David Bernacchia
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
David Bernacchia has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Marco Zannoni
Università di Bologna
4 shared publications - Riccardo Lasagni Manghi
Department of Industrial Engineering, Alma Mater Studiorum - University of Bologna, Via Luciano Montaspro 97, Forlì, FC, Forlì, Italy, 47121
4 shared publications - Luciano Iess
Sapienza University of Rome
3 shared publications - Paolo Cappuccio
Aurora Technology BV for ESA, European Space Agency, European Space Astronomy Centre (ESAC), Camino Bajo del Castillo s/n, Villanueva de la Canada, 28692, Madrid, Spain
3 shared publications - Paolo Tortora
Università di Bologna
3 shared publications Antonio Martellucci
European Space Agency ESA‐ESTEC Noordwijk The Netherlands
2 shared publications
Latest Publications
- Open Access
- 17 October 2026
- Published by Wiley
Characterization of solar plasma's impact on Doppler and range observables through the analysis of BepiColombo, Cassini and Juno data
Solar plasma represents a major source of error in deep-space radio tracking, with stochastic fluctuations in Doppler observables and systematic group-delay biases in range measurements among its most relevant effects. In this work, multifrequency radiometric data from BepiColombo, Cassini, and Juno are analyzed to characterize these effects over a broad range of observation geometries and solar conditions. Plasma contributions are isolated using triple link, single uplink, and dual uplink configurations. For Doppler measurements, the extracted plasma signal is characterized in terms of Allan deviation. Since the multifrequency combination also introduces a residual thermal-noise contribution, the Allan deviation curves are corrected for this effect before model estimation. The corrected values at 60 s are then used to derive an empirical model for two-way X/X plasma-induced Doppler noise as a function of observation geometry. The resulting formulation can be rescaled to other integration times and radio links by accounting for the characteristic Allan-deviation dependence on integration time and the frequency scaling of plasma-induced effects. For range measurements, BepiColombo multifrequency data are used to estimate a model of the plasma-induced path delay based on a power-law electron-density profile. This approach provides an empirical representation of the average geometrical dependence of the plasma-induced range bias on the propagation geometry and carrier frequencies. Overall, the proposed models provide a quantitative empirical description of solar-plasma effects on Doppler and range observables, offering practical tools for radio-science error budgets, tracking-performance assessment, and observation planning for future deep-space missions.
- 17 October 2026
- Published by Wiley
Open AccessCharacterization of solar plasma's impact on Doppler and range observables through the analysis of BepiColombo, Cassini and Juno data
Solar plasma represents a major source of error in deep-space radio tracking, with stochastic fluctuations in Doppler observables and systematic group-delay biases in range measurements among its most relevant effects. In this work, multifrequency radiometric data from BepiColombo, Cassini, and Juno are analyzed to characterize these effects over a broad range of observation geometries and solar conditions. Plasma contributions are isolated using triple link, single uplink, and dual uplink configurations. For Doppler measurements, the extracted plasma signal is characterized in terms of Allan deviation. Since the multifrequency combination also introduces a residual thermal-noise contribution, the Allan deviation curves are corrected for this effect before model estimation. The corrected values at 60 s are then used to derive an empirical model for two-way X/X plasma-induced Doppler noise as a function of observation geometry. The resulting formulation can be rescaled to other integration times and radio links by accounting for the characteristic Allan-deviation dependence on integration time and the frequency scaling of plasma-induced effects. For range measurements, BepiColombo multifrequency data are used to estimate a model of the plasma-induced path delay based on a power-law electron-density profile. This approach provides an empirical representation of the average geometrical dependence of the plasma-induced range bias on the propagation geometry and carrier frequencies. Overall, the proposed models provide a quantitative empirical description of solar-plasma effects on Doppler and range observables, offering practical tools for radio-science error budgets, tracking-performance assessment, and observation planning for future deep-space missions.
