Dezhi Huang
Research Subjects
Dezhi Huang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Antonello Monti
Fraunhofer Institute for Applied Information Technology
1 shared publication - Ferdinanda Ponci
E.ON Energy Research Center, Institute for Automation of Complex Power Systems, RWTH Aachen University, Aachen, Germany
1 shared publication - Junjie Tang
State Key Laboratory of Power Transmission Equipment Technology, School of Electrical Engineering, Chongqing University, Chongqing 401331, China
1 shared publication - Wei Yan
State Key Laboratory of Power Transmission Equipment & System Security and New Technology, Chongqing University, Shapingba District, Chongqing 400044, China
1 shared publication - Zhengmei Lu
State Key Laboratory of Power Transmission Equipment and System Security and New Technology, Chongqing University, Chongqing, China
1 shared publication
Latest Publications
- 13 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-12
State Estimation for Medium- and Low-Voltage Distribution Systems Considering Measurement Characteristics and Grounded Slack Bus
The medium voltage (MV) and low voltage (LV) distribution systems are usually built in a mixed three-phase three-wire and three-phase four-wire pattern, in which the conventional measurements are obtained through the two-wattmeter method (TWM) and three-wattmeter method (HWM). The existing three-phase state estimation (SE) models only involve the measurement characteristics of the HWM. Instead, a set of new and improved measurement equations are formulated in this paper for such buses measured by TWM, and the measurements include line-to-line complex power and virtual zero-sequence current. Along with the increasing underground cable, the neutral point of MV feeder head is normally grounded through a small resistance, and its voltage magnitude is not equal to zero. Accordingly, an accurate model for the slack bus together with its measurement equations is proposed herein, based on the conventional measurements and neutral point virtual measurement. Moreover, this work presents a three-phase SE model for MV and LV distribution systems that incorporates the constraints of zero-sequence current and zero injection, in combination with the exponentially weighted least squares method. The test results of the IEEE 34 bus system and IEEE 123 bus system verify that the proposed formulation takes full advantage of the measurements and structural characteristics of practical distribution networks, and simultaneously boosts the estimation accuracy.
- 13 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-12
State Estimation for Medium- and Low-Voltage Distribution Systems Considering Measurement Characteristics and Grounded Slack Bus
The medium voltage (MV) and low voltage (LV) distribution systems are usually built in a mixed three-phase three-wire and three-phase four-wire pattern, in which the conventional measurements are obtained through the two-wattmeter method (TWM) and three-wattmeter method (HWM). The existing three-phase state estimation (SE) models only involve the measurement characteristics of the HWM. Instead, a set of new and improved measurement equations are formulated in this paper for such buses measured by TWM, and the measurements include line-to-line complex power and virtual zero-sequence current. Along with the increasing underground cable, the neutral point of MV feeder head is normally grounded through a small resistance, and its voltage magnitude is not equal to zero. Accordingly, an accurate model for the slack bus together with its measurement equations is proposed herein, based on the conventional measurements and neutral point virtual measurement. Moreover, this work presents a three-phase SE model for MV and LV distribution systems that incorporates the constraints of zero-sequence current and zero injection, in combination with the exponentially weighted least squares method. The test results of the IEEE 34 bus system and IEEE 123 bus system verify that the proposed formulation takes full advantage of the measurements and structural characteristics of practical distribution networks, and simultaneously boosts the estimation accuracy.