Erfansyah Ali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Erfansyah Ali has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Aloysius Adya Pramudita
Telkom University
5 shared publications - Sung-Nien Hsieh
National Taiwan University of Science and Technology, Taipei, Taiwan
3 shared publications Ding-Bing Lin
2 shared publications- Ding-Bing Lin
Department of Electronic and Computer Engineering National Taiwan University of Science and Technology, Taipei 10607, Taiwan
2 shared publications - Tjahjo Adiprabowo
School of Electrical Engineering, Telkom University, Bandung 40257, Indonesia
2 shared publications - Ariana Tulus Purnomo
Computer Science Study Program, Faculty of Engineering and Technology, Sampoerna University, Jakarta Selatan, Indonesia
1 shared publication
Latest Publications
- Open Access
- 10 July 2026
- Published by Elsevier in e-Prime – Nexus of Electrical, Electronic, and Intelligent Engineering
- Vol. 17
Wearable Antenna-Based Software-Defined Radio System for Human Respiratory Sensor
- 10 July 2026
- Published by Elsevier in e-Prime – Nexus of Electrical, Electronic, and Intelligent Engineering
- Vol. 17
Open AccessWearable Antenna-Based Software-Defined Radio System for Human Respiratory Sensor
- Open Access
- 27 March 2026
- Published by Elsevier in SSRN Electronic Journal
Small Displacement Sensor for Bridge Structure using UWB Textile Antenna
Small displacement on a millimetre scale becomes a vital observation object in several fields, thus motivating the development of relevant sensor concepts for detecting small displacements. An antenna-as-a-sensor offers opportunities to integrate sensing and communication. The small displacement level is used as indicator in estimating the structure health. The need appeared in monitoring the bridge or large civil structure condition. Proposed sensor system consists of two textile ultrawideband antenna that connect to S21 measurement devices and time domain processing unit. Small-displacement monitoring on a bridge structure model is used as a case study in the experiment. The textile UWB antenna is fabricated on a flexible denim substrate, allows surface adaptive placement and stable performance under mechanical deformation. The changes in the transfer function between two antennas in response to the small displacement that occurs were studied. The experimental results show a clear linear correlation between structural displacement and the time-delay shift of the reconstructed main pulse peak. The proposed UWB textile antenna achieves a 1 mm resolution in detecting small structural displacements.
- 27 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSmall Displacement Sensor for Bridge Structure using UWB Textile Antenna
Small displacement on a millimetre scale becomes a vital observation object in several fields, thus motivating the development of relevant sensor concepts for detecting small displacements. An antenna-as-a-sensor offers opportunities to integrate sensing and communication. The small displacement level is used as indicator in estimating the structure health. The need appeared in monitoring the bridge or large civil structure condition. Proposed sensor system consists of two textile ultrawideband antenna that connect to S21 measurement devices and time domain processing unit. Small-displacement monitoring on a bridge structure model is used as a case study in the experiment. The textile UWB antenna is fabricated on a flexible denim substrate, allows surface adaptive placement and stable performance under mechanical deformation. The changes in the transfer function between two antennas in response to the small displacement that occurs were studied. The experimental results show a clear linear correlation between structural displacement and the time-delay shift of the reconstructed main pulse peak. The proposed UWB textile antenna achieves a 1 mm resolution in detecting small structural displacements.
- 6 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 72 (00189456) , 1-14
FMCW Radar for Noncontact Bridge Structure Displacement Estimation
The displacement on the bridge structure is an essential parameter in identifying the bridge structure’s health. The non-contact measurement method is preferable in practice, and the radar system is potentially employed for developing displacement measurement technology. Frequency Modulated Continuous Wave (FMCW) radar has a feature for detecting the target location. However, estimating the small displacement in the bridge structure requires extensive bandwidth to reach the proper resolution. The problem of obtaining the required resolution, and adopting the decrease in accuracy due to several possible radar placements during measurement are addressed in this paper. The concept of bridge displacement measurement using a modified FMCW radar system is proposed. Phase information extraction is employed to reach the displacement detection resolution, and the radar elevation detection based on an inclinometer is equipped in the proposed radar system. The simulation and laboratory experiments were conducted by implementing the proposed radar system for detecting the displacement in the bridge model. The experiment results confirm that the proposed FMCW radar was able to estimate the bridge displacement and overcome the decreasing accuracy due to the radar elevation. The multi-point detection technique is also developed in the proposed radar and capable to capture the displacement profile over bridge span. The proposed FMCW system is then recommended as a radar system in developing a non-contact method for bridge displacement measurement and monitoring.