- Open Access
- 18 December 2025
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 60 (12)
Comparison of Plasma Calibration Techniques to Enhance Radiometric Observables Performance: BepiColombo MORE Test Case
We present and compare different techniques to isolate the dispersive noise contribution from radiometric observables in deep space missions. These techniques have been tested using range and Doppler data collected during five superior solar conjunctions of ESA's (European Space Agency) BepiColombo spacecraft in its cruise phase. First, we present the state‐of‐the‐art of BepiColombo multifrequency link calibration scheme, which leverages on three 2‐way links in X/X, X/Ka and Ka/Ka band. Then we compare its performance with alternative dual‐link schemes, based on a combination of only two of the three links listed above. Our analyses find that the best dual‐link configuration, achieved with the method reported in Mariotti and Tortora (2013, https://doi.org/10.1002/rds.20024 ), is the X/X + Ka/Ka configuration, which on average decreases the RMS noise with respect to the non‐calibrated Ka/Ka residuals by ∼64% for BepiColombo's Doppler data (compressed at 60 s) and by 37% for range data (at integration time of 2 s). Finally, our analysis points out that during radio tracking passes characterized by a low plasma content, the dual link configuration X/X + Ka/Ka provides better performance on range data with respect to the classic full triple link configuration. This can be explained by the higher thermal noise contribution on range measurements due to the smaller integration time with respect to Doppler data: in fact, with the triple link scheme we have a contribution from the thermal noise of the three links while with the dual link configurations only from two.
- 18 December 2025
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 60 (12)
Open AccessComparison of Plasma Calibration Techniques to Enhance Radiometric Observables Performance: BepiColombo MORE Test Case
We present and compare different techniques to isolate the dispersive noise contribution from radiometric observables in deep space missions. These techniques have been tested using range and Doppler data collected during five superior solar conjunctions of ESA's (European Space Agency) BepiColombo spacecraft in its cruise phase. First, we present the state‐of‐the‐art of BepiColombo multifrequency link calibration scheme, which leverages on three 2‐way links in X/X, X/Ka and Ka/Ka band. Then we compare its performance with alternative dual‐link schemes, based on a combination of only two of the three links listed above. Our analyses find that the best dual‐link configuration, achieved with the method reported in Mariotti and Tortora (2013, https://doi.org/10.1002/rds.20024 ), is the X/X + Ka/Ka configuration, which on average decreases the RMS noise with respect to the non‐calibrated Ka/Ka residuals by ∼64% for BepiColombo's Doppler data (compressed at 60 s) and by 37% for range data (at integration time of 2 s). Finally, our analysis points out that during radio tracking passes characterized by a low plasma content, the dual link configuration X/X + Ka/Ka provides better performance on range data with respect to the classic full triple link configuration. This can be explained by the higher thermal noise contribution on range measurements due to the smaller integration time with respect to Doppler data: in fact, with the triple link scheme we have a contribution from the thermal noise of the three links while with the dual link configurations only from two.
- Open Access
- 9 February 2023
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 58 (2)
Tropospheric Delay Calibration System Performance During the First Two BepiColombo Solar Conjunctions
Media propagation delay and delay‐rate induced by the water vapor within the Earth's troposphere represent one of the main error sources for radiometric measurements in deep space. In preparation for the BepiColombo and JUICE missions, the European Space Agency has installed and operates the prototype of a tropospheric delay calibration system (TDCS) at the DSA‐3 ground station located in Malargüe, Argentina. An initial characterization of the TDCS performance was realized using two‐way Doppler measurements at X‐band to perform the orbit determination of the Gaia spacecraft. This work will further characterize the system by analyzing two‐way Doppler and range data at X‐ and Ka‐band for 31 tracking passes of the BepiColombo spacecraft, which were recorded between March 2021 and February 2022 during the first two solar conjunction experiments. The performance exceeds the expectations based on the previous analysis, with a reduction of the Doppler noise of 51% on average and up to 73% when using the TDCS measurements in place of standard calibrations based on global navigation satellite system data. Furthermore, the campaign serves as validation of the TDCS operations during superior solar conjunctions, with most of the tracking passes at low elongation now satisfying the Mercury orbiter radioscience experiment requirements on two‐way Doppler stability. These results, which are in line with those of similar instruments installed at other Deep Space Network antennas, are obtained using a commercial microwave radiometer with significantly lower installation and maintenance costs.
