Aurelian Cosmin Moldovan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Aurelian Cosmin Moldovan has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Valer Micle
Technical University of Cluj-Napoca
4 shared publications - Nicolae Marcoie
Faculty of Hydrotechnical Engineering, Geodesy and Environmental Engineering, “Gheorghe Asachi” Technical University of Iasi, Bd. Prof. Dimitrie Mangeron, No. 65, 700050 Iaşi, Romania
3 shared publications - Tomi Alexandrel Hrăniciuc
Faculty of Hydrotechnics, Geodesy and Environmental Engineering, “Gheorghe Asachi” Technical University of Iasi, Dimitrie Mangeron Blvd. nr. 65, 700050 Iasi, Romania
3 shared publications - Ioana Monica Sur
Technical University of Cluj-Napoca
2 shared publications - Irina Smical
Engineering of Mineral Resources, Materials and Environment Department, North University Centre of Baia Mare, Technical University of Cluj-Napoca, 430083 Baia Mare, Romania
2 shared publications - Adriana Muntean
Maramureș Water Management System, Someș-Tisa Basinal Water Administration, No. 2, Hortensiei Street, 430294 Baia Mare, Romania
1 shared publication
Latest Publications
- Open Access
- 20 September 2026
- Published by MDPI AG in Sustainability
- Vol. 18 (18) , 9643
Hydrometeorological Conditions and Sustainable Reservoir Management for Flood Risk Reduction: A Hydraulic Modeling Approach Supporting Climate Action at Colibița Dam, Romania
Dams are critical infrastructures for water supply, flood mitigation, hydropower generation, and sustainable water resources management. However, operational maneuvers and extreme hydrometeorological events may require controlled reservoir releases, which can increase flood risk in downstream communities. In the context of climate change and increasing hydrometeorological variability, sustainable reservoir operation requires an integrated assessment of water availability, flood hazard, and downstream vulnerability. This study investigates the potential flood risk associated with controlled water releases from the Colibița Dam in Romania and their implications for sustainable water resources management and adaptation to climate change. Hydrometeorological data, topographic measurements, dam characteristics, and precipitation data for the period 2001–2024 were considered. A one-dimensional hydraulic model developed in MIKE 11 was used to simulate water releases through the bottom and secondary bottom outlets under low-flow and increased-flow conditions. Three operational scenarios were evaluated: (i) opening each outlet individually at 50% capacity, (ii) opening each outlet individually at 100% capacity, and (iii) simultaneously opening both outlets at 100% capacity. The results indicate that water releases under low-flow conditions generally pose a limited flood risk to downstream areas. The highest flood risk occurs during periods of elevated river discharge when both outlets are operated simultaneously at full capacity, causing the water level at the Bistrița Bârgăului hydrometric station to exceed the danger threshold by 21 cm. At the Bistrița station, the water level exceeds the attention level by 87 cm while remaining 13 cm below the flood level. The findings demonstrate that integrating hydrometeorological forecasts with hydraulic modeling improves adaptive reservoir operation, reduces downstream flood risk, and strengthens resilience to climate-related hazards, thereby supporting Sustainable Development Goal (SDG) 13.1.
- 20 September 2026
- Published by MDPI AG in Sustainability
- Vol. 18 (18) , 9643
Open AccessHydrometeorological Conditions and Sustainable Reservoir Management for Flood Risk Reduction: A Hydraulic Modeling Approach Supporting Climate Action at Colibița Dam, Romania
Dams are critical infrastructures for water supply, flood mitigation, hydropower generation, and sustainable water resources management. However, operational maneuvers and extreme hydrometeorological events may require controlled reservoir releases, which can increase flood risk in downstream communities. In the context of climate change and increasing hydrometeorological variability, sustainable reservoir operation requires an integrated assessment of water availability, flood hazard, and downstream vulnerability. This study investigates the potential flood risk associated with controlled water releases from the Colibița Dam in Romania and their implications for sustainable water resources management and adaptation to climate change. Hydrometeorological data, topographic measurements, dam characteristics, and precipitation data for the period 2001–2024 were considered. A one-dimensional hydraulic model developed in MIKE 11 was used to simulate water releases through the bottom and secondary bottom outlets under low-flow and increased-flow conditions. Three operational scenarios were evaluated: (i) opening each outlet individually at 50% capacity, (ii) opening each outlet individually at 100% capacity, and (iii) simultaneously opening both outlets at 100% capacity. The results indicate that water releases under low-flow conditions generally pose a limited flood risk to downstream areas. The highest flood risk occurs during periods of elevated river discharge when both outlets are operated simultaneously at full capacity, causing the water level at the Bistrița Bârgăului hydrometric station to exceed the danger threshold by 21 cm. At the Bistrița station, the water level exceeds the attention level by 87 cm while remaining 13 cm below the flood level. The findings demonstrate that integrating hydrometeorological forecasts with hydraulic modeling improves adaptive reservoir operation, reduces downstream flood risk, and strengthens resilience to climate-related hazards, thereby supporting Sustainable Development Goal (SDG) 13.1.