- 6 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 72 (00189456) , 1-14
FMCW Radar for Noncontact Bridge Structure Displacement Estimation
The displacement on the bridge structure is an essential parameter in identifying the bridge structure’s health. The non-contact measurement method is preferable in practice, and the radar system is potentially employed for developing displacement measurement technology. Frequency Modulated Continuous Wave (FMCW) radar has a feature for detecting the target location. However, estimating the small displacement in the bridge structure requires extensive bandwidth to reach the proper resolution. The problem of obtaining the required resolution, and adopting the decrease in accuracy due to several possible radar placements during measurement are addressed in this paper. The concept of bridge displacement measurement using a modified FMCW radar system is proposed. Phase information extraction is employed to reach the displacement detection resolution, and the radar elevation detection based on an inclinometer is equipped in the proposed radar system. The simulation and laboratory experiments were conducted by implementing the proposed radar system for detecting the displacement in the bridge model. The experiment results confirm that the proposed FMCW radar was able to estimate the bridge displacement and overcome the decreasing accuracy due to the radar elevation. The multi-point detection technique is also developed in the proposed radar and capable to capture the displacement profile over bridge span. The proposed FMCW system is then recommended as a radar system in developing a non-contact method for bridge displacement measurement and monitoring.
- 11 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (15) , 14670-14685
Radar System for Detecting Respiration Vital Sign of Live Victim Behind the Wall
The presence of an obstacle in detecting respiration vital signs using a radar system does not only exhibit attenuation and phase shift effects on the radar signal but also causes additional beat frequencies to appear beside those from the target. When a conventional FMCW radar system detects the peak of the received signal spectrum as a beat frequency, this will give an error of detection. The respiratory vital signs will then be undetectable. A method to overcome this obstacle problem is needed. Therefore the implementation of the FMCW radar system in detecting respiratory vital signs behind the wall can be realized. In this paper, a method to deal with the previously mentioned problem is proposed. The proposed method consists of a method for identifying the obstacle response. Then the results are used to eliminate the beat frequency that arises from the obstacle structure, and therefore the signal to clutter ratio (SCR) can be improved. Furthermore, the method is combined with the phase detection method, which is applied to extract the Doppler response related to the target respiratory vital signs. The weighting process by elaborating cross correlation is also employed for minimizing clutter from other objects reflection under debris. A laboratory experiment by developing an FMCW radar system with a 24 GHz frequency operation was performed in this research. The proposed detection method was elaborated in the post-processing of the radar system. The experiment result demonstrates that the proposed method is capable of eliminating the effect of the wall and successfully extracting the respiration vital sign pattern.
- 11 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (15) , 14670-14685
Radar System for Detecting Respiration Vital Sign of Live Victim Behind the Wall
The presence of an obstacle in detecting respiration vital signs using a radar system does not only exhibit attenuation and phase shift effects on the radar signal but also causes additional beat frequencies to appear beside those from the target. When a conventional FMCW radar system detects the peak of the received signal spectrum as a beat frequency, this will give an error of detection. The respiratory vital signs will then be undetectable. A method to overcome this obstacle problem is needed. Therefore the implementation of the FMCW radar system in detecting respiratory vital signs behind the wall can be realized. In this paper, a method to deal with the previously mentioned problem is proposed. The proposed method consists of a method for identifying the obstacle response. Then the results are used to eliminate the beat frequency that arises from the obstacle structure, and therefore the signal to clutter ratio (SCR) can be improved. Furthermore, the method is combined with the phase detection method, which is applied to extract the Doppler response related to the target respiratory vital signs. The weighting process by elaborating cross correlation is also employed for minimizing clutter from other objects reflection under debris. A laboratory experiment by developing an FMCW radar system with a 24 GHz frequency operation was performed in this research. The proposed detection method was elaborated in the post-processing of the radar system. The experiment result demonstrates that the proposed method is capable of eliminating the effect of the wall and successfully extracting the respiration vital sign pattern.
- Open Access
- 1 April 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1195 (1) , 012017
Small displacement detecting method based on multifrequency continuous wave radar system
A small displacement becomes important indicator in identifying a problem that may rises in several systems. Non-Contacting sensor is needed for small displacement detection in several field such as structure health monitoring, landslide monitoring and human vital sign detection. Radar system is potentially implemented as non-contacting sensor for previous mention problems. Detection of small displacement on a target using a radar system requires high accuracy and resolution which gives the consequence of a wide bandwidth requirement. The method of multi-frequency continuous wave radar is then investigated and proposed as a method for detection of small displacement with low bandwidth requirements. Cross correlation and IQ demodulation techniques are applied in post processing. Theoretical analysis and simulation were conducted to study the concept of the proposed method. The results show that the proposed method can determine the location and magnitude of small displacement.
- 1 April 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1195 (1) , 012017
Open AccessSmall displacement detecting method based on multifrequency continuous wave radar system
A small displacement becomes important indicator in identifying a problem that may rises in several systems. Non-Contacting sensor is needed for small displacement detection in several field such as structure health monitoring, landslide monitoring and human vital sign detection. Radar system is potentially implemented as non-contacting sensor for previous mention problems. Detection of small displacement on a target using a radar system requires high accuracy and resolution which gives the consequence of a wide bandwidth requirement. The method of multi-frequency continuous wave radar is then investigated and proposed as a method for detection of small displacement with low bandwidth requirements. Cross correlation and IQ demodulation techniques are applied in post processing. Theoretical analysis and simulation were conducted to study the concept of the proposed method. The results show that the proposed method can determine the location and magnitude of small displacement.