- 9 February 2023
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 58 (2)
Open AccessTropospheric Delay Calibration System Performance During the First Two BepiColombo Solar Conjunctions
Media propagation delay and delay‐rate induced by the water vapor within the Earth's troposphere represent one of the main error sources for radiometric measurements in deep space. In preparation for the BepiColombo and JUICE missions, the European Space Agency has installed and operates the prototype of a tropospheric delay calibration system (TDCS) at the DSA‐3 ground station located in Malargüe, Argentina. An initial characterization of the TDCS performance was realized using two‐way Doppler measurements at X‐band to perform the orbit determination of the Gaia spacecraft. This work will further characterize the system by analyzing two‐way Doppler and range data at X‐ and Ka‐band for 31 tracking passes of the BepiColombo spacecraft, which were recorded between March 2021 and February 2022 during the first two solar conjunction experiments. The performance exceeds the expectations based on the previous analysis, with a reduction of the Doppler noise of 51% on average and up to 73% when using the TDCS measurements in place of standard calibrations based on global navigation satellite system data. Furthermore, the campaign serves as validation of the TDCS operations during superior solar conjunctions, with most of the tracking passes at low elongation now satisfying the Mercury orbiter radioscience experiment requirements on two‐way Doppler stability. These results, which are in line with those of similar instruments installed at other Deep Space Network antennas, are obtained using a commercial microwave radiometer with significantly lower installation and maintenance costs.
- Open Access
- 9 November 2022
- Published by Wiley in ESS Open Archive
Tropospheric Delay Calibration System performance during the first two BepiColombo solar conjunctions
Media propagation delay and delay-rate induced by the water vapor within the Earth’s troposphere represent one of the main error sources for radiometric measurements in deep space. In preparation for the BepiColombo and JUICE missions, the European Space Agency has installed the prototype of a tropospheric delay calibration system (TDCS) at the DSA-3 ground station located in Malargüe, Argentina. An initial characterization of the TDCS performance was realized using the orbit determination of the Gaia spacecraft as a testbed. This work will further characterize the system by analyzing the BepiColombo tracking passes, which were recorded between March 2021 and February 2022 during the first two superior solar conjunction experiments. The performance exceeds the expectations based on the previous analysis, with an average 51% reduction of the Doppler noise when using the TDCS measurements in place of standard calibrations based on global navigation satellite system data. The tropospheric instability at long time scales is also significantly reduced, with most of the tracking passes now satisfying the Mercury orbiter radioscience experiment (MORE) requirements on two-way Doppler stability.
- 9 November 2022
- Published by Wiley in ESS Open Archive
Open AccessTropospheric Delay Calibration System performance during the first two BepiColombo solar conjunctions
Media propagation delay and delay-rate induced by the water vapor within the Earth’s troposphere represent one of the main error sources for radiometric measurements in deep space. In preparation for the BepiColombo and JUICE missions, the European Space Agency has installed the prototype of a tropospheric delay calibration system (TDCS) at the DSA-3 ground station located in Malargüe, Argentina. An initial characterization of the TDCS performance was realized using the orbit determination of the Gaia spacecraft as a testbed. This work will further characterize the system by analyzing the BepiColombo tracking passes, which were recorded between March 2021 and February 2022 during the first two superior solar conjunction experiments. The performance exceeds the expectations based on the previous analysis, with an average 51% reduction of the Doppler noise when using the TDCS measurements in place of standard calibrations based on global navigation satellite system data. The tropospheric instability at long time scales is also significantly reduced, with most of the tracking passes now satisfying the Mercury orbiter radioscience experiment (MORE) requirements on two-way Doppler stability.