- Open Access
- 30 April 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (9) , 4072
Study on Human Health Risks Associated with Consuming Vegetables Grown in Industrially Polluted Soil in Sasar Area, NW Romania, in the Context of Sustainable Development
This study analyzed the health risks associated with the consumption of certain vegetables (carrot, onion, tomato, and pepper) grown in soils potentially polluted with metals (Cd, Cu, Mn, Ni, Pb, Zn) and metalloids (As) from 15 vegetable gardens in the Sasar locality. The research includes measurement of soil and plant metal concentrations, assessment of global pollution of soils with metals using Nemerow pollution index (PIN), calculation of the metal transfer factor (TF) from soil to vegetable, daily intake of metal dose (DIM) and health risk index (HRI) for both children and adults. The results (mean of 3 replicas ± standard deviation) show that the soil is moderately polluted with lead (28.39 ± 8.623 mg kg−1), nickel (23.17 ± 4.043 mg kg−1), and zinc (123.20 ± 26.918 mg kg−1), strongly polluted with copper (71.68 ± 22.463 mg kg−1), and cadmium (2.63 ± 0.881 mg kg−1). Copper exhibited the highest transfer factors (>0.08), followed by cadmium (~0.06), while zinc and nickel showed moderate values (0.02–0.03). Arsenic and manganese had relatively stable and lower levels, whereas lead displayed the lowest transfer rates (HRI < 1) remains below the critical threshold, the findings emphasize the importance of moderate consumption and continuous monitoring of crops in polluted areas. The results can contribute to the integration of sustainable development principles into community policy, protecting the environment and ensuring the sustainable health of consumers.
- 30 April 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (9) , 4072
Open AccessStudy on Human Health Risks Associated with Consuming Vegetables Grown in Industrially Polluted Soil in Sasar Area, NW Romania, in the Context of Sustainable Development
This study analyzed the health risks associated with the consumption of certain vegetables (carrot, onion, tomato, and pepper) grown in soils potentially polluted with metals (Cd, Cu, Mn, Ni, Pb, Zn) and metalloids (As) from 15 vegetable gardens in the Sasar locality. The research includes measurement of soil and plant metal concentrations, assessment of global pollution of soils with metals using Nemerow pollution index (PIN), calculation of the metal transfer factor (TF) from soil to vegetable, daily intake of metal dose (DIM) and health risk index (HRI) for both children and adults. The results (mean of 3 replicas ± standard deviation) show that the soil is moderately polluted with lead (28.39 ± 8.623 mg kg−1), nickel (23.17 ± 4.043 mg kg−1), and zinc (123.20 ± 26.918 mg kg−1), strongly polluted with copper (71.68 ± 22.463 mg kg−1), and cadmium (2.63 ± 0.881 mg kg−1). Copper exhibited the highest transfer factors (>0.08), followed by cadmium (~0.06), while zinc and nickel showed moderate values (0.02–0.03). Arsenic and manganese had relatively stable and lower levels, whereas lead displayed the lowest transfer rates (HRI < 1) remains below the critical threshold, the findings emphasize the importance of moderate consumption and continuous monitoring of crops in polluted areas. The results can contribute to the integration of sustainable development principles into community policy, protecting the environment and ensuring the sustainable health of consumers.
- Open Access
- 30 April 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (9) , 7431
Research on the Sustainable Development of the Bistrita Ardeleana River in Order to Stop the Erosion of the Riverbanks and the Thalweg
The impact of dams and reservoirs on the aquatic ecosystem of rivers is a very important topic for water resource management. These hydrotechnical facilities change the natural hydromorphological regime of the rivers. This paper analyzed the hydrodynamic characteristics of an undeveloped riverbed section downstream of the Colibița reservoir, from the Bistrita Ardeleana River hydrographic basin. After processing the data obtained on the field, two hydraulic models were made using the MIKE 11 program, which aimed to identify the hydraulic parameters such as the wet section, the depth, and the water velocity. The first modeling was used for the flow rate of Q = 54.5 m3/s: the water depth was between 1.952 m and 2.559 m; and the water velocity varied between 1.148 m/s and 1.849 m/s. The second modeling was used for a flow rate of Q = 178 m3/s and showed that the water depth had values between 3.701 m and 4.427 m; and the water velocity varied between 1.316 m/s and 2.223 m/s. Following the granulometric analysis, the average diameter of the particle in the thalweg was D50 = 25.18 mm. The conclusion reached as a result of hydraulic modeling and granulometric analyses indicated that hydromorphological processes take place along the length of the analyzed sector, which have negative effects on water quality as well as on the instability of the riverbed. To make the riverbed safe along the entire studied length, we managed to identify some alternative solutions that have the role of stabilizing the banks, respectively, to stop the deepening of the thalweg. The alternative hydrotechnical constructions will increase the roughness of the riverbed, essentially reducing the water speed and increasing the favorable conditions for the retention of alluvium.
