GHGregory T. Hohensee

Gregory T. Hohensee

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Gregory T. Hohensee has a total of 7 co-authors. Here are the top co-authors by number of shared publications:

  • David G. Cahill

    Department of Materials Science and Engineering, Materials Research Laboratory, University of Illinois at Urbana-Champaign, Urbana, Illinois 61801, USA

    3 shared publications
  • Dallas R. Trinkle

    Department of Materials Science and Engineering University of Illinois at Urbana-Champaign 61801 Urbana Illinois USA

    1 shared publication
  • Joseph Patrick Feser

    Department of Mechanical Engineering, University of Delaware, Newark, Delaware 19716, United States

    1 shared publication
  • Mark D. Losego

    University of Illinois at Urbana-Champaign 2 Department of Materials Science and Engineering, Materials Research Laboratory Urbana, Illinois 61801, USA

    1 shared publication
  • Michael R. Fellinger

    Department of Materials Science and Engineering, Materials Research Laboratory, University of Illinois at Urbana-Champaign, Urbana, Illinois 61801, USA

    1 shared publication
  • Richard B. Wilson

    University of California, Riverside

    1 shared publication

Latest Publications

  • Open Access

    Thermal transport across high-pressure semiconductor-metal transition in Si andSi0.991Ge0.009

    by Gregory T. Hohensee, Michael R. Fellinger, Dallas R. Trinkle, David G. Cahill

    Time-domain thermoreflectance (TDTR) can be applied to metallic samples at high pressures in the diamond anvil cell and provide noncontact measurements of thermal transport properties. We have performed regular and beam-offset TDTR to establish the thermal conductivities of Si and Si0.991Ge0.009 across the semiconductor-metal phase transition and up to 45 GPa. The thermal conductivities of metallic Si and Si(Ge) are comparable to aluminum and indicative of predominantly electronic heat carriers. Metallic Si and Si(Ge) have an anisotropy of approximately 1.4, similar to that of beryllium, due to the primitive hexagonal crystal structure. We used the Wiedemann-Franz law to derive the associated electrical resistivity, and found it consistent with the Bloch-Grüneisen model.


  • Magnon-phonon coupling in the spin-ladder compound Ca9La5Cu24O41 measured by time-domain thermoreflectance

    by Gregory T. Hohensee, R. B. Wilson, Joseph P. Feser, David G. Cahill

    Below room temperature, the apparent thermal conductivity of the two-leg spin ladder, Ca9 La5 Cu24 O41, as measured by time-domain thermoreflectance (TDTR), depends on the frequency of the applied surface heating. This occurs because the thermal penetration depth in the TDTR experiment is comparable to the length scale for the equilibration of the magnons that are the dominant channel for heat conduction and the phonons that dominate the heat capacity. We apply a two-temperature model to analyze the TDTR data and extract an effective volumetric magnon-phonon coupling parameter g for Ca9 La5 Cu24 O41 at temperatures from 75 K to 300 K; g varies by approximately two orders of magnitude over this range of temperature and has the value g=1015Wm−3K−1 near the peak of the thermal conductivity at T≈180 K.


  • Interpreting picosecond acoustics in the case of low interface stiffness

    by Gregory T. Hohensee, Wen-Pin Hsieh, Mark D. Losego, David G. Cahill

    Analysis of data acquired in time-domain thermoreflectance (TDTR) experiments requires accurate measurements of the thickness of the metal film optical transducer that absorbs energy from the pump optical pulse and provides a temperature dependent reflectivity that is interrogated by the probe optical pulse. This thickness measurement is typically accomplished using picosecond acoustics. The presence of contaminants and native oxides at the interface between the sample and transducer often produce a picosecond acoustics signal that is difficult to interpret. We describe heuristics for addressing this common difficulty in interpreting picosecond acoustic data. The use of these heuristics can reduce the propagation of uncertainties and improve the accuracy of TDTR measurements of thermal transport properties.