136 (6) , 065001
Energy Bunching from Subcycle Ionization Injection in Laser Wakefield Acceleration
We report the first experimental observation of carrier-envelope phase-driven energy bunching in laser wakefield acceleration. Using a few-cycle ( ∼ 9 fs ), multiterawatt laser pulse and ionization injection in a helium-nitrogen gas mixture, we observe electron spectra composed of multiple quasimonoenergetic peaks with regular narrow energy spacing. This comb structure arises from intermittent trapping from successive half-cycles of the laser field enabled by the evolving carrier-envelope phase during propagation in the plasma. These findings establish subcycle ionization injection as a potential route to attosecond control in plasma acceleration, enabling trapping and beam structuring synchronized to the optical waveform on subfemtosecond timescales.
- 10 February 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 136 (6) , 065001
Open AccessEnergy Bunching from Subcycle Ionization Injection in Laser Wakefield Acceleration
We report the first experimental observation of carrier-envelope phase-driven energy bunching in laser wakefield acceleration. Using a few-cycle ( ∼ 9 fs ), multiterawatt laser pulse and ionization injection in a helium-nitrogen gas mixture, we observe electron spectra composed of multiple quasimonoenergetic peaks with regular narrow energy spacing. This comb structure arises from intermittent trapping from successive half-cycles of the laser field enabled by the evolving carrier-envelope phase during propagation in the plasma. These findings establish subcycle ionization injection as a potential route to attosecond control in plasma acceleration, enabling trapping and beam structuring synchronized to the optical waveform on subfemtosecond timescales.
- Open Access
- 30 October 2025
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 28 (10)
Correlated x-ray and electron beam steering by pulse-front tilt in laser wakefield acceleration
Laser wakefield accelerators produce ultrashort, highly relativistic electron and x-ray pulses in plasma over millimeter distances. Crucial for investigations and applications of these pulses is a reproducible and controlled output beam pointing. Even with a perfectly stable laser, pulse-front tilt in the driving laser pulse has been shown to cause both the laser pulse and the electron beam to deviate differently from the optical axis after the plasma. We show that this steering also extends to the generated x-rays, but in such a way that they perfectly follow the electron beam. The electron beam or x-ray beam pointing can thus be noninvasively inferred from the other, even when pulse-front-tilt steering is present. This enables active stabilization of either beam, without significant impact on key beam parameters such as energy, charge, and divergence.
- 30 October 2025
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 28 (10)
Open AccessCorrelated x-ray and electron beam steering by pulse-front tilt in laser wakefield acceleration
Laser wakefield accelerators produce ultrashort, highly relativistic electron and x-ray pulses in plasma over millimeter distances. Crucial for investigations and applications of these pulses is a reproducible and controlled output beam pointing. Even with a perfectly stable laser, pulse-front tilt in the driving laser pulse has been shown to cause both the laser pulse and the electron beam to deviate differently from the optical axis after the plasma. We show that this steering also extends to the generated x-rays, but in such a way that they perfectly follow the electron beam. The electron beam or x-ray beam pointing can thus be noninvasively inferred from the other, even when pulse-front-tilt steering is present. This enables active stabilization of either beam, without significant impact on key beam parameters such as energy, charge, and divergence.
- Open Access
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Spatiotemporal distribution of liquid mass in transient sprays using X-ray tomography from a laser-driven plasma accelerator
We present time-resolved three-dimensional measurements of the averaged liquid mass distribution generated by the Spray M from the Engine Combustion Network. The operating condition corresponds to a non-reacting early injection case for spray-guided gasoline injection during the first 200 μs. Few-femtosecond X-rays from a compact laser wakefield accelerator, enable quantitative spray measurements, from the nozzle tip to the spray front. Spray cone angles, plume directionality, and mass redistribution are quantified with spatial resolution of the order of 15 μm. Results show that the eight plumes exhibit a similar spatial distribution of liquid volume fraction. In addition, the distribution of liquid volume fraction changes over time, with maxima starting from the external periphery and moving toward the internal periphery of the plumes. This experiment demonstrates the possibility of studying the time-resolved three-dimensional liquid mass distribution of challenging multi-hole transient sprays running at high injection pressures. This opens new opportunities for validating spray simulations and advancing fuel injection technologies in next-generation combustion systems.
