S K Jebakumar
S K Jebakumar has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Abhay Anant Pashilkar
Senior Principal Scientist CSIR-National Aerospace Laboratories (NAL) Kodihalli Post, HAL Airport Road Bangalore-560 017
2 shared publications - Narasimhan Sundararajan
Department of Aerospace Engineering, Indian Institute of Science, Bengaluru, India
2 shared publications
Latest Publications
- Open Access
- 12 May 2023
- Published by Defence Scientific Information and Documentation Centre in Defence Science Journal
- Vol. 73 (3) , 263-273
Design and Verification of Carefree Maneuvering Protection for a High Performance Fighter Aircraft
Flight envelope protection for a high-performance aircraft poses a challenge to the designers and involves a time-consuming procedure to verify the provided protection. This paper presents a design approach to protect the aircraft from departure by a command path limiter for a rate command attitude hold controller in both the pitch and roll axes. In this approach, the maximum and minimum rates are scheduled as a function of the dynamic pressure on the basis of the open loop aircraft capabilities. This is then augmented with a novel angle of attack protection that comes into play only when the pilot inputs cause the aircraft to exceed the incidence on the positive or negative side (one sided protection), while maintaining the rate command attitude hold behavior within the normal operational bounds of angle of attack. Traditional methods of piloted simulation with a representative cohort of pilots can be time consuming to set up and may not give sufficient confidence whether a departure protection scheme is effective. To address this, a unique multi-modal search using genetic algorithm is developed to verify that this command path protection is able to achieve carefree maneuvering of a fighter aircraft in its entire flight envelope. The sequence of rapid pilot control inputs is coded into a chromosome. The multi-modal genetic algorithm then uses operators like cross-over and mutation on a starting population of chromosomes to evolve new inputs sequences which are then run to obtain the aircraft response. The cost function of the genetic algorithm which is constructed from the aircraft time response is designed to favor the search for multiple maxima which drive the aircraft to departure. The open domain ADMIRE model has been used to demonstrate the approach. Results indicate that the command path design proposed in this paper can be used to protect against departure and the novel multi-modal genetic algorithm helps to verify the departure protection.
- 12 May 2023
- Published by Defence Scientific Information and Documentation Centre in Defence Science Journal
- Vol. 73 (3) , 263-273
Open AccessDesign and Verification of Carefree Maneuvering Protection for a High Performance Fighter Aircraft
Flight envelope protection for a high-performance aircraft poses a challenge to the designers and involves a time-consuming procedure to verify the provided protection. This paper presents a design approach to protect the aircraft from departure by a command path limiter for a rate command attitude hold controller in both the pitch and roll axes. In this approach, the maximum and minimum rates are scheduled as a function of the dynamic pressure on the basis of the open loop aircraft capabilities. This is then augmented with a novel angle of attack protection that comes into play only when the pilot inputs cause the aircraft to exceed the incidence on the positive or negative side (one sided protection), while maintaining the rate command attitude hold behavior within the normal operational bounds of angle of attack. Traditional methods of piloted simulation with a representative cohort of pilots can be time consuming to set up and may not give sufficient confidence whether a departure protection scheme is effective. To address this, a unique multi-modal search using genetic algorithm is developed to verify that this command path protection is able to achieve carefree maneuvering of a fighter aircraft in its entire flight envelope. The sequence of rapid pilot control inputs is coded into a chromosome. The multi-modal genetic algorithm then uses operators like cross-over and mutation on a starting population of chromosomes to evolve new inputs sequences which are then run to obtain the aircraft response. The cost function of the genetic algorithm which is constructed from the aircraft time response is designed to favor the search for multiple maxima which drive the aircraft to departure. The open domain ADMIRE model has been used to demonstrate the approach. Results indicate that the command path design proposed in this paper can be used to protect against departure and the novel multi-modal genetic algorithm helps to verify the departure protection.
- Open Access
- 26 August 2022
- Published by Defence Scientific Information and Documentation Centre in Defence Science Journal
- Vol. 72 (4) , 505-515
A Novel Design Approach for Low Speed Recovery of High Performance Fighter Aircraft
In this paper, a novel design approach for low-speed recovery of a high-performance fighter aircraft is presented. It is shown that the phugoid mode has an important bearing on the problem of low-speed departure. Based on the analysis of the phugoid mode trajectories, a novel low-speed protection algorithm is presented in this paper. The proposed low speed recovery is achieved in three phases. The first phase consists of detecting the incipient departure followed in the second phase by the application of suitable recovery controls and finally the third phase ends with the transfer of controls to the pilot. The design of the first and the third phase consist of choosing the correct trigger conditions which ensures safe recovery of the aircraft in all conditions. The proposed Automatic low speed recovery is triggered when the aircraft trajectory crosses a fixed boundary in the region spanned by the dynamic pressure and its rate of decrease. It is observed that this boundary is approximately a straight line, implying that it is equivalent to a forward prediction in time to indicate when the aircraft will reach the lowest controllable airspeed. This Automatic Low Speed Recovery with Forward Prediction (ALSR-FP) algorithm is found to be simpler than other existing design methods and effective in preventing low speed departure for a variety of pilot inputs that result in the aircraft losing airspeed leading to stall. In the second phase control inputs are chosen to align the velocity vector to the direction of local gravity. The recovery phase is considered complete after the aircraft reaches the dynamic pressure which is approximately 10 % higher than the minimum dynamic pressure for control. Performance of the ALSR-FP is demonstrated using the high-performance fighter aircraft ADMIRE model which has a delta wing configuration, canards and multiple redundant controls. It is also shown that the proposed algorithm can be easily implemented on board for any other fighter and civil aircraft.
- 26 August 2022
- Published by Defence Scientific Information and Documentation Centre in Defence Science Journal
- Vol. 72 (4) , 505-515
Open AccessA Novel Design Approach for Low Speed Recovery of High Performance Fighter Aircraft
In this paper, a novel design approach for low-speed recovery of a high-performance fighter aircraft is presented. It is shown that the phugoid mode has an important bearing on the problem of low-speed departure. Based on the analysis of the phugoid mode trajectories, a novel low-speed protection algorithm is presented in this paper. The proposed low speed recovery is achieved in three phases. The first phase consists of detecting the incipient departure followed in the second phase by the application of suitable recovery controls and finally the third phase ends with the transfer of controls to the pilot. The design of the first and the third phase consist of choosing the correct trigger conditions which ensures safe recovery of the aircraft in all conditions. The proposed Automatic low speed recovery is triggered when the aircraft trajectory crosses a fixed boundary in the region spanned by the dynamic pressure and its rate of decrease. It is observed that this boundary is approximately a straight line, implying that it is equivalent to a forward prediction in time to indicate when the aircraft will reach the lowest controllable airspeed. This Automatic Low Speed Recovery with Forward Prediction (ALSR-FP) algorithm is found to be simpler than other existing design methods and effective in preventing low speed departure for a variety of pilot inputs that result in the aircraft losing airspeed leading to stall. In the second phase control inputs are chosen to align the velocity vector to the direction of local gravity. The recovery phase is considered complete after the aircraft reaches the dynamic pressure which is approximately 10 % higher than the minimum dynamic pressure for control. Performance of the ALSR-FP is demonstrated using the high-performance fighter aircraft ADMIRE model which has a delta wing configuration, canards and multiple redundant controls. It is also shown that the proposed algorithm can be easily implemented on board for any other fighter and civil aircraft.