Hui-Juan Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hui-Juan Liu has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Chang-Chong Liu
School of Civil Engineering, Dalian University of Technology, Dalian 116024, China
1 shared publication - Chun-Xu Qu
Dalian University of Technology
1 shared publication - Dengjie Zhu
Electric Power Research Institute, China Southern Power Grid Co., Ltd., Guangzhou 510663, China
1 shared publication - Hong-Nan Li
School of Infrastructure Engineering, Dalian University of Technology, Dalian 116024, P. R. China
1 shared publication - Wenming Wang
School of Civil Engineering, Shandong Jianzhu University, Jinan 250101, China
1 shared publication - Xiao-Mei Yang
School of Civil Engineering, Dalian University of Technology, Dalian 116024, China
1 shared publication
Latest Publications
- Open Access
Bearing Capacity of Transmission Poles under Combined Wind and Rain Excitations Based on the Deep Learning Method
Generally, only wind effect is considered in the collapse evaluation of transmission poles (TPs). However, during a typhoon landing, the rainfall is usually very heavy and the influence of the wind and rainfall should be considered simultaneously. To estimate the bearing capacity of TPs accurately during a typhoon, this paper proposes a method for predicting the water content distribution of soil based on the deep learning method. Then, the earth pressure distribution related to the rainfall is obtained. Furthermore, according to the static balance principle, the ultimate overturning moment of the TPs is obtained, and the corresponding critical wind speed is determined via a numerical simulation. Finally, a case study is tested and the collapse evaluation of TPs under the combined effects of wind and rainfall is obtained. The results show that the critical wind speed when considering rainfall is less than the value when ignoring the rainfall effect. The traditional method overestimates the structural safety of the TPs because the rainfall has a significant reduction on the bearing capacity of TPs.
Open AccessBearing Capacity of Transmission Poles under Combined Wind and Rain Excitations Based on the Deep Learning Method
Generally, only wind effect is considered in the collapse evaluation of transmission poles (TPs). However, during a typhoon landing, the rainfall is usually very heavy and the influence of the wind and rainfall should be considered simultaneously. To estimate the bearing capacity of TPs accurately during a typhoon, this paper proposes a method for predicting the water content distribution of soil based on the deep learning method. Then, the earth pressure distribution related to the rainfall is obtained. Furthermore, according to the static balance principle, the ultimate overturning moment of the TPs is obtained, and the corresponding critical wind speed is determined via a numerical simulation. Finally, a case study is tested and the collapse evaluation of TPs under the combined effects of wind and rainfall is obtained. The results show that the critical wind speed when considering rainfall is less than the value when ignoring the rainfall effect. The traditional method overestimates the structural safety of the TPs because the rainfall has a significant reduction on the bearing capacity of TPs.
- Open Access
- 17 October 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (10) , 1509
Modal Identification of Structures by Eliminating the Effect of the High Ocean Wind
Tropical cyclone is a rapidly rotating storm system with severe excitation such as high wind. This severe excitation may change the performance of structures, such as bridges, wharves and wind turbine structures. It is very necessary to monitor this important change. Modal parameters are the ones to reflect the structural instinct behavior. However, many identification methods assume that the excitation is white noise, which is not the truth during high ocean wind excitation. Therefore, the modal identification method to deal with severe ocean wind excitation should be investigated. This paper proposes an innovative method to eliminate the effect of high ocean wind on modal identification. The formulation to generate an impulse response is described, where the effect of high wind is pointed. Then the elimination method is derived using the wind velocity spectrum and correlation function. After the wind field is simulated, the wind velocities and spectra at all accelerometer positions are obtained. The real impulse response form is obtained. Then, modal identification using the real impulse response is performed. Finally, a practical cable-stayed bridge is employed and modal identification is performed. The results show that the identified modes can reflect structural real behavior.
- 17 October 2022
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 10 (10) , 1509
Open AccessModal Identification of Structures by Eliminating the Effect of the High Ocean Wind
Tropical cyclone is a rapidly rotating storm system with severe excitation such as high wind. This severe excitation may change the performance of structures, such as bridges, wharves and wind turbine structures. It is very necessary to monitor this important change. Modal parameters are the ones to reflect the structural instinct behavior. However, many identification methods assume that the excitation is white noise, which is not the truth during high ocean wind excitation. Therefore, the modal identification method to deal with severe ocean wind excitation should be investigated. This paper proposes an innovative method to eliminate the effect of high ocean wind on modal identification. The formulation to generate an impulse response is described, where the effect of high wind is pointed. Then the elimination method is derived using the wind velocity spectrum and correlation function. After the wind field is simulated, the wind velocities and spectra at all accelerometer positions are obtained. The real impulse response form is obtained. Then, modal identification using the real impulse response is performed. Finally, a practical cable-stayed bridge is employed and modal identification is performed. The results show that the identified modes can reflect structural real behavior.