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Open AccessSpatiotemporal distribution of liquid mass in transient sprays using X-ray tomography from a laser-driven plasma accelerator
We present time-resolved three-dimensional measurements of the averaged liquid mass distribution generated by the Spray M from the Engine Combustion Network. The operating condition corresponds to a non-reacting early injection case for spray-guided gasoline injection during the first 200 μs. Few-femtosecond X-rays from a compact laser wakefield accelerator, enable quantitative spray measurements, from the nozzle tip to the spray front. Spray cone angles, plume directionality, and mass redistribution are quantified with spatial resolution of the order of 15 μm. Results show that the eight plumes exhibit a similar spatial distribution of liquid volume fraction. In addition, the distribution of liquid volume fraction changes over time, with maxima starting from the external periphery and moving toward the internal periphery of the plumes. This experiment demonstrates the possibility of studying the time-resolved three-dimensional liquid mass distribution of challenging multi-hole transient sprays running at high injection pressures. This opens new opportunities for validating spray simulations and advancing fuel injection technologies in next-generation combustion systems.
- Open Access
- 12 October 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (10) , 101301
Mechanisms to control laser-plasma coupling in laser wakefield electron acceleration
Experimental results, supported by precise modeling, demonstrate optimization of a plasma-based injector with intermediate laser pulse energy (), corresponding to a normalized vector potential , using ionization injection in a tailored plasma density profile. An increase in electron bunch quality and energy is achieved experimentally with the extension of the density downramp at the plasma exit. Optimization of the focal position of the laser pulse in the tailored plasma density profile is shown to efficiently reduce electron bunch angular deviation, leading to a better alignment of the electron bunch with the laser axis. Single peak electron spectra are produced in a previously unexplored regime by combining an early focal position and adaptive optic control of the laser wavefront by optimizing the symmetry of the prefocal laser energy distribution. Experimental results have been validated through particle-in-cell simulations using realistic laser energy, phase distribution, and temporal envelope, allowing for accurate predictions of difficult to model parameters, such as total charge and spatial properties of the electron bunches, opening the way for more accurate modeling for the design of plasma-based accelerators.- 12 October 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (10) , 101301
Open AccessMechanisms to control laser-plasma coupling in laser wakefield electron acceleration
Experimental results, supported by precise modeling, demonstrate optimization of a plasma-based injector with intermediate laser pulse energy (), corresponding to a normalized vector potential , using ionization injection in a tailored plasma density profile. An increase in electron bunch quality and energy is achieved experimentally with the extension of the density downramp at the plasma exit. Optimization of the focal position of the laser pulse in the tailored plasma density profile is shown to efficiently reduce electron bunch angular deviation, leading to a better alignment of the electron bunch with the laser axis. Single peak electron spectra are produced in a previously unexplored regime by combining an early focal position and adaptive optic control of the laser wavefront by optimizing the symmetry of the prefocal laser energy distribution. Experimental results have been validated through particle-in-cell simulations using realistic laser energy, phase distribution, and temporal envelope, allowing for accurate predictions of difficult to model parameters, such as total charge and spatial properties of the electron bunches, opening the way for more accurate modeling for the design of plasma-based accelerators. - Open Access
- 15 January 2018
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 60 (3) , 035014
Influence of micromachined targets on laser accelerated proton beam profiles
High intensity laser-driven proton acceleration from micromachined targets is studied experimentally in the target-normal-sheath-acceleration regime. Conical pits are created on the front surface of flat aluminium foils of initial thickness 12.5 μm and 3 μm using series of low energy pulses (0.5-2.5 μJ). Proton acceleration from such micromachined targets is compared with flat foils of equivalent thickness at a laser intensity of 710^19 W/cm^2. The maximum proton energy obtained from targets machined from 12.5 μm thick foils is found to be slightly lower than that of flat foils of equivalent remaining thickness, and the angular divergence of the proton beam is observed to increase as the depth of the pit approaches the foil thickness. Targets machined from 3 μm thick foils, on the other hand, show evidence of increasing the maximum proton energy when the depth of the structures are small. Furthermore, shallow pits on 3 μm thick foils are found to be efficient in reducing the proton beam divergence by up to a factor of three compared to that obtained from flat foils, while maintaining the maximum proton energy.