- 30 April 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (9) , 7431
Open AccessResearch on the Sustainable Development of the Bistrita Ardeleana River in Order to Stop the Erosion of the Riverbanks and the Thalweg
The impact of dams and reservoirs on the aquatic ecosystem of rivers is a very important topic for water resource management. These hydrotechnical facilities change the natural hydromorphological regime of the rivers. This paper analyzed the hydrodynamic characteristics of an undeveloped riverbed section downstream of the Colibița reservoir, from the Bistrita Ardeleana River hydrographic basin. After processing the data obtained on the field, two hydraulic models were made using the MIKE 11 program, which aimed to identify the hydraulic parameters such as the wet section, the depth, and the water velocity. The first modeling was used for the flow rate of Q = 54.5 m3/s: the water depth was between 1.952 m and 2.559 m; and the water velocity varied between 1.148 m/s and 1.849 m/s. The second modeling was used for a flow rate of Q = 178 m3/s and showed that the water depth had values between 3.701 m and 4.427 m; and the water velocity varied between 1.316 m/s and 2.223 m/s. Following the granulometric analysis, the average diameter of the particle in the thalweg was D50 = 25.18 mm. The conclusion reached as a result of hydraulic modeling and granulometric analyses indicated that hydromorphological processes take place along the length of the analyzed sector, which have negative effects on water quality as well as on the instability of the riverbed. To make the riverbed safe along the entire studied length, we managed to identify some alternative solutions that have the role of stabilizing the banks, respectively, to stop the deepening of the thalweg. The alternative hydrotechnical constructions will increase the roughness of the riverbed, essentially reducing the water speed and increasing the favorable conditions for the retention of alluvium.
- Open Access
Research on the Sustainable Development of the Bistrita Ardeleana River through the Resizing of Weirs
The layout of water resources and the complex and rational use of them have an important role in the socioeconomic activities of an urban settlement. Transversal hydrotechnical constructions such as weirs reduce the longitudinal connectivity of rivers and streams, affecting river biodiversity as well as water quality. This paper presents an alternative method that will help restore connectivity. In order to choose the best solution, topographical measurements were taken with a total topographical station, and a professional drone was used to obtain an updated orthophoto plan. After processing the data obtained in the field, engineering software capable of simulating flow, sediment transport, and water quality in rivers was used. With the help of the software, two hypotheses were realized: hypothesis A, the case with only one weir in place, and hypothesis B, when we have the proposed case with the lowering of the height of the weir’s crest and the construction of three new control weirs downstream of it. In conclusion, the lowering of the current weir’s crest and the construction downstream of it of three new weirs of low height would have a favorable effect from an ecological and a morphological point of view, without very big consequences on the disturbance of the flow from a hydraulic point of view.
Open AccessResearch on the Sustainable Development of the Bistrita Ardeleana River through the Resizing of Weirs
The layout of water resources and the complex and rational use of them have an important role in the socioeconomic activities of an urban settlement. Transversal hydrotechnical constructions such as weirs reduce the longitudinal connectivity of rivers and streams, affecting river biodiversity as well as water quality. This paper presents an alternative method that will help restore connectivity. In order to choose the best solution, topographical measurements were taken with a total topographical station, and a professional drone was used to obtain an updated orthophoto plan. After processing the data obtained in the field, engineering software capable of simulating flow, sediment transport, and water quality in rivers was used. With the help of the software, two hypotheses were realized: hypothesis A, the case with only one weir in place, and hypothesis B, when we have the proposed case with the lowering of the height of the weir’s crest and the construction of three new control weirs downstream of it. In conclusion, the lowering of the current weir’s crest and the construction downstream of it of three new weirs of low height would have a favorable effect from an ecological and a morphological point of view, without very big consequences on the disturbance of the flow from a hydraulic point of view.