Zhujun Feng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Zhujun Feng has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Xiuli Wang
Lanzhou Univ. of Technology
2 shared publications- Ewelina Biskup
Shanghai University of Medicine and Health Sciences, Shanghai, China
1 shared publication - Heng Xu
Department of Plastic and Reconstructive Surgery, Ninth People’s Hospital, Shanghai Jiao Tong University School of Medicine, Shanghai 200011, China
1 shared publication - Jian Zhang
Department of Orthopaedics, Zhongshan Hospital of Fudan University, 180 Fenglin Road, Shanghai, China.
1 shared publication - Jun Chen
School of Chemistry and Chemical Engineering, Chongqing University of Science and Technology, Chongqing, 401331, China
1 shared publication - Kan Wang
School of Automation and Intelligent Sensing, Shanghai Jiao Tong University, Shanghai, China
1 shared publication
Latest Publications
- 1 January 2027
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 153 (1) , 04026214
Displacement Distribution of Prestressed Square Concrete-Filled Steel Tubular Cantilever Columns under Lateral Impact at Any Point
Prestressed concrete-filled steel tubular (CFST) cantilever columns can delay cracking in steel tubes and enhance their impact resistance. However, existing theoretical models lack the capability to efficiently and analytically predict the displacement distribution along the column height under arbitrary impact locations. This paper conducts theoretical analysis based on d’Alembert’s principle, considering the influence of inertial forces, to derive the displacement distribution of prestressed CFST cantilever columns under lateral impact loads. The theoretical derivation divides the deformation of the cantilever column after impact loading into four stages: the first two stages represent the short-term effects of the member; while the latter two stages represent its long-term effects. The deformation caused by long-term effects is significantly greater than that induced by short-term effects. Comparisons between the theoretically derived values and experimental/simulation results show that the theoretical values can effectively predict the deformation of the member at each stage. However, when the impact height is relatively low or the impact mass is large, the long-term effects significantly exceed the experimental and theoretical values, resulting in conservative (safer) predictions. Additionally, the theoretical calculation formulas qualitatively indicate that the final lateral displacement of the prestressed member is smaller.
- 1 January 2027
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 153 (1) , 04026214
Displacement Distribution of Prestressed Square Concrete-Filled Steel Tubular Cantilever Columns under Lateral Impact at Any Point
Prestressed concrete-filled steel tubular (CFST) cantilever columns can delay cracking in steel tubes and enhance their impact resistance. However, existing theoretical models lack the capability to efficiently and analytically predict the displacement distribution along the column height under arbitrary impact locations. This paper conducts theoretical analysis based on d’Alembert’s principle, considering the influence of inertial forces, to derive the displacement distribution of prestressed CFST cantilever columns under lateral impact loads. The theoretical derivation divides the deformation of the cantilever column after impact loading into four stages: the first two stages represent the short-term effects of the member; while the latter two stages represent its long-term effects. The deformation caused by long-term effects is significantly greater than that induced by short-term effects. Comparisons between the theoretically derived values and experimental/simulation results show that the theoretical values can effectively predict the deformation of the member at each stage. However, when the impact height is relatively low or the impact mass is large, the long-term effects significantly exceed the experimental and theoretical values, resulting in conservative (safer) predictions. Additionally, the theoretical calculation formulas qualitatively indicate that the final lateral displacement of the prestressed member is smaller.
- 4 August 2026
- Published by Elsevier in Thin-Walled Structures
- Vol. 231
Damage-based design approach for cable net–concrete filled steel tubular flexible barriers
- 4 August 2026
- Published by Elsevier in Thin-Walled Structures
- Vol. 231
Damage-based design approach for cable net–concrete filled steel tubular flexible barriers
- 26 October 2022
- Published by Springer Nature in Journal of Mountain Science
- Vol. 19 (10) , 2920-2934
Dynamic impact of boulders on different types of concrete dam
- 26 October 2022
- Published by Springer Nature in Journal of Mountain Science
- Vol. 19 (10) , 2920-2934
Dynamic impact of boulders on different types of concrete dam
- Open Access
- 19 May 2021
- Published by Springer Nature in Nano Research
- Vol. 14 (12) , 4901-4902
Erratum to: In vivo and in situ real-time fluorescence imaging of peripheral nerves in the NIR-II window
- 19 May 2021
- Published by Springer Nature in Nano Research
- Vol. 14 (12) , 4901-4902
Open AccessErratum to: In vivo and in situ real-time fluorescence imaging of peripheral nerves in the NIR-II window