- 15 January 2018
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 60 (3) , 035014
Open AccessInfluence of micromachined targets on laser accelerated proton beam profiles
High intensity laser-driven proton acceleration from micromachined targets is studied experimentally in the target-normal-sheath-acceleration regime. Conical pits are created on the front surface of flat aluminium foils of initial thickness 12.5 μm and 3 μm using series of low energy pulses (0.5-2.5 μJ). Proton acceleration from such micromachined targets is compared with flat foils of equivalent thickness at a laser intensity of 710^19 W/cm^2. The maximum proton energy obtained from targets machined from 12.5 μm thick foils is found to be slightly lower than that of flat foils of equivalent remaining thickness, and the angular divergence of the proton beam is observed to increase as the depth of the pit approaches the foil thickness. Targets machined from 3 μm thick foils, on the other hand, show evidence of increasing the maximum proton energy when the depth of the structures are small. Furthermore, shallow pits on 3 μm thick foils are found to be efficient in reducing the proton beam divergence by up to a factor of three compared to that obtained from flat foils, while maintaining the maximum proton energy.
- Open Access
- 1 February 2016
- Published by AIP Publishing in Physics of Plasmas
- Vol. 23 (2) , 023113
Manipulation of the spatial distribution of laser-accelerated proton beams by varying the laser intensity distribution
We report on a study of the spatial profile of proton beams produced through target normal sheath acceleration using flat target foils and changing the laser intensity distribution on the target front surface. This is done by either defocusing a single laser pulse or by using a split-pulse setup and irradiating the target with two identical laser pulses with variable spatial separation. The resulting proton beam profile and the energy spectrum are recorded as functions of the focal spot size of the single laser pulse and of the separation between the two pulses. A shaping of the resulting proton beam profile, related to both an increase in flux of low-energy protons in the target normal direction and a decrease in their divergence, in one or two dimensions, is observed. The results are explained by simple modelling of rear surface sheath field expansion, ionization, and projection of the resulting proton beam.
- 1 February 2016
- Published by AIP Publishing in Physics of Plasmas
- Vol. 23 (2) , 023113
Open AccessManipulation of the spatial distribution of laser-accelerated proton beams by varying the laser intensity distribution
We report on a study of the spatial profile of proton beams produced through target normal sheath acceleration using flat target foils and changing the laser intensity distribution on the target front surface. This is done by either defocusing a single laser pulse or by using a split-pulse setup and irradiating the target with two identical laser pulses with variable spatial separation. The resulting proton beam profile and the energy spectrum are recorded as functions of the focal spot size of the single laser pulse and of the separation between the two pulses. A shaping of the resulting proton beam profile, related to both an increase in flux of low-energy protons in the target normal direction and a decrease in their divergence, in one or two dimensions, is observed. The results are explained by simple modelling of rear surface sheath field expansion, ionization, and projection of the resulting proton beam.
- Open Access
- 19 December 2014
- Published by Hindawi Limited in Laser and Particle Beams
- Vol. 33 (1) , 59-64
A setup for studies of laser-driven proton acceleration at the Lund Laser Centre
We report on a setup for the investigation of proton acceleration in the regime of target normal sheath acceleration. The main interest here is to focus on stable laser beam parameters as well as a reliable target setup and diagnostics in order to do extensive and systematic studies on the acceleration mechanism. A motorized target alignment system in combination with large target mounts allows for up to 340 shots with high repetition rate without breaking the vacuum. This performance is used to conduct experiments with a split mirror setup exploring the effect of spatial and temporal separation between the pulses on the acceleration mechanism and on the resulting proton beam.
- 19 December 2014
- Published by Hindawi Limited in Laser and Particle Beams
- Vol. 33 (1) , 59-64
Open AccessA setup for studies of laser-driven proton acceleration at the Lund Laser Centre
We report on a setup for the investigation of proton acceleration in the regime of target normal sheath acceleration. The main interest here is to focus on stable laser beam parameters as well as a reliable target setup and diagnostics in order to do extensive and systematic studies on the acceleration mechanism. A motorized target alignment system in combination with large target mounts allows for up to 340 shots with high repetition rate without breaking the vacuum. This performance is used to conduct experiments with a split mirror setup exploring the effect of spatial and temporal separation between the pulses on the acceleration mechanism and on the resulting proton beam.