Yushi Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yushi Yang has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Yue Zhao
University of Arkansas
2 shared publications - Ahmad Al-Hmoud
Department of Energy Engineering, German Jordanian University, Amman 11180, Jordan
1 shared publication - Brij N. Singh
John Deere
1 shared publication - Dongyu Jin
John Deere
1 shared publication - Junpeng Ma
Sichuan University
1 shared publication Long Wu
John Deere
1 shared publication
Latest Publications
- 1 December 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (12) , 21064-21079
Robust Soft-Switching Inverter Design for Electric Motors With Significant Parasitic Capacitances
- 1 December 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (12) , 21064-21079
Robust Soft-Switching Inverter Design for Electric Motors With Significant Parasitic Capacitances
- 13 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (1) , 74-78
A Novel Continuously Variable Gate Voltage Control Concept for Silicon Carbide Power Modules
This letter presents a novel gate driver concept that utilizes high-frequency (HF), up to 60 MHz, modulated signals to enable continuous variation of gate voltage to achieve highly flexible driving profiles and optimize the performance of silicon carbide (SiC) power modules. This continuously variable gate driver (CVGD) concept is unique from existing solutions in relying on the HF driving signal and the intrinsic parasitics of the module, rather than relying on additional hardware circuitry and dc–dc converters. The proposed CVGD concept can precisely control all regions over a switching cycle while using a topology and part count similar to those of a conventional gate driver. The CVGD is prototyped and validated using the latest 3.3 kV SiC power modules for three potential use cases, including slew rate control, software-based gate resistance variation, and current balancing for paralleled modules.
- 13 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (1) , 74-78
A Novel Continuously Variable Gate Voltage Control Concept for Silicon Carbide Power Modules
This letter presents a novel gate driver concept that utilizes high-frequency (HF), up to 60 MHz, modulated signals to enable continuous variation of gate voltage to achieve highly flexible driving profiles and optimize the performance of silicon carbide (SiC) power modules. This continuously variable gate driver (CVGD) concept is unique from existing solutions in relying on the HF driving signal and the intrinsic parasitics of the module, rather than relying on additional hardware circuitry and dc–dc converters. The proposed CVGD concept can precisely control all regions over a switching cycle while using a topology and part count similar to those of a conventional gate driver. The CVGD is prototyped and validated using the latest 3.3 kV SiC power modules for three potential use cases, including slew rate control, software-based gate resistance variation, and current balancing for paralleled modules.
- 18 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (1) , 7-11
DC-Link Voltages Digital Sampling for Cascaded H-Bridge Rectifiers With Single Voltage Sensor Under Loads Unbalanced Condition
Direct current (dc) voltage sensor in each cell of the cascaded H-bridge rectifier (CHBR) is traditionally indispensable for capacitor voltage balancing control. The cost of dc sensors will increase with the number of cells. This letter proposes a strategy for dc-voltage digital sampling based on sliding window recursive least square (RLS), which employs only one voltage sensor. Sliding window RLS is used to decouple voltage information within one sampling interval. For the actual situation where the modulation waves of cells are different, this method owns faster updating rate and higher detection precision compared to the existing multisampling method. A downscale test platform of the single-phase CHBR is built to verify the correctness and effectiveness of the proposed method. The result shows that better current quality and steadier dc voltage are achieved.
- 18 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 38 (1) , 7-11
DC-Link Voltages Digital Sampling for Cascaded H-Bridge Rectifiers With Single Voltage Sensor Under Loads Unbalanced Condition
Direct current (dc) voltage sensor in each cell of the cascaded H-bridge rectifier (CHBR) is traditionally indispensable for capacitor voltage balancing control. The cost of dc sensors will increase with the number of cells. This letter proposes a strategy for dc-voltage digital sampling based on sliding window recursive least square (RLS), which employs only one voltage sensor. Sliding window RLS is used to decouple voltage information within one sampling interval. For the actual situation where the modulation waves of cells are different, this method owns faster updating rate and higher detection precision compared to the existing multisampling method. A downscale test platform of the single-phase CHBR is built to verify the correctness and effectiveness of the proposed method. The result shows that better current quality and steadier dc voltage are achieved.